MA750GQ-P

MA750GQ-P Datasheet

MagAlpha MA750

Part	Datasheet
MA750GQ-P	MA750GQ-P (pdf)

Related Parts	Information
MA750GQ-Z	MA750GQ-Z
EVMA750-Q-00A	EVMA750-Q-00A

PDF Datasheet Preview
MagAlpha MA750 Contactless Turning Knob Sensor Key features 8 bit digital and 12 bit PWM output 500 kHz refresh rate mA supply current Serial interface for data readout and settings The MagAlpha MA750 is a robust contactless angle encoder suitable for control buttons and knobs. The IC detects the absolute angular position of a permanent magnet, typically a diametrically magnetized cylinder attached to the rotor. QFN16 3x3mm Package The output is digital SPI or PWM. For usual potentiometer replacement, the PWM signal can be filtered to obtain an analog signal. Figure 1 Functional Block Diagram Monolithic Power Systems, Inc. \| Gland, Switzerland \| Tel +41 22 364 63 50 \| \| MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited. 2014 Monolithic Power Systems. All Rights MA750 Contactless Turning Knob Sensor Specifications TABLE 1 OPERATING CONDITIONS Parameters Supply voltage Supply current Supply voltage for OTP flashing Supply current for OTP flashing 1 Operating temperature Applied magnetic field Isup Vflash Iflash 1 See section 11 for more details about the supply circuit for OTP flashing. TABLE 2 SENSOR OUTPUT SPECIFICATIONS Measurement conditions VDD = V, 50 mT < B < 100 mT, Temp = -40 +125°C, unless otherwise noted Parameters Max Unit Remark Power up time +/- +/- deg Output drift Temperature induced Magnetic field induced Voltage supply induced deg/°C deg/mT deg/mV Absolute output - serial Data output length 16 bit Refresh rate 550 kHz Latency Resolution noise level Absolute output - PWM Resolution noise level 12 bit Digital I/O Threshold voltage High Threshold voltage Low Rising edge slew rate Falling edge slew rate V/ns CL = 50 pF Ordering Information Package Free Air Temperature TA MA750GQ QFN 3x3mm -40° to 125° * For Tape & Reel, add suffix e.g. Appendix A Definitions Resolution noise level Refresh rate The smallest angle increment distinguishable from the noise. Here the resolution is defined as 3 times , the standard deviation in degrees, taken over 1000 data points at a constant position. The resolution in bits is obtained with: Rate at which new data points are stored in the output buffer. Latency The time between the data ready at the output and the instant at which the shaft passes that position. The lag in degrees is , where is the angular velocity in deg/s. Power up time Starting at power up, time until the sensor delivers valid data. Integral Non-Linearity INL Maximum deviation between the sensor output and the best line fit. Monolithic Power Systems, Inc. \| Gland, Switzerland \| Tel +41 22 364 63 50 \| \| MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited. 2014 Monolithic Power Systems. All Rights MA750 Contactless Turning Knob Sensor Jitter sensor out deg 400 350 300 250 200 150 100 ideal sensor output resolution ± 3 100 200 300 400 500 rotor position deg sensor out best straight fit 600 700 Figure A1 Absolute Angle Errors For the incremental output maximum fluctuation of the angular position of the raising edges. Overall reproducibility Maximum variation between two readings, successive or not, of the same shaft position at a fixed magnetic field over the complete temperature range. Monolithic Power Systems, Inc. Switzerland  +41 22 364 63 50 The information provided by Monolithic Power Systems, Inc. in this document is believed to be correct. However MPS reserves the right, without further notice, i to change the product specification and/or the information in this document and ii to improve reliability, functions and design of the product and iii to discontinue or limit production or distribution of any product version. Monolithic Power Systems, Inc. does not assume any liability arising out of any application or use of any product or information, including without limitation consequential or incidental damages. All operating parameters must be validated for each customer's application by customer's technical experts. Recommended parameters can and do vary in different applications. Devices sold by MPS are covered by patents and patent applications. By this publication MPS does not assume responsibility for patent infringements or other rights of third parties which may result from its use.

PDF Datasheet Preview

MagAlpha MA750

Contactless Turning Knob Sensor

Key features
8 bit digital and 12 bit PWM output 500 kHz refresh rate mA supply current Serial interface for data readout and settings

The MagAlpha MA750 is a robust contactless angle encoder suitable for control buttons and knobs. The IC detects the absolute angular position of a permanent magnet, typically a diametrically magnetized cylinder attached to the rotor.

QFN16 3x3mm Package

The output is digital SPI or PWM. For usual potentiometer replacement, the PWM signal can be filtered to obtain an analog signal.

Figure 1 Functional Block Diagram

Monolithic Power Systems, Inc. | Gland, Switzerland | Tel +41 22 364 63 50 | |

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited. 2014 Monolithic Power Systems. All Rights

MA750

Contactless Turning Knob Sensor

Specifications

TABLE 1 OPERATING CONDITIONS

Parameters Supply voltage Supply current Supply voltage for OTP flashing Supply current for OTP flashing 1 Operating temperature Applied magnetic field

Isup

Vflash

Iflash
1 See section 11 for more details about the supply circuit for OTP flashing.

TABLE 2 SENSOR OUTPUT SPECIFICATIONS

Measurement conditions VDD = V, 50 mT < B < 100 mT, Temp = -40 +125°C, unless otherwise noted

Parameters

Max Unit

Remark

Power up time
+/- +/- deg

Output drift Temperature induced Magnetic field induced Voltage supply induced
deg/°C deg/mT deg/mV

Absolute output - serial

Data output length
16 bit

Refresh rate
550 kHz

Latency

Resolution noise level

Absolute output - PWM

Resolution noise level
12 bit

Digital I/O Threshold voltage High Threshold voltage Low Rising edge slew rate Falling edge slew rate

V/ns

CL = 50 pF
Ordering Information

Package

Free Air Temperature TA

MA750GQ

QFN 3x3mm
-40° to 125°
* For Tape & Reel, add suffix e.g.

Appendix A Definitions

Resolution noise level Refresh rate

The smallest angle increment distinguishable from the noise. Here the resolution is defined as 3 times , the standard deviation in degrees, taken over 1000 data points at a constant position. The resolution in bits is obtained with:

Rate at which new data points are stored in the output buffer.

Latency

The time between the data ready at the output and the instant at which the shaft
passes that position. The lag in degrees is
, where is the
angular velocity in deg/s.

Power up time

Starting at power up, time until the sensor delivers valid data.

Integral Non-Linearity INL

Maximum deviation between the sensor output and the best line fit.

Monolithic Power Systems, Inc. | Gland, Switzerland | Tel +41 22 364 63 50 | |

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited. 2014 Monolithic Power Systems. All Rights

MA750

Contactless Turning Knob Sensor

Jitter
sensor out deg
400 350 300 250 200 150 100
ideal sensor output
resolution ± 3
100 200 300 400 500 rotor position deg
sensor out best straight fit
600 700

Figure A1 Absolute Angle Errors

For the incremental output maximum fluctuation of the angular position of the raising edges.

Overall reproducibility

Maximum variation between two readings, successive or not, of the same shaft position at a fixed magnetic field over the complete temperature range.

Monolithic Power Systems, Inc. Switzerland
 +41 22 364 63 50

The information provided by Monolithic Power Systems, Inc. in this document is believed to be correct. However MPS reserves the right, without further notice, i to change the product specification and/or the information in this document and ii to improve reliability, functions and design of the product and iii to discontinue or limit production or distribution of any product version.

Monolithic Power Systems, Inc. does not assume any liability arising out of any application or use of any product or information, including without limitation consequential or incidental damages. All operating parameters must be validated for each customer's application by customer's technical experts. Recommended parameters can and do vary in different applications.

Devices sold by MPS are covered by patents and patent applications. By this publication MPS does not assume responsibility for patent infringements or other rights of third parties which may result from its use.

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived MA750GQ-P Datasheet file may be downloaded here without warranties.

Datasheet ID: MA750GQ-P 649996