TLE6236G

TLE6236G Datasheet

Datasheet TLE 6236 G

Part	Datasheet
TLE6236G	TLE6236G (pdf)

PDF Datasheet Preview
Datasheet TLE 6236 G Smart Octal Low-Side Switch Product Summary • Short Circuit Protection • Overtemperature Protection • Overvoltage Protection • 8 bit Serial Data Input and Diagnostic Output acc. SPI protocol Supply voltage Drain source clamping voltage On resistance VDS AZ max 60 • Direct Parallel Control of Four Chan- Output current all outp.ON equal ID NOM 200 nels for PWM Applications individually • General Fault Flag • Daisy chainable with other SPI devices • Very Low Leakage Current 1µA • Compatible with 3V Micro Controllers • Electostatic Discharge ESD Protection Application • µC Compatible Power Switch for 12V and 24VApplications • Switch for Automotive and Industrial System • Solenoids, Relays, Resistive Loads, LEDs • Robotic Controls P-DSO 28 Ordering Code: Q67007-A9413-A705 Octal Low-Side Switch in Smart Power Technology SPT with a Serial Peripheral Interface SPI and eight open drain DMOS output stages. The TLE 6236 G is protected by embedded protection functions and designed for automotive and industrial applications. The output stages are controlled via an SPI Interface. Additionally four channels can be controlled direct in parallel for PWM applications. The open load detection pull down sources can be disabled via the OL/PRG pin. Then the leakage current is reduced to 1µA max. to avoid e.g. the glowing of LEDs in off state. Therefore the TLE 6236 G is particularly suitable for body control units, dash board illumination or en- gine management systems. Block Diagram OL/PRG RESET VS FAULT IN1 IN2 IN3 IN4 SCLK SI CS SO V2.1 as Ch. 1 LOGIC Protection Functions as Ch. 1 as Ch. 1 Output Stage Serial Interface SPI Output Control Buffer OL/PRG GND Page 1 OUT1 OUT8 26.Aug. 2002 Datasheet TLE 6236 G Detailed Block Diagram OL/PRG RESET FAULT Channel 1 Open load/SCG SCB/Overload Output Stage OUT1 IN2 IN3 IN4 SO SI SCLK CS SPI Interface 16 bit OL/PRG Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 OUT8 V2.1 26.Aug. 2002 Package and Ordering Code all dimensions in mm P-DSO 28 TLE 6236 G Ordering Code Q67007-A9413-A705 Datasheet TLE 6236 G Published by Infineon Technologies AG, Bereichs Kommunikation St.-Martin-Strasse 76, D-81541 München Infineon Technologies AG 1999 All Rights Reserved. Attention please! The information herein is given to describe certain components and shall not be considered as warranted characteristics. Terms of delivery and rights to technical change reserved. We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding circuits, descriptions and charts stated herein. Infineon Technologies is an approved CECC manufacturer. Information For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies Office in Germany or our Infineon Technologies Representatives worldwide see address list . Warnings Due to technical requirements components may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies Office. Infineon Technologies Components may only be used in life-support devices or systems with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered. V2.1 Page 15 26.Aug. 2002

PDF Datasheet Preview

Datasheet TLE 6236 G

Smart Octal Low-Side Switch

Product Summary
• Short Circuit Protection
• Overtemperature Protection
• Overvoltage Protection
• 8 bit Serial Data Input and Diagnostic

Output acc. SPI protocol

Supply voltage Drain source clamping voltage On resistance

VDS AZ max 60
• Direct Parallel Control of Four Chan- Output current all outp.ON equal ID NOM 200
nels for PWM Applications
individually
• General Fault Flag
• Daisy chainable with other SPI devices
• Very Low Leakage Current 1µA
• Compatible with 3V Micro Controllers
• Electostatic Discharge ESD Protection

Application
• µC Compatible Power Switch for 12V and 24VApplications
• Switch for Automotive and Industrial System
• Solenoids, Relays, Resistive Loads, LEDs
• Robotic Controls

P-DSO 28
Ordering Code:

Q67007-A9413-A705

Octal Low-Side Switch in Smart Power Technology SPT with a Serial

Peripheral Interface SPI and eight open drain DMOS output stages. The TLE 6236 G is protected by
embedded protection functions and designed for automotive and industrial applications. The output
stages are controlled via an SPI Interface. Additionally four channels can be controlled direct in parallel
for PWM applications. The open load detection pull down sources can be disabled via the OL/PRG
pin. Then the leakage current is reduced to 1µA max. to avoid e.g. the glowing of LEDs in off state.

Therefore the TLE 6236 G is particularly suitable for body control units, dash board illumination or en-
gine management systems.

Block Diagram

OL/PRG RESET VS FAULT

IN1 IN2 IN3 IN4

SCLK SI CS SO

V2.1
as Ch. 1

LOGIC

Protection Functions
as Ch. 1 as Ch. 1

Output Stage

Serial Interface SPI

Output Control Buffer

OL/PRG

GND Page 1

OUT1 OUT8
26.Aug. 2002

Datasheet TLE 6236 G Detailed Block Diagram

OL/PRG RESET FAULT

Channel 1

Open load/SCG SCB/Overload

Output Stage

OUT1

IN2 IN3 IN4

SO SI SCLK CS

SPI Interface
16 bit

OL/PRG

Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8

OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 OUT8

V2.1
26.Aug. 2002
Package and Ordering Code
all dimensions in mm

P-DSO 28 TLE 6236 G
Ordering Code Q67007-A9413-A705

Datasheet TLE 6236 G

Published by Infineon Technologies AG, Bereichs Kommunikation St.-Martin-Strasse 76, D-81541 München Infineon Technologies AG 1999 All Rights Reserved.

Attention please!

The information herein is given to describe certain components and shall not be considered as warranted characteristics.

Terms of delivery and rights to technical change reserved.

We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding circuits, descriptions and charts stated herein.

Infineon Technologies is an approved CECC manufacturer.

Information

For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies Office in Germany or our Infineon Technologies Representatives worldwide see address list .

Warnings

Due to technical requirements components may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies Office.

Infineon Technologies Components may only be used in life-support devices or systems with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.

V2.1

Page 15
26.Aug. 2002

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived TLE6236G Datasheet file may be downloaded here without warranties.

Datasheet ID: TLE6236G 638776