GPM130C

GPM130C Datasheet


GPC130 Commercial/GPM130 Medical 130 Watt Global Performance Switchers

Part Datasheet
GPM130C GPM130C GPM130C (pdf)
Related Parts Information
GPC130A GPC130A GPC130A
GPM130D GPM130D GPM130D
GPM130B GPM130B GPM130B
GPM130A GPM130A GPM130A
GPC130D GPC130D GPC130D
GPM130E GPM130E GPM130E
GPC130B GPC130B GPC130B
GPC130E GPC130E GPC130E
GPC130C GPC130C GPC130C
GPM130DG GPM130DG GPM130DG
GPC130EG GPC130EG GPC130EG
GPC130DG GPC130DG GPC130DG
GPC130AG GPC130AG GPC130AG
GPC130CG GPC130CG GPC130CG
PDF Datasheet Preview
GPC130 Commercial/GPM130 Medical 130 Watt Global Performance Switchers

FEATURES:
• Wide-range ac input 85-264 Vac
• 2-year warranty
• Commercial Approved to UL1950, IEC950,

EN60950 and CSA22.2-234 L3
• Medical Approved to UL2601-1, IEC601-1 and

CSA22.2 No. 601
• Conducted EMI exceeds FCC Class B and CISPR 22

Class B Commercial models and CISPR 11 Class B Medical models
• marked to LVD

SPECIFICATIONS:

Ac Input 85-264 Vac, 47-63 Hz single phase.

Input Current Maximum input current at 120 Vac, 60 Hz with full rated output load A

Hold-Up Time 20 ms minimum from loss of ac input at full load, nominal line 115 Vac .

Output Power 100 W continuous, 165 W peak 130 W with 26 cfm air flow. Peak ratings are for 60 s maximum duration, 10% duty cycle. During peak load condition, output regulation may exceed total regulation limits.

Overload Protection Fully protected against short circuit and output overload. Short circuit protection is cycling type power limit on outputs 1 & 2 foldback type on outputs 3 & Recovery after fault is automatic. See output ratings chart for additional notes or conditions.

Overvoltage Protection Main outputs 124% ± 12% typical.

Efficiency 70% at full rated load, nominal input voltage, depending on model and load distribution.

Turn-on Time Less than 1 second at 120 Vac, 25°C inversely proportional to input voltage and thermistor temperature .

Input Protection Internal ac fuse provided. Designed to blow only if a catastrophic failure occurs in the unit.

Inrush Current Inrush is limited by internal thermistors. Inrush at 240 Vac under cold start conditions will not exceed 34 A.

Temperature Coefficient 0.03%/°C typical on all outputs.

Thermal Shutdown Provided as a standard feature. Designed to protect unit from prolonged overtemperature.

Environmental Designed for 0 to 50°C operation at full rated output power derate output current and total output power by per °C above 50°C. See Environmental and Packaging Specifications on next page.

Power Fail

TTL- or CMOS-compatible output goes low < 0.5V 5 ms before output voltage drops more than 4% below nominal
voltage upon loss of ac power. The signal is factory set to trip on 84 to 94Vac brown-out depending upon incoming line impedance and distortion. Other settings are available to the
user through adjustment of built-in potentiometer.

Output Noise rms, 1% pk-pk, 20 MHz bandwidth, differential mode.

Measured with noise probe directly across output terminals of the power supply.

Transient Response Main typical response time for return to within of final value for a 50% load step change. A/µs. Maximum voltage deviation is Startup/shutdown overshoot less than

Remote Sense Provided as a standard feature on output

Voltage Adjustment Built-in potentiometer adjusts voltage ±5% on outputs 1 &

Overload Protection Factory set to begin power limiting at approximately 170 W.

EMI/EMC Compliance

All models include built-in EMI filtering to meet the following
emissions requirements:

EMI SPECIFICATIONS

COMPLIANCE LEVEL

Conducted Emissions GPC130 EN55022 Class B FCC Class B

Conducted Emissions GPM130 EN55022 Class B FCC Class B

Static Discharge

EN61000-4-2, 6 kV contact, 8 kV air

RF Field Susceptibility

EN61000-4-3, 3 V/meter
More datasheets: FQB24N08TM | IRM-8601S-1 | M213308 SL005 | M213308 SL002 | M213308 SL001 | EM2030L01QI | EVB-EM2030L01QI | FQPF5N60 | GPC130A | GPM130D


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived GPM130C Datasheet file may be downloaded here without warranties.

Datasheet ID: GPM130C 506312