63811-0800

63811-0800 Datasheet

Specification Sheet Order No. 63811-0800

Part	Datasheet
63811-0800	63811-0800 (pdf)

PDF Datasheet Preview
Hand Crimp Tool for 2.00mm Pitch MicroBlade Wire-to-Wire Crimp Terminal HAND CRIMP TOOL Operating Instruction and Specification Sheet Order No. 63811-0800 Small handle spread which make this style tool ideally suited for end users Ratchet with safety release that ensures consistent performance A precision user-friendly terminal locator wire stop holds terminals in the proper crimping position SCOPE Products 2.00mm Pitch MicroBlade Wire-to-Wire Crimp Terminals. Terminal Order No. Wire Size Insulation Diameter Strip Length Series No. Loose Piece Reel AWG 50011 50011-8100 50011-8000 39-00-0422 24 - 30 Customer to cut off terminal from reel 0.20mm maximum Cut-off Tab. DEFINITION OF TERMS BRUSH BELL MOUTH INSULATION CRIMP CONDUCTOR CRIMP BEND UP ROLLING STRIP LENGTH TWISTING BEND DOWN CRIMP HEIGHT The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No ATS-638110800 Release Date 09-20-95 UNCONTROLLED COPY Page 1 of 5 Hand Crimp Tool for 2.00mm Pitch MicroBlade Wire-to-Wire Crimp Terminal CONDITIONS: After crimping, the conductor profiles should measure the following see notes on page Wire Size Terminal Series No. 50011 24 26 28 30 Conductor Crimp Height Ref Punch Width Ref Pull Force Minimum Profile

PDF Datasheet Preview

Hand Crimp Tool for 2.00mm Pitch MicroBlade Wire-to-Wire Crimp Terminal

HAND CRIMP TOOL Operating Instruction and

Specification Sheet Order No. 63811-0800

Small handle spread which make this style tool ideally suited for end users Ratchet with safety release that ensures consistent performance A precision user-friendly terminal locator wire stop holds terminals in the proper crimping position

SCOPE

Products 2.00mm Pitch MicroBlade Wire-to-Wire Crimp Terminals.

Terminal Order No.

Wire Size Insulation Diameter Strip Length

Series No. Loose Piece

Reel AWG
50011
50011-8100
50011-8000 39-00-0422
24 - 30

Customer to cut off terminal from reel 0.20mm maximum Cut-off Tab.

DEFINITION OF TERMS

BRUSH

BELL MOUTH

INSULATION CRIMP

CONDUCTOR CRIMP

BEND UP ROLLING

STRIP LENGTH

TWISTING

BEND DOWN

CRIMP HEIGHT

The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope.

Doc No ATS-638110800 Release Date 09-20-95

UNCONTROLLED COPY

Page 1 of 5

Hand Crimp Tool for 2.00mm Pitch MicroBlade Wire-to-Wire Crimp Terminal

CONDITIONS:

After crimping, the conductor profiles should measure the following see notes on page

Wire Size Terminal

Series No.
50011
24 26 28 30

Conductor Crimp

Height Ref

Punch Width Ref

Pull Force Minimum

Profile

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 63811-0800 Datasheet file may be downloaded here without warranties.

Datasheet ID: 63811-0800 649668