107484-002

107484-002 Datasheet

QP-104 HAND PRESS PART NUMBER 107484-002

Part	Datasheet
107484-002	107484-002 (pdf)

PDF Datasheet Preview
QP-104 HAND PRESS PART NUMBER 107484-002 FCI MANUAL P/N 162046-001 QP-104 HAND PRESS Table of Contents INTRODUCTION General INSTALLATION 4 4 Service Parts REFERENCE DRAWINGS EPL 107484 Quickie Hand Press Quickie Hand Press Model #103 Quickie Hand Press Setup QP-104 Fixtures REFERENCE DOCUMENTS FORM #E-3245 - -Customer Application Machine Warranty and Service Policy “Section I” Equipment owned by FCI Electronics. FORM #E-3244 - -Customer Application Machine Warranty and Service Policy “Section II” Equipment purchased by the customer. FORM # E-3247- - FCI Electronics Address List Introduction General Description • The QP-104 press is a hand-operated press. The use of a toggle linkage is utilized to produce the force needed to do crimping. Installation Receiving • Upon arrival, remove the QP-104 hand press from the shipping crate, and inspect immediately for shipping damage. Report any damage to a FCI USA representative, and file a damage claim with the carrier. Set-up • The QP-104 should be securely mounted to an adequate work bench top with ¼ inch bolts, washers, and nuts. Service Service • Once a month, the bearings, toggle joints and ram shaft should be lubricated with 20w oil. • WHAT TO DO IF YOU NEED SERVICE: In the event service or technical help is needed FCI USA provides a toll free number. For service or technical help call Parts Replacement • PARTS REPLACEMENT When calling for spare parts, have part number s ready for the customer service person. Number s can be obtained from the reference drawings located in the back of this manual. Spare part orders call 1-800-222-2194 and ask for CUSTOMER SERVICE.

PDF Datasheet Preview

QP-104 HAND PRESS PART NUMBER 107484-002

FCI MANUAL P/N 162046-001

QP-104 HAND PRESS

Table of Contents

INTRODUCTION General

INSTALLATION 4
4 Service Parts

REFERENCE DRAWINGS EPL 107484 Quickie Hand Press Quickie Hand Press Model #103 Quickie Hand Press Setup QP-104 Fixtures

REFERENCE DOCUMENTS FORM #E-3245 - -Customer Application Machine Warranty and Service Policy “Section I” Equipment owned by FCI Electronics.

FORM #E-3244 - -Customer Application Machine Warranty and Service Policy “Section II” Equipment purchased by the customer.

FORM # E-3247- - FCI Electronics Address List

Introduction

General Description
• The QP-104 press is a hand-operated press. The use of a toggle linkage is utilized to produce the force needed to do crimping.

Installation

Receiving
• Upon arrival, remove the QP-104 hand press from the shipping crate, and inspect immediately for
shipping damage. Report any damage to a FCI USA representative, and file a damage claim with the carrier.

Set-up
• The QP-104 should be securely mounted to an adequate work bench top with ¼ inch bolts, washers,
and nuts.

Service

Service
• Once a month, the bearings, toggle joints and ram shaft should be lubricated with 20w oil.
• WHAT TO DO IF YOU NEED SERVICE:

In the event service or technical help is needed FCI USA provides a toll free number. For service or technical help call

Parts Replacement
• PARTS REPLACEMENT When calling for spare parts, have part number s ready for the customer service person. Number s can be obtained from the reference drawings located in the back of this manual. Spare part orders call 1-800-222-2194 and ask for CUSTOMER SERVICE.

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 107484-002 Datasheet file may be downloaded here without warranties.

Datasheet ID: 107484-002 634934