ATAM862P-TNSY8D

ATAM862P-TNSY8D Datasheet


The ATAM862-8 is a single package dual-chip circuit. It combines a UHF ASK/FSK transmitter with a 4-bit microcontroller. It supports highly integrated solutions in car access and tire pressure monitoring applications, as well as manifold applications in the industrial and consumer segment. It is available for the transmitting frequency range of 868 MHz to 928 MHz with data rates up to 32 kbaud Manchester coded.

Part Datasheet
ATAM862P-TNSY8D ATAM862P-TNSY8D ATAM862P-TNSY8D (pdf)
Related Parts Information
ATAM862P-TNQY8D ATAM862P-TNQY8D ATAM862P-TNQY8D
PDF Datasheet Preview
• Single Package Fully-integrated 4-bit Microcontroller with RF Transmitter
• Low Power Consumption in Sleep Mode < 1 µA Typically
• Flash Controller for Application Program Available
• Maximum Output Power with Low Supply Current
• 2.0V to 4.0V Operation Voltage for Single Li-cell Power Supply
• to +125°C Operation Temperature
• SSO24 Package
• About Seven External Components

The ATAM862-8 is a single package dual-chip circuit. It combines a UHF ASK/FSK transmitter with a 4-bit microcontroller. It supports highly integrated solutions in car access and tire pressure monitoring applications, as well as manifold applications in the industrial and consumer segment. It is available for the transmitting frequency range of 868 MHz to 928 MHz with data rates up to 32 kbaud Manchester coded.

For further frequency ranges 310 MHz to 330 MHz and 429 MHz to 439 MHz separate datasheets are available.

The device contains a flash microcontroller.

Figure Application Diagram ATAM862

Micro-

PLL-
controller

Transmitter

Keys

Antenna

UHF ASK/FSK Receiver

Microcontroller

Microcontroller with UHF ASK/FSK Transmitter

ATAM862-8

Pin Configuration

Figure Pinning SSO24

XTAL 1 VS 2

GND 3 ENABLE 4 NRESET 5 BP63/T3I 6 BP20/NTE 7

BP23 8 BP41/T2I/VMI 9

BP42/T2O 10 BP43/SD/INT3 11

VSS 12
24 ANT1 23 ANT2 22 PA_ENABLE 21 CLK 20 BP60/T3O 19 OSC2 18 OSC1 17 BP50/INT6 16 BP52/INT1 15 BP53/INT1 14 BP40/SC/INT3 13 VDD

Table Pin Description RF Part

Symbol Function

XTAL

Connection for crystal

Supply voltage

Ground

ENABLE input

Configuration

VS 1.5k

VS 1.2k

XTAL
182 µA

ESD protection circuitry see Figure 7-5 on page 11 ESD protection circuitry see Figure 7-5 on page 11

ENABLE
200k
2 ATAM862-8

Table Pin Description RF Part Continued

Symbol Function
Ordering Information

Extended Type Number 1

Program Memory

ATAM862x-TNQYzf
4 kB Flash

ATAM862x-TNSYzf
4 kB Flash

Note:

J -40° C to +125° C + lead free = RF frequency range = 8 868 MHz/915 MHz

Package Information

Data-EEPROM 2 x 512 bit 2 x 512 bit

Package SSO24

Delivery Taped and reeled Tubes

Drawing-No. Issue 1;

Package SSO24 Dimensions in mm
technical drawings according to DIN specifications

History
4590G-4BMCU-04/07
• Put datasheet in new template
• Features on page 1 Maximum output power value and the low current
value are changed
4590F-4BMCU-12/05
• Put datasheet in new template
• Page 30 Section “32-kHz Oscillator” changed
• Page 105 Ordering Information changed
4590E-4BMCU-09/04
• Abs. Max. Ratings table page 11 row “Input voltage” changed
• Abs. Max. Ratings table page 11 table note 1 changed
• El. Char. table page 12 row “PA_ENABLE input“ changed
• El. Char. table page 12 table note 1 changed
106 ATAM862-8

ATAM862-8

Table of Contents
1 Description 1 2 Pin Configuration 2 3 UHF ASK/FSK Transmitter Block 4 Features 4 5 Description 4 6 General Description 6 7 Functional Description 6

ASK Transmission FSK Transmission CLK Output Application Circuit
8 Absolute Maximum Ratings RF Part 11 9 Thermal Resistance 11 10 Electrical Characteristics 11 Microcontroller Block 13 12 Features 13 Description 13 14 Introduction 13

Differences between ATAM862-8 and ATAR862 Microconrtollers
15 MARC4 Architecture General Description 15 16 Components of Microcontroller Core 15 17 Program Memory 16

RAM Registers ALU I/O Bus Instruction Set Interrupt Structure Software Interrupts

Hardware Interrupts
18 Master Reset 23

Power-on Reset and Brown-out Detection
19 Voltage Monitor 24
20 Clock Generation 26

Clock Module Oscillator Circuits and External Clock Input Stage Clock Management
21 Power-down Modes 31
22 Peripheral Modules 32

Addressing Peripherals
23 Bi-directional Ports 35

Bi-directional Port 1 Bi-directional Port 2 Bi-directional Port 5 Bi-directional Port 4 Bi-directional Port 6 Universal Timer/Counter/ Communication Module UTCM Timer 1 Timer 2 Timer 2 Modes Timer 2 Output Modes Timer 2 Output Signals Timer 2 Registers
24 Timer 3 58

Features Timer/Counter Modes Timer 3 Modulator/Demodulator Modes Timer 3 Modulator for Carrier Frequency Burst Modulation Timer 3 Demodulator for Biphase, Manchester and Pulse-width-modulated

Signals Timer 3 Registers Timer 3 Capture Register Synchronous Serial Interface SSI
108 ATAM862-8

ATAM862-8

Serial Interface Registers
25 Combination Modes 83

Combination Mode Timer 2 and SSI Combination Mode Timer 3 and SSI Combination Mode Timer 2 and Timer 3 Combination Mode Timer 2, Timer 3 and SSI Data EEPROM Serial Interface EEPROM Initialization the Serial Interface to the EEPROM
Headquarters

Atmel Corporation 2325 Orchard Parkway San Jose, CA 95131 USA Tel 1 408 441-0311 Fax 1 408 487-2600

International

Atmel Asia Room 1219 Chinachem Golden Plaza 77 Mody Road Tsimshatsui East Kowloon Hong Kong Tel 852 2721-9778 Fax 852 2722-1369

Atmel Europe Le Krebs 8, Rue Jean-Pierre Timbaud BP 309 78054 Saint-Quentin-en-Yvelines Cedex France Tel 33 1-30-60-70-00 Fax 33 1-30-60-71-11

Atmel Japan 9F, Tonetsu Shinkawa Bldg. 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan Tel 81 3-3523-3551 Fax 81 3-3523-7581

Product Contact

Web Site

Literature Requests

Technical Support

Sales Contact

Disclaimer The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Unless specifically provided otherwise, Atmel products are not suitable for, and shall not be used in, automotive applications. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life.
2007 Atmel Corporation. All rights reserved. logo and combinations thereof, and others are registered trademarks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others.
More datasheets: HDC-S416-42S1-TG30 | CY62256VNLL-70SNXC | CY62256VNLL-70SNXCT | CY62256VNLL-70ZXAT | CY62256VNLL-70ZRXE | CY62256VNLL-70ZRXET | CY62256VNLL-70ZXA | AOZ1031AI_2 | 19032704A | AO4448L


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived ATAM862P-TNSY8D Datasheet file may be downloaded here without warranties.

Datasheet ID: ATAM862P-TNSY8D 519241