HCPL-3100

HCPL-3100 Datasheet

HCPL-3100, HCPL-3101 Power MOSFET/IGBT Gate Drive Optocouplers

Part	Datasheet
HCPL-3100	HCPL-3100 (pdf)

Related Parts	Information
HCPL-3100-000E	HCPL-3100-000E
HCPL-3101	HCPL-3101
HCPL-3100-300E	HCPL-3100-300E
HCPL-3100-500E	HCPL-3100-500E
HCPL-3101-500E	HCPL-3101-500E
HCPL-3101-000E	HCPL-3101-000E
HCPL-3101-300E	HCPL-3101-300E

PDF Datasheet Preview
HCPL-3100, HCPL-3101 Power MOSFET/IGBT Gate Drive Optocouplers Data Sheet The HCPL-3100/3101 consists of an LED* optically coupled to an integrated circuit with a power output stage. These optocouplers are suited for driving power MOSFETs and IGBTs used in motor control inverter applications. The high operating voltage range of the output stage provides the voltage drives required by gate controlled devices. The voltage and current supplied by these optocouplers allow for direct interfacing to the power device without the need for an intermediate amplifier stage. The HCPL-3100 switches a 3000 pF load in 2 µs and the HCPL-3101, using a higher speed LED, switches a 3000 pF load in µs. With a CMR rating of 15 kV/µs typical these opto-couplers readily reject transients found in inverter applications. The LED controls the state of the output stage. Transistor Q2 in the output stage is on with the LED off, allowing the gate of the power device to be held low. Turning on the LED turns off transistor Q2 and switches on transistor Q1 in the output stage which provides current and voltage to drive the gate of the power device. • High output current IO1 and IO2 A Peak, A continuous • 15 kV/µs minimum Common Mode Rejection CMR at VCM = 1500 V • Wide operating VCC range 15 to 30 volts • High speed 1 µs typical propagation delay HCPL-3100 µs typical propagation delay HCPL-3101 • Recognized under UL 1577 for dielectric withstand proof test voltages of 5000 vac, 1 minute • Isolated MOSFET/IGBT gate drive • AC and DC motor drives • General purpose industrial inverters • Uninterruptable power supply Functional Diagram ANODE 1 HCPL-3100 8 VCC HCPL-3101 8 VCC CATHODE 2 3 4 7 GND Q2 6 VO2 Q1 5 VO1 ANODE 2 CATHODE 3 7 GND Q2 6 VO2 Q1 5 VO1 TRUTH TABLE OUTPUT HIGH LEVEL LOW LEVEL Q1 Q2 ON OFF ON THE USE OF A µF BYPASS CAPACITOR CONNECTED BETWEEN PINS 8 AND 7 IS RECOMMENDED. ALSO CURRENT LIMITING RESISTOR IS RECOMMENDED SEE FIGURE 1, AND NOTE 2 AND NOTE *HCPL-3100 LED contains Silicon-doped GaAs and HCPL-3101 LED contains AlGaAs. CAUTION It is advised that normal static precautions be taken in handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD. Schematic 1 ANODE CATHODE HCPL-3100 6 VO2 IO1 V O1 THE USE OF A µF BYPASS CAPACITOR CONNECTED BETWEEN PINS 8 AND 7 IS RECOMMENDED. ALSO CURRENT LIMITING RESISTOR IS RECOMMENDED SEE FIGURE 1, AND NOTE 2 AND NOTE 2 ANODE Ordering Information HCPL-3100 and HCPL-3101 are UL Recognized with 5000 Vrms for 1 minute per UL1577. HCPL-3100 HCPL-3101 Option RoHS Compliant -000E -300E -500E Package 300 mil DIP-8 Surface Mount Gull Wing Tape & Reel Quantity 50 per tube 50 per tube 1000 per reel To order, choose a part number from the part number column and combine with the desired option from the option column to form an order entry. Example 1 HCPL-3100-500E to order product of 300 mil DIP Gull Wing Surface Mount package in Tape and Reel packaging and RoHS compliant. Example 2 HCPL-3101-000E to order product of 300 mil DIP package in Tube packaging and RoHS compliant. Option datasheets are available. Contact your Avago sales representative or authorized distributor for information. Remarks The notation ‘#XXX’ is used for existing products, while new products launched since July 15, 2001 and RoHS compliant will use Outline Drawing TYPE NUMBER DATE CODE A XXXX YYWW 0° 13° 0° 13° TYP. ANODE 1 CATHODE 2 HCPL-3100 8 VCC 7 GND Q2 6 VO2 Q1 5 VO1 1 ANODE 2 CATHODE 3 HCPL-3101 8 VCC 7 GND Q2 6 VO2 Q1 5 VO1 Demonstrated ESD Performance Human Body Model MIL-STD883 Method Class 2 Machine Model EIAJ IC-1211988 Version 2 , Test Method 20, Condition C 1200 V Regulatory Information The HCPL-3100/3101 has been approved by the following organization:

PDF Datasheet Preview

HCPL-3100, HCPL-3101 Power MOSFET/IGBT Gate Drive Optocouplers

Data Sheet

The HCPL-3100/3101 consists of an LED* optically coupled to an integrated circuit with a power output stage. These optocouplers are suited for driving power MOSFETs and IGBTs used in motor control inverter applications. The high operating voltage range of the output stage provides the voltage drives required by gate controlled devices. The voltage and current supplied by these optocouplers allow for direct interfacing to the power device without the need for an intermediate amplifier stage.

The HCPL-3100 switches a 3000 pF load in 2 µs and the HCPL-3101, using a higher speed LED, switches a 3000 pF load in µs. With a CMR rating of 15 kV/µs typical these opto-couplers readily reject transients found in inverter applications.

The LED controls the state of the output stage. Transistor Q2 in the output stage is on with the LED off, allowing the gate of the power device to be held low. Turning on the LED turns off transistor Q2 and switches on transistor Q1 in the output stage which provides current and voltage to drive the gate of the power device.
• High output current IO1 and IO2 A Peak, A continuous
• 15 kV/µs minimum Common Mode Rejection CMR at VCM = 1500 V
• Wide operating VCC range 15 to 30 volts
• High speed
1 µs typical propagation delay HCPL-3100 µs typical propagation delay HCPL-3101
• Recognized under UL 1577 for dielectric withstand proof test voltages of 5000 vac, 1 minute
• Isolated MOSFET/IGBT gate drive
• AC and DC motor drives
• General purpose industrial inverters
• Uninterruptable power supply

Functional Diagram

ANODE 1

HCPL-3100
8 VCC

HCPL-3101
8 VCC

CATHODE 2 3 4
7 GND Q2
6 VO2 Q1
5 VO1

ANODE 2 CATHODE 3
7 GND Q2
6 VO2 Q1
5 VO1

TRUTH TABLE

OUTPUT

HIGH LEVEL

LOW LEVEL

Q1 Q2 ON OFF ON

THE USE OF A µF BYPASS CAPACITOR CONNECTED BETWEEN PINS 8 AND 7 IS RECOMMENDED. ALSO CURRENT LIMITING RESISTOR IS RECOMMENDED SEE FIGURE 1, AND NOTE 2 AND NOTE
*HCPL-3100 LED contains Silicon-doped GaAs and HCPL-3101 LED contains AlGaAs.

CAUTION It is advised that normal static precautions be taken in handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD.

Schematic
1 ANODE

CATHODE

HCPL-3100
6 VO2

IO1 V O1

THE USE OF A µF BYPASS CAPACITOR CONNECTED BETWEEN PINS 8 AND 7 IS RECOMMENDED. ALSO CURRENT LIMITING RESISTOR IS RECOMMENDED SEE FIGURE 1, AND NOTE 2 AND NOTE
2 ANODE
Ordering Information

HCPL-3100 and HCPL-3101 are UL Recognized with 5000 Vrms for 1 minute per UL1577.

HCPL-3100

HCPL-3101

Option

RoHS Compliant -000E -300E -500E

Package 300 mil DIP-8

Surface Mount

Gull Wing

Tape & Reel

Quantity 50 per tube 50 per tube 1000 per reel

To order, choose a part number from the part number column and combine with the desired option from the option column to form an order entry.

Example 1 HCPL-3100-500E to order product of 300 mil DIP Gull Wing Surface Mount package in Tape and Reel packaging and RoHS compliant.

Example 2 HCPL-3101-000E to order product of 300 mil DIP package in Tube packaging and RoHS compliant.

Option datasheets are available. Contact your Avago sales representative or authorized distributor for information.

Remarks The notation ‘#XXX’ is used for existing products, while new products launched since July 15, 2001 and RoHS compliant will use

Outline Drawing

TYPE NUMBER

DATE CODE

A XXXX YYWW
0° 13°
0° 13°

TYP.

ANODE 1

CATHODE 2

HCPL-3100
8 VCC
7 GND Q2
6 VO2 Q1
5 VO1
1 ANODE 2 CATHODE 3

HCPL-3101
8 VCC
7 GND Q2
6 VO2 Q1
5 VO1

Demonstrated ESD Performance

Human Body Model MIL-STD883 Method Class 2

Machine Model EIAJ IC-1211988 Version 2 , Test Method 20, Condition C 1200 V

Regulatory Information

The HCPL-3100/3101 has been approved by the following organization:

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived HCPL-3100 Datasheet file may be downloaded here without warranties.

Datasheet ID: HCPL-3100 520251