WT41-A-AI5

WT41-A-AI5 Datasheet


WT41-A / WT41-N

Part Datasheet
WT41-A-AI5 WT41-A-AI5 WT41-A-AI5 (pdf)
Related Parts Information
WT41-A-AI4 WT41-A-AI4 WT41-A-AI4
PDF Datasheet Preview
WT41-A / WT41-N

DATA SHEET

Wednesday, 22 January 2014 Version

Copyright 2000-2014 Bluegiga Technologies

All rights reserved. Bluegiga Technologies assumes no responsibility for any errors which may appear in this manual. Furthermore, Bluegiga Technologies reserves the right to alter the hardware, software, and/or specifications detailed here at any time without notice and does not make any commitment to update the information contained here. Bluegiga’s products are not authorized for use as critical components in life support devices or systems. The WRAP is a registered trademark of Bluegiga Technologies The Bluetooth trademark is owned by the Bluetooth SIG Inc., USA and is licensed to Bluegiga Technologies. All other trademarks listed herein are owned by their respective owners.

Bluegiga Technologies Oy

VERSION HISTORY Version

Comment

First draft Description and product codes added Dimensions updated, layout guide added, UART and USB chapters added Pin descriptions, PCM, USB, UART, SPI Physical dimensions corrected Product codes corrected Recommendation for a power-up reset circuitry added to chapter 10 Pins 1 and 52 GND removed. Dimensions updated, recommended land pattern added Certification information added Physical dimensions and recommended PCB land pattern updated Figure 7 recommended land pattern corrected Radio and antenna characteristics, layout guide for WT41-N Japan certification info added FCC RF radiation exposure statement updated Layout guide updated VDD added to table 1 FCC and IC statements updated PIO current drive capability added. List of approved antennas added. IC statements in French added Information about Japan compliance updated Absolute maximum supply voltage 3.7V MIC Japan information updated

Bluegiga Technologies Oy

FCC C2PC to remove 20 cm restriction

MIC Japan ID corrected

MSL information updated

TXP vs VDD_PA figure added

Minor changes

Bluegiga Technologies Oy

TABLE OF CONTENTS
1 Ordering 2 Pinout and Terminal Description 3 Electrical Characteristics 12

Absolute Maximum Ratings 12 Recommended Operating Conditions 12 PIO Current Sink and Source 12 Transmitter Performance For BDR 13 Radiated Spurious Emissions 14 Receiver Performance 15 Current Consumption 15 Antenna Performance and Radiation Patterns 16 4 Physical Dimensions 20 5 Layout 22 WT41-A 22 WT41-N 23

Layout for WT41-N with u.fl connector close to RF pin 23 Layout for WT41-N with 50 ohm trace from RF pin to a SMA connector 23 6 UART 25 UART Bypass 27 UART Configuration While Reset is Active 27 UART Bypass 27 7 USB Interface 28 USB Data Connections 28 USB Pull-Up resistor 28 USB Power 28 Self-Powered 28 Bus-Powered 29 USB Suspend 30 USB Detach and Wake-Up 30 USB Driver 31 USB v2.0 Compliance and Compatibility 31 8 Serial Peripheral Interface 32 9 PCM Codec Interface 33 PCM Interface Master/Slave 33 Long Frame Sync 34 Short Frame Sync 34 Multi-slot Operation 35

Bluegiga Technologies Oy

GCI Interface 35

Slots and Sample 36

Additional Features 37

PCM_CLK and PCM_SYNC Generation 37

PCM Configuration 38
10 I/O Parallel Ports 40

PIO 40
11 41

Pin States on Reset 42
12 Certifications 43

Bluetooth 43

FCC 43

IC Industry 44

CE 47

Japan 47

Qualified Antenna Types for 47

Moisture Sensitivity Level 48
13 Contact 49

Bluegiga Technologies Oy

WT41 Module

WT41 is a long range class 1, + EDR module. WT41 is a highly integrated and sophisticated module, containing all the necessary elements from radio to antenna and a fully implemented protocol stack. Therefore WT41 provides an ideal solution for developers who want to integrate wireless technology into their design with limited knowledge of and RF technologies. WT41 is optimized for long range applications and since it contains a RF power amplifier, low noise amplifier and a highly efficient chip antenna. With 115 dB radio budget WT41 can reach over 1 km range in line off sight.

By default WT41 module is equipped with powerful and easy-to-use iWRAP firmware. iWRAP enables users to access functionality with simple ASCII commands delivered to the module over serial interface - it's just like a modem.

APPLICATIONS:
• Hand held terminals
• Industrial devices
• Point-of-Sale systems
• PCs
• Personal Digital Assistants PDAs
• Computer Accessories
• Access Points
• Automotive Diagnostics Units

FEATURES:
• Fully Qualified Bluetooth v2.1 + EDR end product,
• CE, FCC, IC and MIC Japan
• TX power 19 dBm
• RX sensitivity -92 dBm
• Higly efficient chip antenna, U.FL connector or

RF pin
• Class 1, range up to 800 meters
• Industrial temperature range from -40oC to
+85oC
• RoHS Compliant
• USB interface USB compatible
• UART with bypass mode
• 6 x GPIO
• 1 x 8-bit AIO
• Support for Coexistence
• Integrated iWRAPTM Bluetooth stack or HCI
firmware

Bluegiga Technologies Oy
1 Ordering Information

WT41-A-HCI

Firmware HCI21= HCI30= AI4 = AI5 = C=

HCI firmware Bluetooth + EDR HCI firmware Bluetooth iWRAP Custom*

HW version A = Chip antenna N = RF pin

Product series

Bluegiga Technologies Oy

Page 8 of 49

Pinout and Terminal Description
54 53
57 56 55
59 58
2 3 4 5
6 GND
7 GND
8 9 10
11 VDD_PA
12 13 14 15 16

PIO2 PIO3 UART_RTS UART_RX GND
17 18 19

USB+ USBUART_CTS
20 PCM_IN
21 PCM_CLK
22 23

PCM_SYNC GND

RF RFGND
51 50
49 48
47 46 45 44

AIO 43

UART_TX PIO5

SPI_MOSI SPI_MISO
42 41 40 39

SPI_CLK SPI_CSB

GND PIO7
38 37
36 35

PIO6 RESET

VDD GND
34 33
32 31
More datasheets: KPD1S2W4 | FJX4013RTF | N512-BK | CSFM105-G | CSFM104-G | CSFM103-G | CSFM101-G | CSFM102-G | AOT12N60_001 | DM74LS670N


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived WT41-A-AI5 Datasheet file may be downloaded here without warranties.

Datasheet ID: WT41-A-AI5 521952