SPM0408LE5H-TB-6

SPM0408LE5H-TB-6 Datasheet

SPM0408LE5H-TB

Part	Datasheet
SPM0408LE5H-TB-6	SPM0408LE5H-TB-6 (pdf)

PDF Datasheet Preview
SPM0408LE5H-TB Amplified Zero-Height SiSonicTM Microphone With Enhanced RF Protection The SPM0408LE5H-TB is a miniature, highperformance, low power, bottom port silicon microphone. Using Knowles’ proven high performance SiSonicTM MEMS technology, the SPM0408LE5H-TB consists of an acoustic sensor, a low noise input buffer, and an output amplifier. These devices are suitable for applications such as cellphones, smart phones, laptop computers, sensors, digital still cameras, portable music recorders, and other portable electronic devices where excellent wideband audio performance and RF immunity are required. Features • Up to 20dB of Gain • Enhanced RF protection • Flat Frequency Response • Zero-Height MicTM • Operation to 5v • Ultra-Stable Performance • Standard SMD Reflow • Omnidirectional 2/28/2013 Knowles Electronics SPM0408LE5H-TB ABSOLUTE MAXIMUM RATINGS Parameter VDD to Ground OUT to Ground Input Current to Any Pin Temperature Range Absolute Maximum Rating VDD + ±5 -40 to +100 Units V mA °C Stresses exceeding these “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only. Functional operation at these or any other conditions beyond those indicated under “Acoustic & Electrical Specifications” is not implied. Exposure beyond those indicated under “Acoustic & Electrical Specifications” for extended periods may affect device reliability. ACOUSTIC & ELECTRICAL SPECIFICATIONS TEST CONDITIONS 23 ±2°C, 55±20% R.H., VDD min < VDD < VDD max , no load, Gain = 20dB, unless otherwise indicated Parameter Supply Voltage1 Supply Current1,2 Sensitivity1 Symbol VDD IDD S Conditions 94 dB SPL 1 kHz Min Typ Max Units - 350 µA -21 -18 -15 dBV/Pa Signal to Noise Ratio SNR 94 dB SPL 1 kHz, A-weighted - dB A Total Harmonic Distortion Acoustic Overload Point Output Impedance ZOUT 94 dB SPL 1 kHz, S = Typ, Rload > 2 10% THD 1 kHz, Gain = 0dB, S = Typ, VDD = 5.5V, Rload > 2 1153 1 kHz - dB SPL Directivity Omnidirectional Polarity Increasing sound pressure Increasing output voltage 1 100% tested. 2 Maximum specifications are measured at maximum VDD. Typical specifications are measured at VDD = 1.8V. 3 For gain = 20dB, AOP min = 95 dB SPL.

PDF Datasheet Preview

SPM0408LE5H-TB

Amplified Zero-Height SiSonicTM Microphone With Enhanced RF Protection

The SPM0408LE5H-TB is a miniature, highperformance, low power, bottom port silicon microphone. Using Knowles’ proven high performance SiSonicTM MEMS technology, the SPM0408LE5H-TB consists of an acoustic sensor, a low noise input buffer, and an output amplifier. These devices are suitable for applications such as cellphones, smart phones, laptop computers, sensors, digital still cameras, portable music recorders, and other portable electronic devices where excellent wideband audio performance and RF immunity are required.

Features
• Up to 20dB of Gain
• Enhanced RF protection
• Flat Frequency Response
• Zero-Height MicTM
• Operation to 5v
• Ultra-Stable Performance
• Standard SMD Reflow
• Omnidirectional
2/28/2013 Knowles Electronics

SPM0408LE5H-TB

ABSOLUTE MAXIMUM RATINGS

Parameter VDD to Ground OUT to Ground

Input Current to Any Pin Temperature Range

Absolute Maximum Rating

VDD + ±5
-40 to +100

Units V mA °C

Stresses exceeding these “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only. Functional operation at these or any other conditions beyond those indicated under “Acoustic & Electrical Specifications” is not implied. Exposure beyond those indicated under “Acoustic & Electrical Specifications” for extended periods may affect device reliability.

ACOUSTIC & ELECTRICAL SPECIFICATIONS

TEST CONDITIONS 23 ±2°C, 55±20% R.H., VDD min < VDD < VDD max , no load, Gain = 20dB, unless otherwise indicated

Parameter Supply Voltage1 Supply Current1,2

Sensitivity1

Symbol VDD IDD S

Conditions 94 dB SPL 1 kHz

Min Typ Max Units
- 350 µA
-21 -18 -15 dBV/Pa

Signal to Noise Ratio SNR
94 dB SPL 1 kHz, A-weighted
- dB A

Total Harmonic Distortion

Acoustic Overload Point

Output Impedance ZOUT
94 dB SPL 1 kHz, S = Typ, Rload > 2
10% THD 1 kHz, Gain = 0dB, S = Typ, VDD = 5.5V, Rload > 2
1153
1 kHz
- dB SPL

Directivity

Omnidirectional

Polarity

Increasing sound pressure

Increasing output voltage
1 100% tested.
2 Maximum specifications are measured at maximum VDD. Typical specifications are measured at VDD = 1.8V. 3 For gain = 20dB, AOP min = 95 dB SPL.

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived SPM0408LE5H-TB-6 Datasheet file may be downloaded here without warranties.

Datasheet ID: SPM0408LE5H-TB-6 644981