HT-0066

HT-0066 Datasheet

FCI Tool P/N HT-0066

Part	Datasheet
HT-0066	HT-0066 (pdf)

PDF Datasheet Preview
Hand Tool 0066 Mini PVC Terminal 22 AWG Operation and Service Manual FCI Tool P/N HT-0066 FCI MANUAL P/N 166813 STATUS Released Printed May 10, TABLE OF CONTENTS OPERATION Crimping Parts Parts REFERENCE DOCUMENTS FORM # E-3246- - Hand Tool Warranty FORM # E-3247- - FCI Electronics Address List STATUS Released Printed May 10, Operation Crimping Instructions To Load Terminal: Press terminal holder as shown in Figure Insert terminal with “U” shaped barrels up, onto terminal holder pin until terminal is against pin shoulder. When using wire with regular insulation, place terminal in side marked “A”. When using wire with coax insulation, place terminal in side marked “B”. Release terminal holder: Hold terminal against pin shoulder while releasing holder to insure terminal remains in proper position while moving over anvil. To Load Wire: Place wire, stripped to proper length, into barrel of terminal Wire tonker can be used for wire stop by placing stripped end of insulation against tonker. Crimp by holding wire and closing hand tool. NOTE To eliminate a sticking problem, the top dies should be cleared of gold build-up at approximately 125 crimps Figure 1 STATUS Released Printed May 10, Figure 2 Figure 3 STATUS Released Printed May 10, Parts List Detail No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 HT-0066 Mini PVC Terminal Wire Size 22 26 Crimper Holder 155089-001 Insulation Crimper B117021-1 Wire Barrel Crimper 102605-1 Anvil Holder 102466-1 Insulation Anvil A117022-1

PDF Datasheet Preview

Hand Tool 0066 Mini PVC Terminal 22 AWG

Operation and Service Manual

FCI Tool P/N HT-0066

FCI MANUAL P/N 166813

STATUS Released Printed May 10,

TABLE OF CONTENTS

OPERATION Crimping Parts

Parts

REFERENCE DOCUMENTS

FORM # E-3246- - Hand Tool Warranty FORM # E-3247- - FCI Electronics Address List

STATUS Released Printed May 10,

Operation

Crimping Instructions

To Load Terminal:

Press terminal holder as shown in Figure Insert terminal with “U” shaped barrels up, onto terminal holder pin until terminal is against pin
shoulder. When using wire with regular insulation, place terminal in side marked “A”. When using wire with coax insulation, place terminal in side marked “B”. Release terminal holder:

Hold terminal against pin shoulder while releasing holder to insure terminal remains in proper position while moving over anvil.

To Load Wire:

Place wire, stripped to proper length, into barrel of terminal Wire tonker can be used for wire stop by placing stripped end of insulation against tonker.

Crimp by holding wire and closing hand tool.

NOTE To eliminate a sticking problem, the top dies should be cleared of gold build-up at approximately 125 crimps

Figure 1

STATUS Released Printed May 10,

Figure 2

Figure 3

STATUS Released Printed May 10,

Parts List

Detail No.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

HT-0066 Mini PVC Terminal

Wire Size 22 26

Crimper Holder
155089-001

Insulation Crimper

B117021-1

Wire Barrel Crimper
102605-1

Anvil Holder
102466-1

Insulation Anvil

A117022-1

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived HT-0066 Datasheet file may be downloaded here without warranties.

Datasheet ID: HT-0066 635119