HMC216MS8E
HMC216MS8E Datasheet
HMC216MS8 / 216MS8E
| Part | Datasheet |
|---|---|
HMC216MS8E |
HMC216MS8E (pdf) |
| PDF Datasheet Preview |
|---|
| MIXERS - SINGLE & DOUBLE-BALANCED - SMT OBSOLETE PRODUCT HMC216MS8 / 216MS8E v02.0705 GaAs MMIC SMT DOUBLE-BALANCED FET MIXER, - GHz The HMC216MS8 / HMC216MS8E is ideal for • Base Stations • WirelessLAN • PCMCIA • Portable Wireless Input IP3 +25 dBm +11 dBm LO Range = +3 to +11 dBm Conversion Loss dB LO / RF Isolation 32 dB Functional Diagram The HMC216MS8 & HMC216MS8E are ultra miniature double-balanced FET mixers in 8 lead plastic surface mount packages MSOP . This MMIC mixer is constructed of switched GaAs FETs and novel planar transformer baluns on the chip. In addition to an LO drive of +3 to +13 dBm, a gate voltage of Vgg = to Vdc is required. The device can be used as an upconverter or downconverter for 1900 or 2400 MHz applications. The consistent MMIC performance will improve system operation and assure regulatory compliance. Electrical Specifications, TA = +25° C, As a Function of LO Drive, Vgg = Vdc Parameter Frequency Range, RF & LO Frequency Range, IF Conversion Loss Noise Figure SSB LO to RF Isolation LO to IF Isolation LO = +11 dBm Min. Typ. Max. LO = +7 dBm Min. Typ. Max. LO = +3 dBm Min. Typ. Max. IP3 Input 1 dB Gain Compression Input Units GHz dB dBm For price, delivery and to place orders Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824 Phone 978-250-3343 Fax 978-250-3373 Order On-line at Application Support Phone 978-250-3343 or MIXERS - SINGLE & DOUBLE-BALANCED - SMT v02.0705 OBSOLETE PRODUCT HMC216MS8 / 216MS8E GaAs MMIC SMT DOUBLE-BALANCED FET MIXER, - GHz Conversion Loss vs Temperature LO = +7 dBm CONVERSION LOSS dB -40 C +25 C +85 C [1] Reference this number when ordering complete evaluation PCB [2] Circuit Board Material Rogers 4350 The circuit board used in the application should use RF circuit design techniques. Signal lines should have 50 Ohm impedance while the package ground leads should be connected directly to the ground plane similar to that shown. A sufficient number of via holes should be used to connect the top and bottom ground planes. The evaluation circuit board shown is available from Hittite upon request. For price, delivery and to place orders Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824 Phone 978-250-3343 Fax 978-250-3373 Order On-line at Application Support Phone 978-250-3343 or |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived HMC216MS8E Datasheet file may be downloaded here without warranties.