ICS552R-01I

ICS552R-01I Datasheet

ICS552-01

Part	Datasheet
ICS552R-01I	ICS552R-01I (pdf)

Related Parts	Information
ICS552R-01	ICS552R-01
ICS552R-01T	ICS552R-01T
ICS552R-01IT	ICS552R-01IT

PDF Datasheet Preview
OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS DATASHEET ICS552-01 The ICS552-01 produces 8 low-skew copies of the multiple input clock or fundamental, parallel-mode crystal. Unlike other clock drivers, these parts do not require a separate oscillator for the input. Using IDT’s patented Phase-Locked Loop PLL to multiply the input frequency, it is ideal for generating and distributing multiple high-frequency clocks. This is a single chip used for 3 different applications: 1 ICS552-01 A mode an Oscillator mutiplier 2 ICS552-01 B mode a Dual 1:4 buffer 3 ICS552-01 C mode a 1:8 Oscillator buffer Features all • Packaged as 20-pin SSOP QSOP • Pb-free packaging available • Operating voltages of V to V • Industrial temperature available Features specific ICS552-01 for A mode • Contains on-chip multiplier with selections of x1, x1.33, x2, x2.66, x3, x3.33, x4, x4.66, x5, and x6 • Power-down and Tri-state modes Block Diagram mode ICS552-01 for B mode • Up to 200 MHz clock input/output at V • Low skew of 250 ps maximum for any bank of four • Inputs can be connected together for a 1 to 8 buffer with 250 ps skew between any outputs • Non-inverting buffer mode • Ideal for clock networks • Output Enable mode tri-states outputs • Full CMOS output swing with 25 mA output drive capability at TTL levels • Advanced, low power, sub-micron CMOS process ICS552-01 for C mode • Use with 25 MHz crystal for networking • Use with 27 MHz crystal for MPEG ICS552-01 for A and C modes • Input frequency of to MHz • Provides 8 low-skew outputs <250 ps • Output clock duty cycle of 40/60 at V NOTE The ICS552A-01 is recommended for new designs NOTE EOL for non-green parts to occur on 5/13/10 per PDN U-09-01 4 S3:S0 to MHz crystal or clock input Crystal Buffer/ Crystal Oscillator External capacitors are required with a crystal input. PLL Multiplier CLK1 CLK2 CLK3 CLK4 CLK5 CLK6 CLK7 CLK8 IDT / ICS OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS 1 ICS552-01 OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS CLOCK MULTIPLIER AND BUFFER Pin Assignment mode X1/ICLK 3 GND 6 CLK1 7 CLK2 8 Ordering Information A1 -C- SEATING PLANE aaa C Part / Order Number 552R-01* 552R-01T* 552R-01LN 552R-01LNT 552R-01I* 552R-01IT* 552R-01ILF 552R-01ILFT Marking ICS552R-01 ICS552R-01 552R-01LN 552R-01LN ICS552R-01I ICS552R-01I 552R-01ILF 552R-01ILF Shipping Packaging Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Package 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP Temperature 0 to +70° C 0 to +70° C 0 to +70° C 0 to +70° C -40 to +85° C -40 to +85° C -40 to +85° C -40 to +85° C *NOTE EOL for non-green parts to occur on 5/13/10 per PDN U-09-01 Parts that are ordered with a "LF"or “LN” suffix to the part number are the Pb-Free configuration and are RoHS compliant. While the information presented herein has been checked for both accuracy and reliability, Integrated Device Technology IDT assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is intended for use in normal commercial applications. Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary environmental requirements are not recommended without additional processing by IDT. IDT reserves the right to change any circuitry or specifications without notice. IDT does not authorize or warrant any IDT product for use in life support devices or critical medical instruments. IDT / ICS OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS 10 ICS552-01 OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS CLOCK MULTIPLIER AND BUFFER Innovate with IDT and accelerate your future networks. Contact: For Sales 800-345-7015 408-284-8200 Fax 408-284-2775 For Tech Support Corporate Headquarters Integrated Device Technology, Inc. 2006 Integrated Device Technology, Inc. All rights reserved. Product specifications subject to change without notice. IDT and the IDT logo are trademarks of Integrated Device Technology, Inc. Accelerated Thinking is a service mark of Integrated Device Technology, Inc. All other brands, product names and marks are or may be trademarks or registered trademarks used to identify products or services of their respective owners. Printed in USA

PDF Datasheet Preview

OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS

DATASHEET

ICS552-01

The ICS552-01 produces 8 low-skew copies of the multiple input clock or fundamental, parallel-mode crystal. Unlike other clock drivers, these parts do not require a separate oscillator for the input. Using IDT’s patented Phase-Locked Loop PLL to multiply the input frequency, it is ideal for generating and distributing multiple high-frequency clocks. This is a single chip used for 3 different applications:
1 ICS552-01 A mode an Oscillator mutiplier
2 ICS552-01 B mode a Dual 1:4 buffer
3 ICS552-01 C mode a 1:8 Oscillator buffer

Features all
• Packaged as 20-pin SSOP QSOP
• Pb-free packaging available
• Operating voltages of V to V
• Industrial temperature available

Features specific

ICS552-01 for A mode
• Contains on-chip multiplier with selections of x1,
x1.33, x2, x2.66, x3, x3.33, x4, x4.66, x5, and x6
• Power-down and Tri-state modes

Block Diagram mode

ICS552-01 for B mode
• Up to 200 MHz clock input/output at V
• Low skew of 250 ps maximum for any bank of four
• Inputs can be connected together for a 1 to 8 buffer
with 250 ps skew between any outputs
• Non-inverting buffer mode
• Ideal for clock networks
• Output Enable mode tri-states outputs
• Full CMOS output swing with 25 mA output drive
capability at TTL levels
• Advanced, low power, sub-micron CMOS process

ICS552-01 for C mode
• Use with 25 MHz crystal for networking
• Use with 27 MHz crystal for MPEG

ICS552-01 for A and C modes
• Input frequency of to MHz
• Provides 8 low-skew outputs <250 ps
• Output clock duty cycle of 40/60 at V

NOTE The ICS552A-01 is recommended for new designs

NOTE EOL for non-green parts to occur on 5/13/10 per PDN U-09-01
4 S3:S0
to MHz crystal or clock input

Crystal Buffer/ Crystal Oscillator

External capacitors are required with a crystal input.

PLL Multiplier

CLK1 CLK2 CLK3 CLK4 CLK5 CLK6 CLK7 CLK8

IDT / ICS OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS 1

ICS552-01 OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS

CLOCK MULTIPLIER AND BUFFER

Pin Assignment mode

X1/ICLK 3

GND 6

CLK1 7

CLK2 8
Ordering Information

A1 -C-

SEATING PLANE
aaa C

Part / Order Number
552R-01* 552R-01T* 552R-01LN 552R-01LNT 552R-01I* 552R-01IT* 552R-01ILF 552R-01ILFT

Marking

ICS552R-01 ICS552R-01 552R-01LN 552R-01LN ICS552R-01I ICS552R-01I 552R-01ILF 552R-01ILF

Shipping Packaging

Tubes Tape and Reel

Tubes Tape and Reel

Tubes Tape and Reel

Tubes Tape and Reel

Package
20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP 20-pin SSOP

Temperature
0 to +70° C 0 to +70° C 0 to +70° C 0 to +70° C -40 to +85° C -40 to +85° C -40 to +85° C -40 to +85° C
*NOTE EOL for non-green parts to occur on 5/13/10 per PDN U-09-01

Parts that are ordered with a "LF"or “LN” suffix to the part number are the Pb-Free configuration and are RoHS compliant.

While the information presented herein has been checked for both accuracy and reliability, Integrated Device Technology IDT assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is intended for use in normal commercial applications. Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary environmental requirements are not recommended without additional processing by IDT. IDT reserves the right to change any circuitry or specifications without notice. IDT does not authorize or warrant any IDT product for use in life support devices or critical medical instruments.

IDT / ICS OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS 10

ICS552-01 OSCILLATOR, MULTIPLIER, AND BUFFER WITH 8 OUTPUTS

CLOCK MULTIPLIER AND BUFFER

Innovate with IDT and accelerate your future networks. Contact:

For Sales
800-345-7015 408-284-8200 Fax 408-284-2775

For Tech Support

Corporate Headquarters

Integrated Device Technology, Inc.
2006 Integrated Device Technology, Inc. All rights reserved. Product specifications subject to change without notice. IDT and the IDT logo are trademarks of Integrated Device Technology, Inc. Accelerated Thinking is a service mark of Integrated Device Technology, Inc. All other brands, product names and marks are or may be trademarks or registered trademarks used to identify products or services of their respective owners. Printed in USA

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived ICS552R-01I Datasheet file may be downloaded here without warranties.

Datasheet ID: ICS552R-01I 637006