MAX2992ECB+

MAX2992ECB+ Datasheet

MAX2992 G3-PLC MAC/PHY Powerline Transceiver

Part	Datasheet
MAX2992ECB+	MAX2992ECB+ (pdf)

Related Parts	Information
MAX2992GCB+T	MAX2992GCB+T
MAX2992GCB+	MAX2992GCB+
MAX2992ECB+T	MAX2992ECB+T

PDF Datasheet Preview
ABRIDGED DATA SHEET MAX2992 G3-PLC MAC/PHY Powerline Transceiver Benefits and Features S G3-PLC Compliant S Prestandard Conformance P1901.2, ITU G.hnem G.9955, IEC/CENELEC S Frequency-Band Compliant with CENELEC, FCC, and ARIB S Operating Frequency from 10kHz to 490kHz S Single-Chip Solution Integrating Physical Layer PHY and Media Access Controller MAC S Two UART and Two SPIK Interfaces S Supports IPV6-Compatible Networking Layer 6LoWPAN IPV6 Header Compression Maximizes Payload Size Dynamic Routing Mechanism Supports Mesh Networking CSMA/CA Carrier Sense Multiple Access with Collision Avoidance/Channel Access S High-Speed, Reliable Communication Data Rate of up to 300kbps Two Layers of Forward Error Correction FEC and Cyclic Redundancy Check CRC16 Enhanced FEC with Reed-Solomon and Viterbi CCM* Authentication Coprocessor featuring AES-128 Encryption/Decryption Automatic Repeat Request ARQ Enhances Error Detection and Data Reliability Dynamic Link Adaptation to Select Optimum Data Rate Based on Channel Condition Programmable Tone Notching S AEC-Q100 Automotive Qualified Smart Grid Communications Advanced Metering Infrastructure AMI Smart Meters AMI Concentrators Electronic Vehicle Charging Street Lighting Automation Home Energy Monitoring Building Automation Solar and Renewable Energy Management The MAX2992 powerline communication PLC baseband modem delivers half-duplex, asynchronous data communication over AC power lines at speeds up to 300kbps. The MAX2992 is a system-on-chip SoC that combines the physical PHY and media access control MAC layers using Maxim’s 32-bit MAXQ30 microcontroller core. The MAX2991 integrated analog front-end transceiver interfaces seamlessly with the MAX2992, and together with the MAX2992 G3-PLC firmware, forms a complete G3-PLC-compliant modem solution. The MAX2992 utilizes OFDM techniques with DBPSK, DQPSK, D8PSK modulation and forward error correction FEC to enable robust data communication using the electrical power grid. The design provides inherent adaptability to frequency selective channels, robustness in the presence of group delay, and immunity to impulsive noise. To allow for regulatory compliance, the MAX2992 incorporates a programmable tone notching mechanism. This allows the notching of certain frequency bands in the transmit spectrum of the modem. This feature also provides an alternative method to address coexistence with other narrowband transmitters such as legacy FSK-based PLC systems. The MAX2992 MAC incorporates a 6LoWPAN adaptation layer to support IPv6 packets. An enhanced CSMA/ CA and ARQ, together with the mesh routing protocol, supports all common MAC layer services for various network topologies. Intelligent communication mechanisms adapt and enhance system performance over a range of channel conditions. These mechanisms include channel estimation, adaptive tone mapping, and routing protocols. An on-chip CCM an extension of CCM specified in IEEE authentication coprocessor with AES-128 encryption/decryption provides security and authentication. Ordering Information PART TEMP RANGE PIN-PACKAGE MAX2992GCB/V+ -40NC to +105NC 64 LQFP /V denotes an automotive qualified part. +Denotes a lead Pb -free/RoHS-compliant package. G3-PLC is a trademark of Maxim Integrated Products, Inc. SPI is a trademark of Motorola, Inc. IEEE is registered service mark of the Institute of Electrical and Electronics Engineers, Inc. Maxim Integrated Products 1 For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642, or visit Maxim’s website at ABRIDGED DATA SHEET MAX2992 G3-PLC MAC/PHY Powerline Transceiver Typical Application Circuit HOST APPLICATION MAX2992 INTERFACE MAX2991 Tx BLOCK AFE Rx BLOCK LINE DRIVER FLASH G3-PLC FIRMWARE LINE COUPLER AC POWER LINE Maxim Integrated Products 2

PDF Datasheet Preview

ABRIDGED DATA SHEET

MAX2992 G3-PLC MAC/PHY Powerline Transceiver

Benefits and Features

S G3-PLC Compliant S Prestandard Conformance P1901.2, ITU

G.hnem G.9955, IEC/CENELEC S Frequency-Band Compliant with CENELEC, FCC,
and ARIB S Operating Frequency from 10kHz to 490kHz S Single-Chip Solution Integrating Physical Layer

PHY and Media Access Controller MAC S Two UART and Two SPIK Interfaces S Supports IPV6-Compatible Networking Layer
6LoWPAN IPV6 Header Compression Maximizes Payload Size

Dynamic Routing Mechanism Supports Mesh Networking

CSMA/CA Carrier Sense Multiple Access with Collision Avoidance/Channel Access

S High-Speed, Reliable Communication Data Rate of up to 300kbps Two Layers of Forward Error Correction FEC and Cyclic Redundancy Check CRC16 Enhanced FEC with Reed-Solomon and Viterbi CCM* Authentication Coprocessor featuring AES-128 Encryption/Decryption Automatic Repeat Request ARQ Enhances Error Detection and Data Reliability Dynamic Link Adaptation to Select Optimum Data Rate Based on Channel Condition Programmable Tone Notching

S AEC-Q100 Automotive Qualified

Smart Grid Communications Advanced Metering Infrastructure AMI Smart Meters AMI Concentrators Electronic Vehicle Charging Street Lighting Automation Home Energy Monitoring Building Automation Solar and Renewable Energy Management

The MAX2992 powerline communication PLC baseband modem delivers half-duplex, asynchronous data communication over AC power lines at speeds up to 300kbps. The MAX2992 is a system-on-chip SoC that combines the physical PHY and media access control MAC layers using Maxim’s 32-bit MAXQ30 microcontroller core. The MAX2991 integrated analog front-end transceiver interfaces seamlessly with the MAX2992, and together with the MAX2992 G3-PLC firmware, forms a complete G3-PLC-compliant modem solution.

The MAX2992 utilizes OFDM techniques with DBPSK, DQPSK, D8PSK modulation and forward error correction FEC to enable robust data communication using the electrical power grid. The design provides inherent adaptability to frequency selective channels, robustness in the presence of group delay, and immunity to impulsive noise. To allow for regulatory compliance, the MAX2992 incorporates a programmable tone notching mechanism. This allows the notching of certain frequency bands in the transmit spectrum of the modem. This feature also provides an alternative method to address coexistence with other narrowband transmitters such as legacy FSK-based PLC systems.

The MAX2992 MAC incorporates a 6LoWPAN adaptation layer to support IPv6 packets. An enhanced CSMA/ CA and ARQ, together with the mesh routing protocol, supports all common MAC layer services for various network topologies. Intelligent communication mechanisms adapt and enhance system performance over a range of channel conditions. These mechanisms include channel estimation, adaptive tone mapping, and routing protocols. An on-chip CCM an extension of CCM specified in IEEE authentication coprocessor with AES-128 encryption/decryption provides security and authentication.
Ordering Information

PART

TEMP RANGE PIN-PACKAGE

MAX2992GCB/V+ -40NC to +105NC
64 LQFP
/V denotes an automotive qualified part. +Denotes a lead Pb -free/RoHS-compliant package.

G3-PLC is a trademark of Maxim Integrated Products, Inc. SPI is a trademark of Motorola, Inc. IEEE is registered service mark of the Institute of Electrical and Electronics Engineers, Inc.

Maxim Integrated Products 1
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642, or visit Maxim’s website at

ABRIDGED DATA SHEET

MAX2992 G3-PLC MAC/PHY Powerline Transceiver

Typical Application Circuit

HOST APPLICATION

MAX2992

INTERFACE

MAX2991

Tx BLOCK AFE

Rx BLOCK

LINE DRIVER

FLASH G3-PLC FIRMWARE

LINE COUPLER

AC POWER LINE

Maxim Integrated Products 2

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived MAX2992ECB+ Datasheet file may be downloaded here without warranties.

Datasheet ID: MAX2992ECB+ 647290