OPMODE & LIMIT set performance of receiver Must be reprogrammed upon power-up Programmed using one-wire protocol over DATA line
Part | Datasheet |
---|---|
![]() |
ATAKSTK511-3 (pdf) |
Related Parts | Information |
---|---|
![]() |
ATAKSTK511-8 |
![]() |
ATAKSTK511-9 |
PDF Datasheet Preview |
---|
STK511 Uni-Directional Radio Starter Kit y Introduction y Kit Contents y Receiver Application Board y Receiver Interface Board Stand-alone Operation with STK500 y Transmitter Application Board y System Setup General Setup Demo Setup Hardware Demo Setup Software Demo Receiver Configuration Demo Transmitter Configuration y Running the Demo y Conclusion STK511 18-Mrz-05 STK511 Introduction y UHF radio covers 315, 434, 868 and 915 MHz y Supports “intelligent” receiver ICs y Atmel reference design receiver uses in STK500 y Atmel reference design transmitter uses ATtiny13 Supports 8-pin TSSOP PLL transmitters ICs ASK or FSK transmission is pushbutton selectable y Receiver Interface Board Supports stand-alone receiver operation Quickly programs configuration registers OPMODE LIMIT Doubles as an expansion card for STK500 Enables quick prototype development Sample software for STK500 included 18-Mrz-05 STK511 Kit Contents y STK511 Receiver Interface Board IFB y RF Receiver Application Board RAB one of the following: T5743 MHz T5760 868 MHz T5761 915 MHz y RF Transmitter Application Board TAB one of the following: Tiny13 + T5750 868/915MHz Tiny13 + T5753 315MHz Tiny13 + T5754 433.92MHz y CD containing sample software and related documents y Antenna Transmitter uses integrated PCB trace Receiver uses external monopole whip 18-Mrz-05 STK511 Receiver Application Board y Registers part of Atmel receivers T5743/60/61 OPMODE & LIMIT set performance of receiver Must be reprogrammed upon power-up Programmed using one-wire protocol over DATA line y LED to indicate IC activity y Test points for viewing signal activity y Matching network for receive antenna 18-Mrz-05 STK511 Receiver Interface Board 18-Mrz-05 STK511 Stand-alone Operation y Change receiver’s settings without writing software DIP switches set configuration register values Embedded firmware ATmega8515 programs registers |
More datasheets: 700701201 | 702501201 | 707200201 | 299D01201 | 700303202 | 531300201 | 465200202 | 464900201 | ATAKSTK511-8 | ATAKSTK511-9 |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived ATAKSTK511-3 Datasheet file may be downloaded here without warranties.