PI3B16232A

PI3B16232A Datasheet

PI3B16232

Part	Datasheet
PI3B16232A	PI3B16232A (pdf)

PDF Datasheet Preview
PI3B16232 3.3V, Synchronous 16-Bit to 32-Bit FET Mux/Demux NanoSwitch Product Features Near-Zero propagation delay. 5-ohm Switches Connect Between Two Ports Packages Available : - 56-pin 240mil Wide Thin Plastic TSSOP A - 56-pin 300mil Wide Plastic SSOP V Logic Block Diagram Product Description Pericom Semiconductors PI3B series of logic circuits are produced using the company's advanced submicron CMOS technology. The PI3B16232 is a volt, 16-bit to 32-bit synchronous switch. Two select inputs S0 and S1 control the data flow. A clock CLK and a clock enable CLKEN synchronize the device operation. When CLKEN is high, the bus switch remains in the last clocked function. Product Pin Configuration CLKEN 28 CLK 27 S0 30 S1 29 1 of 16 Channels 56 1B1 55 1B2 Truth Table CLK X CLKEN H L Function Last State Disconnect A = B1 and A = B2 A = B1 A = B2 1A 2B1 2B2 3A 4B1 4B2 5A 6B1 6B2 7A 8B1 8B2 GND Vc c 9A 10B1 10B2 11A 12B1 12B 2 13A 14B 1 14B 2 15A 16B1 16B2 CLK CLKEN 12 56-Pin 45 13 A, V 44 1B1 1B2 2A 3B1 3B2 4A 5B1 5B2 6A 7B1 7B 2 8A GND Vc c 9B1 9B2 10A 11B1 11B2 12A 13B1 13B2 14A 15B1 15B2 16A S0 S1 PS8178C 03/18/02 PI3B16232 3.3V, Synchronous 16-Bit to 32-Bit Maximum Ratings Above which the useful life may be impaired. For user guidelines, not tested. Storage Temperature 65°Cto+150°C Ambient Temperature with Power Applied 40°C to +85°C Supply Voltage Range 0.5Vto+4.6V Note Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the DC Input Voltage 0.5Vto+4.6V DC Output Current 120mA Power Dissipation 0.5W device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. DC Electrical Characteristics Over the Operating Range, TA = 40°C to +85°C, VCC = 3.0V to 3.6V Parameters Test Conditions 1 Min. Input HIGH Voltage Guaranteed Logic HIGH Level Input LOW Voltage Guaranteed Logic LOW Level Input High Current VCC = Max., VIN = VCC Ordering Information Part PI3B16222A 56 PI3B16222V Package TSSOP SSOP Width 240-mil 300-mil Temperature 40°C to 85°C Pericom Semiconductor Corporation 2380 Bering Drive • San Jose, CA 95131 • 1-800-435-2336 • Fax 408 435-1100 • PS8178C 03/18/02

PDF Datasheet Preview

PI3B16232
3.3V, Synchronous 16-Bit to 32-Bit FET Mux/Demux NanoSwitch

Product Features

Near-Zero propagation delay. 5-ohm Switches Connect Between Two Ports Packages Available :
- 56-pin 240mil Wide Thin Plastic TSSOP A - 56-pin 300mil Wide Plastic SSOP V

Logic Block Diagram

Product Description

Pericom Semiconductors PI3B series of logic circuits are produced using the company's advanced submicron CMOS technology.

The PI3B16232 is a volt, 16-bit to 32-bit synchronous switch. Two select inputs S0 and S1 control the data flow. A clock CLK and a clock enable CLKEN synchronize the device operation. When CLKEN is high, the bus switch remains in the last clocked function.

Product Pin Configuration

CLKEN 28 CLK 27 S0 30

S1 29
1 of 16 Channels
56 1B1
55 1B2

Truth Table

CLK X

CLKEN H L

Function Last State Disconnect A = B1 and A = B2

A = B1 A = B2
1A 2B1 2B2 3A 4B1 4B2 5A 6B1 6B2 7A 8B1 8B2 GND Vc c 9A 10B1 10B2 11A 12B1 12B 2 13A 14B 1 14B 2 15A 16B1 16B2 CLK CLKEN
12 56-Pin 45
13 A, V 44
1B1 1B2 2A 3B1 3B2 4A 5B1 5B2 6A 7B1 7B 2 8A GND Vc c 9B1 9B2 10A 11B1 11B2 12A 13B1 13B2 14A 15B1 15B2 16A S0 S1

PS8178C 03/18/02

PI3B16232 3.3V, Synchronous 16-Bit to 32-Bit

Maximum Ratings Above which the useful life may be impaired. For user guidelines, not tested.

Storage Temperature 65°Cto+150°C Ambient Temperature with Power Applied 40°C to +85°C Supply Voltage Range 0.5Vto+4.6V

Note Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the

DC Input Voltage 0.5Vto+4.6V DC Output Current 120mA Power Dissipation 0.5W
device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

DC Electrical Characteristics Over the Operating Range, TA = 40°C to +85°C, VCC = 3.0V to 3.6V

Parameters

Test Conditions 1

Min.

Input HIGH Voltage

Guaranteed Logic HIGH Level

Input LOW Voltage

Guaranteed Logic LOW Level

Input High Current

VCC = Max., VIN = VCC
Ordering Information

Part

PI3B16222A 56

PI3B16222V

Package TSSOP SSOP

Width 240-mil 300-mil

Temperature 40°C to 85°C

Pericom Semiconductor Corporation 2380 Bering Drive
• San Jose, CA 95131
• 1-800-435-2336
• Fax 408 435-1100
•

PS8178C 03/18/02

More datasheets: NANOUSB3_NE2D/GS/RS_ | M13092 SL005 | M13092 SL001 | M13092 SL002 | BDW23-S | BDW23C-S | BDW23A-S | T0053426699N | 2090135203 | DKSB1000C

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived PI3B16232A Datasheet file may be downloaded here without warranties.

Datasheet ID: PI3B16232A 510044