63811-0400

63811-0400 Datasheet

63811-0400 Hand Crimp Tool for “Sabre” Flat Blade Female Terminals

Part	Datasheet
63811-0400	63811-0400 (pdf)

PDF Datasheet Preview
63811-0400 Hand Crimp Tool for “Sabre” Flat Blade Female Terminals HAND CRIMP TOOL SPECIFICATION SHEET Order No. 63811-0400 Small handle spread which make this style tool ideally suited for end users Ratchet with safety release that ensures consistent performance A precision user-friendly terminal locator wire stop holds terminals in the proper crimping position SCOPE Terminal Series No. 43374-0001 43375-0001 Wire Size AWG 14-18 14-18 Insulation Diameter Strip Length TYPE 2 DEFINITION OF TERMS BRUSH STRIP LENGTH BELL MOUTH INSULATION CRIMP SEAM BEND UP ROLLING CUT-OFF TAB BEND DOWN CONDUCTOR CRIMP COND.CRIMP HEIGHT TWISTING The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. UNCONTROLLED COPY Page 1 of 5 63811-0400 Hand Crimp Tool for “Sabre” Flat Blade Female Terminals CONDITIONS: After crimping, the conductor profiles should measure the following, see notes on page Terminal Wire Size Series No. AWG mm2 43374-0001 14 43374-0001 16 43374-0001 18 Cond. Crimp Height Ref Punch Width Ref Cond. Pull Force Min. Profile N Lb. A B 43375-0001 14 43375-0001 16 43375-0001 18 OPERATION Open the tool by squeezing the handles together, at the end of the closing stroke, the ratchet mechanism will release the handles and the hand tool will spring open. Crimping Terminals Figure 1

PDF Datasheet Preview

63811-0400 Hand Crimp Tool for “Sabre” Flat Blade Female Terminals

HAND CRIMP TOOL SPECIFICATION SHEET Order No. 63811-0400

Small handle spread which make this style tool ideally suited for end users Ratchet with safety release that ensures consistent performance A precision user-friendly terminal locator wire stop holds terminals in the proper crimping position

SCOPE

Terminal Series No.
43374-0001 43375-0001

Wire Size AWG 14-18 14-18

Insulation Diameter

Strip Length

TYPE 2

DEFINITION OF TERMS

BRUSH

STRIP LENGTH

BELL MOUTH

INSULATION CRIMP

SEAM

BEND UP

ROLLING

CUT-OFF TAB

BEND DOWN

CONDUCTOR CRIMP

COND.CRIMP HEIGHT

TWISTING

The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope.

UNCONTROLLED COPY

Page 1 of 5
63811-0400 Hand Crimp Tool for “Sabre” Flat Blade Female Terminals

CONDITIONS:

After crimping, the conductor profiles should measure the following, see notes on page

Terminal Wire Size Series No.

AWG mm2 43374-0001 14 43374-0001 16 43374-0001 18

Cond. Crimp Height Ref

Punch Width Ref

Cond.

Pull Force Min. Profile

N Lb. A B
43375-0001 14 43375-0001 16 43375-0001 18

OPERATION

Open the tool by squeezing the handles together, at the end of the closing stroke, the ratchet mechanism will release the handles and the hand tool will spring open.

Crimping Terminals

Figure 1

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 63811-0400 Datasheet file may be downloaded here without warranties.

Datasheet ID: 63811-0400 649665