SA12

SA12 Datasheet


The SA12 is a pulse width modulation amplifier that can supply 3000W to the load. An internal 400kHz oscillator requires no external components. The clock input stage divides the oscillator frequency by two, which provides the 200 kHz switching frequency. External oscillators may also be used to lower the switching frequency or to synchronize multiple amplifiers. Current sensing is provided for each half of the H-bridge giving amplitude and direction data. A shutdown input turns off all four drivers of the H-bridge output. A high side current limit and the programmable low side current limit protect the amplifier from shorts to supply or ground in addition to load shorts. The H-bridge output MOSFETs are protected from thermal overloads by directly sensing the temperature of the die. The 12-pin hermetic MO-127 power package occupies

Part Datasheet
SA12 SA12 SA12 (pdf)
PDF Datasheet Preview
P r o d u Sc tAIInn1nn2oovvaa t i o n FFrroomm

Pulse Width Modulation Amplifiers

SAS1A122
• HIGH FREQUENCY SWITCHING 200 kHz
• WIDE SUPPLY
• 15A CONTINUOUS TO 65°C case
• 3 PROTECTION CIRCUITS
• ANALOG OR DIGITAL INPUTS
• SYNCHRONIZED OR EXTERNAL OSCILLATOR
• FLEXIBLE FREQUENCY CONTROL
• REACTIVE LOADS
• LOW FREQUENCY SONAR
• LARGE PIEZO ELEMENTS
• OFF-LINE DRIVERS
• C-D WELD CONTROLLER
12-pin Power DIP PACKAGE STYLE CR EXTERNAL CONNECTIONS

The SA12 is a pulse width modulation amplifier that can supply 3000W to the load. An internal 400kHz oscillator requires no external components. The clock input stage divides the oscillator frequency by two, which provides the 200 kHz switching frequency. External oscillators may also be used to lower the switching frequency or to synchronize multiple amplifiers. Current sensing is provided for each half of the H-bridge giving amplitude and direction data. A shutdown input turns off all four drivers of the H-bridge output. A high side current limit and the programmable low side current limit protect the amplifier from shorts to supply or ground in addition to load shorts. The H-bridge output MOSFETs are protected from thermal overloads by directly sensing the temperature of the die. The 12-pin hermetic MO-127 power package occupies
only 3 square inches of board space.

BLOCK DIAGRAM AND TYPICAL APPLICATION TORQUE MOTOR DRIVER

Vcc 10
+PWM 3
100pF 28K

CLK OUT

CONTROL SIGNAL

CLK IN 1 GND 5

CLK IN CLK OUT
+PWM
-PWM/RAMP

GND ILIM/SHDN

TOP 10
4 VIEW 9

ISENSE A OUT
* VCC * +VS

B OUT I SENSE B

Case tied to pin Allow no current in case. Bypassing of supplies is required. Package is Apex MO-127 STD . See Outline Dimensions/Packages in Apex data book.
*See text. As +PWM goes more positive, A OUT duty cycle increases.

CURRENT LIMIT PWM

OUTPUT DRIVERS

SHUTDOWN CONTROL
9 +VS

B OUT 8

A OUT 11

MOTOR

I SENSE A 12

ILIM/SHDN 6
7 I SENSE B
5K .01uF

RSENSE 1K

RSENSE

Copyright Cirrus Logic, Inc. 2009 All Rights Reserved
More datasheets: 3688 | 702 | HSCH-5330 | HSCH-5340 | HSCH-5332 | HSCH-5312 | HSCH-5331 | HSCH-5314 | HSCH-5310 | A000103


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived SA12 Datasheet file may be downloaded here without warranties.

Datasheet ID: SA12 523249