MIKROE-2563

MIKROE-2563 Datasheet

PID MIKROE-2563

Part	Datasheet
MIKROE-2563	MIKROE-2563 (pdf)

PDF Datasheet Preview
Mic click PID MIKROE-2563 Mic click carries the surface mount silicon microphone with maximum RF protection. The click is designed to run on a 3.3V power supply. It communicates with the target microcontroller over the AN pin on the mikroBUS line. How it works Mic clicks contains a silicon microphone, which outputs the signal to the analog pin AN on the mikroBUS line via the op amp. SPQ0410HR5H-B features The SPQ0410HR5H-B is a miniature, high-performance, low power, top port silicon microphone. Using the SiSonic MEMS technology, the SPQ0410HR5H-B consists of an acoustic sensor, a low noise input buffer, and an output amplifier. MaxRF protection prevents RF noise in traces from getting into the mic output. Omnidirectional microphones SPQ0410HR5H-B is an omnidirectional microphone. As the name implies an omnidirectional microphone can hear equally in all directions. So whichever way you hold it, up or down, it will work the same. Key features • o Sensitivity dBV/Pa o Signal to noise ratio 59 dB A o Output impedance 400 Ω o Omnidirectional o MaxRF protection • Interface AN pin • 3.3V power supply Specification Product Type Microphone Processing audio with an MCU, mobile phones, smartphones, laptop computers, sensors, digital still cameras, portable music recorders, etc. SPQ0410HR5H-B Key Features Omnidirectional, MaxRF protection, Sensitivity -42 dBV/Pa Interface Analog Power Supply 3.3V Compatibility mikroBUS Click board size S x mm Pinout diagram This table shows how the pinout on Mic click corresponds to the pinout on the mikroBUS socket the latter shown in the two middle columns . Notes Pin Notes mikroBUStm Analog output pin AN 1 AN PWM 16 NC Not connected Not connected NC 2 RST INT 15 NC Not connected Not connected NC 3 CS TX 14 NC Not connected Not connected NC 4 SCK RX 13 NC Not connected Not connected NC 5 MISO SCL 12 NC Not connected Not connected NC 6 MOSI SDA 11 NC Not connected Power supply +3.3V 7 3.3V 5V 10 NC Not connected Ground GND 8 GND 9 GND Ground Programming Code examples for Mic click, written for MikroElektronika hardware and compilers are available on Libstock. Code snippet The following code snippet measures volume every 10 ms, and outputs measured data to a tft display. 01 void main

PDF Datasheet Preview

Mic click

PID MIKROE-2563

Mic click carries the surface mount silicon microphone with maximum RF protection. The click is designed to run on a 3.3V power supply. It communicates with the target microcontroller over the AN pin on the mikroBUS line.

How it works

Mic clicks contains a silicon microphone, which outputs the signal to the analog pin AN on the mikroBUS line via the op amp.

SPQ0410HR5H-B features

The SPQ0410HR5H-B is a miniature, high-performance, low power, top port silicon microphone. Using the SiSonic MEMS technology, the SPQ0410HR5H-B consists of an acoustic sensor, a low noise input buffer, and an output amplifier. MaxRF protection prevents RF noise in traces from getting into the mic output.

Omnidirectional microphones

SPQ0410HR5H-B is an omnidirectional microphone. As the name implies an omnidirectional microphone can hear equally in all directions. So whichever way you hold it, up or down, it will work the same.

Key features
• o Sensitivity dBV/Pa o Signal to noise ratio 59 dB A o Output impedance 400 Ω o Omnidirectional o MaxRF protection
• Interface AN pin
• 3.3V power supply

Specification

Product Type Microphone

Processing audio with an MCU, mobile phones, smartphones, laptop computers, sensors, digital still cameras, portable music recorders, etc.

SPQ0410HR5H-B

Key Features Omnidirectional, MaxRF protection, Sensitivity -42 dBV/Pa

Interface

Analog

Power Supply 3.3V

Compatibility mikroBUS

Click board size

S x mm

Pinout diagram

This table shows how the pinout on Mic click corresponds to the pinout on the mikroBUS socket the latter shown in the two middle columns .

Notes

Pin Notes
mikroBUStm

Analog output pin AN 1 AN PWM 16 NC Not connected

Not connected NC 2 RST INT 15 NC Not connected

Not connected NC 3 CS TX 14 NC Not connected

Not connected NC 4 SCK RX 13 NC Not connected

Not connected NC 5 MISO SCL 12 NC Not connected

Not connected NC 6 MOSI SDA 11 NC Not connected

Power supply +3.3V 7 3.3V 5V 10 NC Not connected

Ground GND 8 GND 9 GND Ground

Programming

Code examples for Mic click, written for MikroElektronika hardware and compilers are available on Libstock.

Code snippet

The following code snippet measures volume every 10 ms, and outputs measured data to a tft display.
01 void main

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived MIKROE-2563 Datasheet file may be downloaded here without warranties.

Datasheet ID: MIKROE-2563 649377