ADNK-5023-CY02

ADNK-5023-CY02 Datasheet

ADNK-5023-CY02 Optical Mouse Designer’s Kit

Part	Datasheet
ADNK-5023-CY02	ADNK-5023-CY02 (pdf)

PDF Datasheet Preview
ADNK-5023-CY02 Optical Mouse Designer’s Kit Product Overview Avago Technologies has produced a new optical mouse reference design kit. Based on the new Avago Technologies ADNS-5020-EN small form factor optical mouse sensor and the powerful Cypress CY7C63743 USB microcontroller, this reference design kit provides a low cost and yet, feature-rich solution in one neat package. The Avago Technologies ADNS-5020-EN optical mouse sensor, an 8-pin staggered dual inline package DIP , is based on an optimized architecture with good navigation performance. It is able to measure changes in position by optically acquiring sequential surface images with auto frame rate feature and mathematically determining the direction and magnitude of movement. The ADNS-5020-EN along with the ADNS-5100 lens, ADNS-5200 clip and HLMP-ED80-XX000 form a complete, compact optical mouse tracking system. There are no mechanical parts, which means high reliability and less maintenance for the end user. In addition, precision optical alignment is not required, facilitating high volume assembly. The sensor is programmed via registers through a three-wire serial port. • Complete optical mouse reference design kit • ADNS-5020-EN small form factor optical mouse sensor • Optimized architecture for simpler circuitry and minimal number of passive components • No mechanical moving parts for easy maintenance and high reliability • SmartSpeed self-adjusting frame rate for optimum performance • Serial port burst mode for fast data transfer • 500 or 1000 cpi selectable resolution • Single volt power supply • Three-wire serial port along with reset NRESET pin • Cypress CY7C63743 USB controller • USB or PS/2 interface for PC connection • Proprietary 8-bit RISC processor, USB and PS/2- optimized interface for high system performance • 8K Bytes of internal EPROM provided to enable easy customization of firmware and lower cost • Conforms to USB suspend mode specifications VBUS 1 GND 2 POWER SW2 middle SW1 right left Vcc 5 P1.0 20 P1.1 19 P1.2 8 P1.3 P0.7 21 P0.6 22 P0.5 P0.4 24 17 P1.6 P1.7 Cypress CY7C63743 P0.2 15 D+/SCLK D-/SDAT R13 1.30K P0.3 4 P1.4 7 P1.5 18 13 XOUT 11 VREG 12 XIN/P2.1 P0.0 1 P0.1 2 VPP 10 GND R4 27K D1 HLMP-ED80 1 SCLK SDIO GND 6 C3 C4 ADNS-5020-EN REG0 7 NRESET Ordering Information For ordering information, please contact your local Avago Technologies sales representative. 800 235-0312, visit the website at For product information and a complete list of distributors, please go to our web site: Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies, Pte. in the United States and other countries. Data subject to change. Copyright 2006 Avago Technologies Pte. All rights reserved. AV01-0368EN - August 2, 2006

PDF Datasheet Preview

ADNK-5023-CY02 Optical Mouse Designer’s Kit

Product Overview

Avago Technologies has produced a new optical mouse reference design kit. Based on the new Avago Technologies ADNS-5020-EN small form factor optical mouse sensor and the powerful Cypress CY7C63743 USB microcontroller, this reference design kit provides a low cost and yet, feature-rich solution in one neat package.

The Avago Technologies ADNS-5020-EN optical mouse sensor, an 8-pin staggered dual inline package DIP , is based on an optimized architecture with good navigation performance. It is able to measure changes in position by optically acquiring sequential surface images with auto frame rate feature and mathematically determining the direction and magnitude of movement.

The ADNS-5020-EN along with the ADNS-5100 lens, ADNS-5200 clip and HLMP-ED80-XX000 form a complete, compact optical mouse tracking system. There are no mechanical parts, which means high reliability and less maintenance for the end user. In addition, precision optical alignment is not required, facilitating high volume assembly. The sensor is programmed via registers through a three-wire serial port.
• Complete optical mouse reference design kit
• ADNS-5020-EN small form factor optical mouse
sensor
• Optimized architecture for simpler circuitry and minimal number of passive components
• No mechanical moving parts for easy maintenance and high reliability
• SmartSpeed self-adjusting frame rate for optimum performance
• Serial port burst mode for fast data transfer
• 500 or 1000 cpi selectable resolution
• Single volt power supply
• Three-wire serial port along with reset NRESET pin
• Cypress CY7C63743 USB controller
• USB or PS/2 interface for PC connection
• Proprietary 8-bit RISC processor, USB and PS/2-
optimized interface for high system performance
• 8K Bytes of internal EPROM provided to enable easy customization of firmware and lower cost
• Conforms to USB suspend mode specifications

VBUS 1

GND 2

POWER

SW2 middle

SW1 right
left Vcc
5 P1.0 20 P1.1
19 P1.2 8 P1.3

P0.7 21 P0.6 22

P0.5 P0.4 24
17 P1.6 P1.7

Cypress

CY7C63743 P0.2
15 D+/SCLK D-/SDAT

R13 1.30K

P0.3 4

P1.4 7 P1.5 18
13 XOUT 11 VREG 12 XIN/P2.1

P0.0 1 P0.1 2 VPP 10 GND

R4 27K

D1 HLMP-ED80
1 SCLK SDIO

GND 6

C3 C4

ADNS-5020-EN

REG0 7

NRESET
Ordering Information
For ordering information, please contact your local Avago Technologies sales representative. 800 235-0312, visit the website at

For product information and a complete list of distributors, please go to our web site:

Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies, Pte. in the United States and other countries. Data subject to change. Copyright 2006 Avago Technologies Pte. All rights reserved. AV01-0368EN - August 2, 2006

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived ADNK-5023-CY02 Datasheet file may be downloaded here without warranties.

Datasheet ID: ADNK-5023-CY02 519945