AUIPS7081R

AUIPS7081R Datasheet

AUIPS7081 R S

Part	Datasheet
AUIPS7081R	AUIPS7081R (pdf)

Related Parts	Information
AUIPS7081	AUIPS7081
AUIPS7081S	AUIPS7081S

PDF Datasheet Preview
July, 17th, 2014 Automotive grade AUIPS7081 R S INTELLIGENT POWER HIGH SIDE SWITCH • Over temperature shutdown with auto-restart • Short circuit protection current limit • Active clamp • Open load detection • Logic ground isolated from power ground • ESD protection • Ground loss protection • Status feedback The AUIPS7081 R S is a five terminal Intelligent Power Switch IPS with built in short circuit, over-temperature, ESD protection, inductive load capability and diagnostic feedback. The output current is limited at Ilim value. Current limitation is activated until the thermal protection acts. The over-temperature protection turns off the device if the junction temperature exceeds Tshutdown. It will automatically restart after the junction has cooled 7°C below Tshutdown. A diagnostic pin is provided for status feedback of short circuit, over-temperature and open load detection. The double level shifter circuitry allows large offsets between the logic ground and the load. Typical Connection Product Summary Rds on max. Vclamp 70V I Limit 5A typ. Open load 3V Package TO220 AUIPS7081 AUIPS7081S D-Pak AUIPS7081R +Bat 15K Dg 4 Control V Diag Input Signal In 2 Rin Gnd 1 Vcc 3 Out 5 Pull-up resistor for Open Load Off detection Load AUIPS7081 R S Qualification Information† Qualification Level Automotive per AEC-Q100 Comments This family of ICs has passed an Automotive qualification. IR’s Industrial and Consumer qualification level is granted by extension of the higher Automotive level. D2PAK-5L MSL1, 260°C per IPC/JEDEC J-STD-020 Moisture Sensitivity Level TO-220 Not applicable non-surface mount package style DPAK-5L MSL1, 260°C per IPC/JEDEC J-STD-020 Ordering Information Base Part Number Package Type AUIPS7081 TO220-5-Leads AUIPS7081S D2-Pak-5-Leads AUIPS7081R D-Pak-5-Leads Standard Pack Form Tube Tape and reel left Tube Tape and reel left Quantity 50 800 75 3000 Complete Part Number AUIPS7081 AUIPS7081S AUIPS7081STRL AUIPS7081R AUIPS7081RTRL AUIPS7081 R S IMPORTANT NOTICE Unless specifically designated for the automotive market, International Rectifier Corporation and its subsidiaries IR reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or services without notice. Part numbers designated with the “AU” prefix follow automotive industry and / or customer specific requirements with regards to product discontinuance and process change notification. All products are sold subject to IR’s terms and conditions of sale supplied at the time of order acknowledgment. IR warrants performance of its hardware products to the specifications applicable at the time of sale in accordance with IR’s standard warranty. Testing and other quality control techniques are used to the extent IR deems necessary to support this warranty. Except where mandated by government requirements, testing of all parameters of each product is not necessarily performed. IR assumes no liability for applications assistance or customer product design. Customers are responsible for their products and applications using IR components. To minimize the risks with customer products and applications, customers should provide adequate design and operating safeguards. Reproduction of IR information in IR data books or data sheets is permissible only if reproduction is without alteration and is accompanied by all associated warranties, conditions, limitations, and notices. Reproduction of this information with alterations is an unfair and deceptive business practice. IR is not responsible or liable for such altered documentation. Information of third parties may be subject to additional restrictions. Resale of IR products or serviced with statements different from or beyond the parameters stated by IR for that product or service voids all express and any implied warranties for the associated IR product or service and is an unfair and deceptive business practice. IR is not responsible or liable for any such statements. IR products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or in other applications intended to support or sustain life, or in any other application in which the failure of the IR product could create a situation where personal injury or death may occur. Should Buyer purchase or use IR products for any such unintended or unauthorized application, Buyer shall indemnify and hold International Rectifier and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that IR was negligent regarding the design or manufacture of the product. Only products certified as military grade by the Defense Logistics Agency DLA of the US Department of Defense, are designed and manufactured to meet DLA military specifications required by certain military, aerospace or other applications. Buyers acknowledge and agree that any use of IR products not certified by DLA as military-grade, in applications requiring military grade products, is solely at the Buyer’s own risk and that they are solely responsible for compliance with all legal and regulatory requirements in connection with such use. IR products are neither designed nor intended for use in automotive applications or environments unless the specific IR products are designated by IR as compliant with ISO/TS 16949 requirements and bear a part number including the designation “AU”. Buyers acknowledge and agree that, if they use any non-designated products in automotive applications, IR will not be responsible for any failure to meet such requirements. For technical support, please contact IR’s Technical Assistance Center WORLD HEADQUARTERS 101 N. Sepulveda Blvd., El Segundo, California 90245 Tel 310 252-7105 AUIPS7081 R S October 2011 March 2012 October 18, 2012 June, 16th 2014 July 17, 2014 Notes/Changes First release Remove the preliminary mention Remove the PbF mention Update minimum value of Ilim Remove TRR and TR packing option Remove Pbf suffix in the 1st page

PDF Datasheet Preview

July, 17th, 2014

Automotive grade

AUIPS7081 R S

INTELLIGENT POWER HIGH SIDE SWITCH
• Over temperature shutdown with auto-restart
• Short circuit protection current limit
• Active clamp
• Open load detection
• Logic ground isolated from power ground
• ESD protection
• Ground loss protection
• Status feedback

The AUIPS7081 R S is a five terminal Intelligent Power Switch IPS with built in short circuit, over-temperature, ESD protection, inductive load capability and diagnostic feedback. The output current is limited at Ilim value. Current limitation is activated until the thermal protection acts. The over-temperature protection turns off the device if the junction temperature exceeds Tshutdown. It will automatically restart after the junction has cooled 7°C below Tshutdown. A diagnostic pin is provided for status feedback of short circuit, over-temperature and open load detection. The double level shifter circuitry allows large offsets between the logic ground and the load.

Typical Connection

Product Summary

Rds on max.

Vclamp 70V

I Limit
5A typ.

Open load 3V

Package

TO220

AUIPS7081

AUIPS7081S

D-Pak

AUIPS7081R
+Bat
15K Dg 4

Control

V Diag Input Signal

In 2 Rin

Gnd 1

Vcc 3

Out 5

Pull-up resistor for Open Load Off detection

Load

AUIPS7081 R S

Qualification Information†

Qualification Level

Automotive per AEC-Q100

Comments This family of ICs has passed an Automotive qualification. IR’s Industrial and Consumer qualification level is granted by extension of the higher Automotive level.

D2PAK-5L

MSL1, 260°C per IPC/JEDEC J-STD-020

Moisture Sensitivity Level

TO-220

Not applicable non-surface mount package style

DPAK-5L

MSL1, 260°C per IPC/JEDEC J-STD-020
Ordering Information

Base Part Number Package Type

AUIPS7081

TO220-5-Leads

AUIPS7081S

D2-Pak-5-Leads

AUIPS7081R

D-Pak-5-Leads

Standard Pack

Form Tube Tape and reel left Tube Tape and reel left

Quantity 50 800 75
3000

Complete Part Number

AUIPS7081 AUIPS7081S AUIPS7081STRL AUIPS7081R AUIPS7081RTRL

AUIPS7081 R S

IMPORTANT NOTICE

Unless specifically designated for the automotive market, International Rectifier Corporation and its subsidiaries IR reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or services without notice. Part numbers designated with the “AU” prefix follow automotive industry and / or customer specific requirements with regards to product discontinuance and process change notification. All products are sold subject to IR’s terms and conditions of sale supplied at the time of order acknowledgment.

IR warrants performance of its hardware products to the specifications applicable at the time of sale in accordance with IR’s standard warranty. Testing and other quality control techniques are used to the extent IR deems necessary to support this warranty. Except where mandated by government requirements, testing of all parameters of each product is not necessarily performed.

IR assumes no liability for applications assistance or customer product design. Customers are responsible for their products and applications using IR components. To minimize the risks with customer products and applications, customers should provide adequate design and operating safeguards.

Reproduction of IR information in IR data books or data sheets is permissible only if reproduction is without alteration and is accompanied by all associated warranties, conditions, limitations, and notices. Reproduction of this information with alterations is an unfair and deceptive business practice. IR is not responsible or liable for such altered documentation. Information of third parties may be subject to additional restrictions.

Resale of IR products or serviced with statements different from or beyond the parameters stated by IR for that product or service voids all express and any implied warranties for the associated IR product or service and is an unfair and deceptive business practice. IR is not responsible or liable for any such statements.

IR products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or in other applications intended to support or sustain life, or in any other application in which the failure of the IR product could create a situation where personal injury or death may occur. Should Buyer purchase or use IR products for any such unintended or unauthorized application, Buyer shall indemnify and hold International Rectifier and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that IR was negligent regarding the design or manufacture of the product.

Only products certified as military grade by the Defense Logistics Agency DLA of the US Department of Defense, are designed and manufactured to meet DLA military specifications required by certain military, aerospace or other applications. Buyers acknowledge and agree that any use of IR products not certified by DLA as military-grade, in applications requiring military grade products, is solely at the Buyer’s own risk and that they are solely responsible for compliance with all legal and regulatory requirements in connection with such use.

IR products are neither designed nor intended for use in automotive applications or environments unless the specific IR products are designated by IR as compliant with ISO/TS 16949 requirements and bear a part number including the designation “AU”. Buyers acknowledge and agree that, if they use any non-designated products in automotive applications, IR will not be responsible for any failure to meet such requirements.

For technical support, please contact IR’s Technical Assistance Center

WORLD HEADQUARTERS 101 N. Sepulveda Blvd., El Segundo, California 90245

Tel 310 252-7105

AUIPS7081 R S

October 2011

March 2012

October 18, 2012

June, 16th 2014

July 17, 2014

Notes/Changes

First release Remove the preliminary mention Remove the PbF mention Update minimum value of Ilim Remove TRR and TR packing option Remove Pbf suffix in the 1st page

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived AUIPS7081R Datasheet file may be downloaded here without warranties.

Datasheet ID: AUIPS7081R 637608