FIT0282

FIT0282 Datasheet

3D Printer Heater SKU FIT0282

Part	Datasheet
FIT0282	FIT0282 (pdf)

PDF Datasheet Preview
3D Printer Heater SKU FIT0282 INTRODUCTION This is a Heater used to heating the hot end which is very popular for 3D printers such as Reprap, Ultimaker and Makerbot. It has a right angle which make it easy to be installed at the hot end. 1.6m wire is long enough to suit most situation. The bright red color gives a bright warning of its heat! SPECIFICATION • Voltage:19V • Power:38W • Wire length:1.6m 62.99 • head diameter:5.8mm-6mm 0.23"-0.24" • Head lenght:25mm 0.98" Powered By DFRobot 2008-2017

PDF Datasheet Preview

3D Printer Heater SKU FIT0282

INTRODUCTION

This is a Heater used to heating the hot end which is very popular for 3D printers such as Reprap, Ultimaker and Makerbot. It has a right angle which make it easy to be installed at the hot end. 1.6m wire is long enough to suit most situation. The bright red color gives a bright warning of its heat!

SPECIFICATION
• Voltage:19V
• Power:38W
• Wire length:1.6m 62.99
• head diameter:5.8mm-6mm 0.23"-0.24"
• Head lenght:25mm 0.98"

Powered By DFRobot 2008-2017

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived FIT0282 Datasheet file may be downloaded here without warranties.

Datasheet ID: FIT0282 508891