AT17F16-30JC

AT17F16-30JC Datasheet


AT17F16

Part Datasheet
AT17F16-30JC AT17F16-30JC AT17F16-30JC (pdf)
Related Parts Information
AT17F16-30JI AT17F16-30JI AT17F16-30JI
AT17F16-30CU AT17F16-30CU AT17F16-30CU
AT17F16-30JU AT17F16-30JU AT17F16-30JU
AT17F16-30TQC AT17F16-30TQC AT17F16-30TQC
AT17F16-30BJC AT17F16-30BJC AT17F16-30BJC
AT17F16-30BJI AT17F16-30BJI AT17F16-30BJI
AT17F16-30TQI AT17F16-30TQI AT17F16-30TQI
PDF Datasheet Preview
• Programmable 16,777,216 x 1-bit Serial Memories Designed to Store Configuration Programs for Field Programmable Gate Arrays FPGAs
• 3.3V Output Capability
• 5V Tolerant I/O Pins
• Program Support using the Atmel ATDH2200E System or Industry Third-party

Programmers
• In-System Programmable ISP via 2-wire Bus
• Simple Interface to SRAM FPGAs
• Compatible with Atmel AT40K and AT94K Devices, APEX Devices,

FPGAs, XC3000, XC4000, XC5200, FPGAs, MPA1000 FPGAs
• Cascadable Read-back to Support Additional Configurations or Higher-density Arrays
• Low-power CMOS FLASH Process
• Available in 6 mm x 6 mm x 1 mm 8-lead LAP Pin-compatible with 8-lead SOIC/VOIC Footprint Packages , 20-lead PLCC and 44-lead TQFP Packages
• Emulation of Atmel’s AT24CXXX Serial EEPROMs
• Low-power Standby Mode
• Single Device Capable of Holding 4-bit Stream Files Allowing Simple System Reconfiguration
• Fast Serial Download Speeds up to 33 MHz
• Endurance 10,000 Write Cycles Typical
• Green Pb/Halide-free/RoHS Compliant Package Options Available

FPGA Configuration Flash Memory

AT17F16

The AT17F Series of In-System Programmable Configuration PROMs Configurators provide an easy-to-use, cost-effective configuration memory for Field Programmable Gate Arrays. The AT17F Series device is packaged in the 8-lead LAP, 20-lead PLCC and 44-lead TQFP, see Table The AT17F Series Configurator uses a simple serial-access procedure to configure one or more FPGA devices.

The AT17F Series Configurators can be programmed with industry-standard programmers, Atmel’s ATDH2200E Programming Kit or Atmel’s ATDH2225 ISP Cable.

Table AT17F Series Packages Package 8-lead LAP 20-lead PLCC 44-lead TQFP

AT17F16 Yes

Pin Configuration
8-lead LAP

DATA 1 CLK 2

RESET/OE 3 CE 4
8 VCC 7 SER_EN 6 CEO A2 5 GND
20-lead PLCC
3 NC 2 DATA 1 NC 20 VCC 19 NC

CLK 4 NC 5

RESET/OE 6 PAGESEL1 7
18 NC 17 SER_EN 16 PAGE_EN 15 READY 14 CEO A2

NC 9 GND 10 PAGESEL0 11

NC 12 NC 13
44 TQFP
44 NC 43 CLK 42 NC 41 NC 40 DATA 39 PAGE_EN 38 VCC 37 NC 36 NC 35 SER_EN 34 NC

NC 1 NC 2 NC 3 NC 4 NC 5 NC 6 NC 7 NC 8 NC 9 NC 10 NC 11
33 NC 32 NC 31 NC 30 NC 29 NC 28 NC 27 NC 26 NC 25 NC 24 NC 23 READY

NC 12 RESET/OE 13 PAGESEL0 14

CE 15 NC 16 NC 17 GND 18 PAGESEL1 19 NC 20 CEO A2 21 NC 22
2 AT17F16

Block Diagram

READY

PAGE_EN PAGESEL0 PAGESEL1

Power-on Reset

Reset

Config. Page Select

AT17F16

Clock/Oscillator Logic

Serial Download Logic

CLK CEO A2

Flash Memory

CE/WE/OE Data
Ordering Information

Memory Size
Ordering Code

Package 1 2
16-Mbit

AT17F16-30TQC AT17F16-30TQI
44A - 44 TQFP 44A - 44 TQFP

Notes For the -30BJC and -30BJI packages, customers may migrate to the AT17F32-BJU. For the -30JC and -30JI packages, customers may migrate to the AT17F16-30JU.

Green Package Options Pb/Halide-free/RoHS Compliant

Memory Size 16-Mbit
Ordering Code AT17F16-30CU AT17F16-30JU

Package
8CN4 - 8 LAP 20J - 20 PLCC

AT17F16

Operation Range Commercial 0° C to 70° C Industrial
-40° C to 85° C

Operation Range Industrial
-40° C to 85° C
8CN4 20J 44A

Package Type 8-lead, 6 mm x 6 mm x mm, Leadless Array Package LAP Pin-compatible with 8-lead SOIC/VOIC Packages 20-lead, Plastic J-leaded Chip Carrier PLCC 44-lead, Thin mm Plastic Quad Flat Package Carrier TQFP

Packaging Information
8CN4 LAP

Marked Pin1 Indentifier

Top View

Side View
mm TYP 8

Bottom View

Pin1 Corner

SYMBOL A A1 b D E e1 L L1

COMMON DIMENSIONS Unit of Measure = mm

NOM BSC REF

NOTE 1

Note:

Metal Pad Dimensions. All exposed metal area shall have the following finished platings.

Ni to mm Au to mm

Package Drawing Contact:

TITLE 8CN4, 8-lead 6 x 6 x mm Body , Lead Pitch 1.27mm,

Leadless Array Package LAP
8CN4
14 AT17F16
20J PLCC

AT17F16

PIN NO. 1 IDENTIFIER
e E1 E

D2/E2 B1

A2 A1 A
0.51 0.020 MAX 3X

This package conforms to JEDEC reference MS-018, Variation AA. Dimensions D1 and E1 do not include mold protrusion.

Allowable protrusion is mm per side. Dimension D1 and E1 include mold mismatch and are measured at the extreme material condition at the upper or lower parting line. Lead coplanarity is mm maximum.

COMMON DIMENSIONS Unit of Measure = mm

SYMBOL MIN NOM MAX NOTE
Removed -30CC and -30CI devices from ordering information. Announced last-time buy for -30JC, -30BJC, -30JI, and -30BJI devices.
Removed -30JC, -30JI, -30BJC and -30BJI devices from ordering information.
18 AT17F16

AT17F16

Headquarters

Atmel Corporation 2325 Orchard Parkway San Jose, CA 95131 USA Tel 1 408 441-0311 Fax 1 408 487-2600

International

Atmel Asia Room 1219 Chinachem Golden Plaza 77 Mody Road Tsimshatsui East Kowloon Hong Kong Tel 852 2721-9778 Fax 852 2722-1369

Atmel Europe Le Krebs 8, Rue Jean-Pierre Timbaud BP 309 78054 Saint-Quentin-enYvelines Cedex France Tel 33 1-30-60-70-00 Fax 33 1-30-60-71-11

Atmel Japan 9F, Tonetsu Shinkawa Bldg. 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan Tel 81 3-3523-3551 Fax 81 3-3523-7581

Product Contact

Web Site

Literature Requests

Technical Support

Sales Contact

Disclaimer The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Unless specifically provided otherwise, Atmel products are not suitable for, and shall not be used in, automotive applications. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life.
2008 Atmel Corporation. All rights reserved. logo and combinations thereof, and others are registered trademarks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others.
More datasheets: AOWF12T60 | BXA30-48D05-FJ | 881604 SL005 | PRM1403 WH005 | PRM1403 WH002 | PRM1403 WH001 | AT17F16-30JI | AT17F16-30CU | AT17F16-30JU | AT17F16-30TQC


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived AT17F16-30JC Datasheet file may be downloaded here without warranties.

Datasheet ID: AT17F16-30JC 518861