AT17LV010A-10PI

AT17LV010A-10PI Datasheet


The AT17A series FPGA configuration EEPROMs Configurators provide an easy-touse, cost-effective configuration memory for Field Programmable Gate Arrays. The AT17A series device is packaged in the 8-lead PDIP 1 , 20-lead PLCC and 32-lead TQFP, see Table The AT17A series configurator uses a simple serial-access procedure to configure one or more FPGA devices. The user can select the polarity of the reset function by programming four EEPROM bytes.These devices also support a write-protection mechanism within its programming mode.

Part Datasheet
AT17LV010A-10PI AT17LV010A-10PI AT17LV010A-10PI (pdf)
Related Parts Information
AT17LV512A-10JI AT17LV512A-10JI AT17LV512A-10JI
AT17LV256A-10JC AT17LV256A-10JC AT17LV256A-10JC
AT17LV128A-10JC AT17LV128A-10JC AT17LV128A-10JC
AT17LV002A-10QI AT17LV002A-10QI AT17LV002A-10QI
AT17LV512A-10PI AT17LV512A-10PI AT17LV512A-10PI
AT17LV002A-10JI AT17LV002A-10JI AT17LV002A-10JI
AT17LV010A-10JI AT17LV010A-10JI AT17LV010A-10JI
AT17LV512A-10PC AT17LV512A-10PC AT17LV512A-10PC
AT17LV010A-10JC AT17LV010A-10JC AT17LV010A-10JC
AT17LV002A-10QC AT17LV002A-10QC AT17LV002A-10QC
AT17LV040A-10BJI AT17LV040A-10BJI AT17LV040A-10BJI
AT17LV040A-10BJC AT17LV040A-10BJC AT17LV040A-10BJC
AT17LV010A-10QI AT17LV010A-10QI AT17LV010A-10QI
AT17LV010A-10QC AT17LV010A-10QC AT17LV010A-10QC
AT17LV010A-10PC AT17LV010A-10PC AT17LV010A-10PC
AT17LV512A-10JC AT17LV512A-10JC AT17LV512A-10JC
AT17LV002A-10JC AT17LV002A-10JC AT17LV002A-10JC
AT17LV65A-10JI AT17LV65A-10JI AT17LV65A-10JI
AT17LV65A-10JC AT17LV65A-10JC AT17LV65A-10JC
AT17LV256A-10JI AT17LV256A-10JI AT17LV256A-10JI
AT17LV002A-10CU AT17LV002A-10CU AT17LV002A-10CU
PDF Datasheet Preview
• EE Programmable 65,536 x 1-, 131,072 x 1-, 262,144 x 1-, 524,288 x 1-, 1,048,576 x 1- and
2,097,152 x 1-bit Serial Memories Designed to Store Configuration Programs for Altera and APEX FPGAs Device Selection Guide Included
• Available as a 3.3V ±10% and 5.0V ±5% Commercial, ±10% Industrial Version
• In-System Programmable ISP via 2-wire Bus
• Simple Interface to SRAM FPGAs
• Compatible with Atmel AT6000, AT40K and AT94K Devices, Altera APEX Devices, Lucent FPGAs, Xilinx XC3000 , XC4000 , XC5200 ,

FPGAs, Motorola MPA1000 FPGAs
• Cascadable Read-back to Support Additional Configurations or Higher-density Arrays
• Very Low-power CMOS EEPROM Process
• Programmable Reset Polarity
• Available 8-lead PDIP, 20-lead PLCC and 32-lead TQFP Packages Pin Compatible

Across Product Family
• Emulation of Atmel’s AT24CXXX Serial EEPROMs
• Low-power Standby Mode
• High-reliability

Endurance 100,000 Write Cycles Data Retention 90 Years for Industrial Parts at 85°C and 190 Years for

Commercial Parts at 70°C

The AT17A series FPGA configuration EEPROMs Configurators provide an easy-touse, cost-effective configuration memory for Field Programmable Gate Arrays. The AT17A series device is packaged in the 8-lead PDIP 1 , 20-lead PLCC and 32-lead TQFP, see Table The AT17A series configurator uses a simple serial-access procedure to configure one or more FPGA devices. The user can select the polarity of the reset function by programming four EEPROM bytes.These devices also support a write-protection mechanism within its programming mode.

Note:

The 8-lead LAP, PDIP and SOIC packages for the AT17LV65A/128A/256A do not have an A label. However, the 8-lead packages are pin compatible with the 8-lead package of Altera’s EEPROMs, refer to the AT17LV65/128/256/512/010/002/040 datasheet available on the Atmel web site for more information.

The AT17A series configurators can be programmed with industry-standard programmers, Atmel’s ATDH2200E Programming Kit or Atmel’s ATDH2225 ISP Cable.

Table AT17A Series Packages

Package

AT17LV65A/ AT17LV128A/ AT17LV256A

AT17LV512A
8-lead PDIP
20-lead PLCC
32-lead TQFP

AT17LV010A Yes

AT17LV002A

FPGA Configuration EEPROM Memory

AT17LV65A AT17LV128A AT17LV256A AT17LV512A AT17LV010A AT17LV002A
3.3V and 5V System Support

Pin Configuration
8-lead PDIP

DATA 1 DCLK 2 WP 1 RESET/OE 3
nCS 4
8 VCC 7 SER_EN 6 A2 nCASC 5 GND
20-lead PLCC
3 NC 2 DATA 1 NC 20 VCC 19 NC

DCLK 4 WP1 2 5

NC 7 WP 1 RESET/OE 8
18 SER_EN 17 NC 16 NC 15 NC READY 2 14 NC
nCS 9 GND 10

NC 11 A2 nCASC 12

NC 13
32-lead TQFP
32 NC 31 DATA 30 NC 29 NC 28 NC 27 VCC 26 NC 25 NC

NC 1 DCLK 2

NC 3 WP1 3 NC 4

NC 5 NC 6 RESET/OE 7 NC 8
24 NC 23 SER_EN 22 NC 21 NC 20 READY 19 NC 18 NC 17 NC
Figure Ordering Code 1

AT17LV65A-10PC

Voltage 3.3V Nominal to 5V Nominal

Size Bits 65 = 65K 128 = 128K 256 = 256K 512 = 512K 010 = 1M 002 = 2M

Special Pinouts

A = Altera

Blank = Xilinx/Atmel/ Other

Package P = 8P3 J = 20J A = 32A

Temperature C = Commercial I = Industrial

Note:

The 8-lead LAP and SOIC packages for the AT17LV65A/128A/256A do not have an A label. However, the 8-lead packages are pin compatible with the 8-lead package of Altera’s EEPROMs, refer to the AT17LV65/128/256/512/010/002/040 datasheet available on the Atmel web site for more information.

Package Type
8-lead, Wide, Plastic Dual Inline Package PDIP
20-lead, Plastic J-leaded Chip Carrier PLCC
32-lead, Thin mm Plastic Quad Flat Package Carrier TQFP
14 AT17LV65A/128A/256A/512A/002A

AT17LV65A/128A/256A/512A/002A
Ordering Information 1

Memory Size 64-Kbit 2 7
Ordering Code AT17LV65A-10JC

Package 20J

Operation Range Commercial 0°C to 70°C
128-Kbit 7

AT17LV65A-10JI AT17LV128A-10JC

Industrial
-40°C to 85°C

Commercial
0°C to 70°C
256-Kbit 3 7

AT17LV128A-10JI AT17LV256A-10JC

Industrial
-40°C to 85°C

Commercial
0°C to 70°C
512-Kbit 4 7

AT17LV256A-10JI

AT17LV512A-10PC AT17LV512A-10JC

Industrial
-40°C to 85°C

Commercial
0°C to 70°C
1-Mbit 5 7

AT17LV512A-10PI AT17LV512A-10JI

AT17LV010A-10PC AT17LV010A-10JC AT17LV010A-10QC

Industrial
-40°C to 85°C

Commercial
0°C to 70°C
2-Mbit 6 7

AT17LV010A-10PI AT17LV010A-10JI AT17LV010A-10QI

AT17LV002A-10JC AT17LV002A-10QC

Industrial
-40°C to 85°C

Commercial
0°C to 70°C

AT17LV002A-10JI AT17LV002A-10QI

Industrial
-40°C to 85°C

Currently, there are two types of low-density configurators. The new version will be identified by a “B” after the datacode. The “B” version is fully backward-compatible with the original devices so existing customers will not be affected. The new parts no longer require a MUX for ISP. See programming specification for more details.

Use 64-Kbit density parts to replace Altera EPC1064. Use 256-Kbit density parts to replace Altera EPC1213. Use 512-Kbit density parts to replace Altera EPC1441. Use 1-Mbit density parts to replace Altera EPC1 Use 2-Mbit density parts to replace Altera EPC2. Atmel AT17LV002A devices do not support JTAG programming Atmel
More datasheets: AT17LV512A-10PI | AT17LV002A-10JI | AT17LV010A-10JI | AT17LV512A-10PC | AT17LV010A-10JC | AT17LV002A-10QC | AT17LV040A-10BJI | AT17LV040A-10BJC | AT17LV010A-10QI | AT17LV010A-10QC


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived AT17LV010A-10PI Datasheet file may be downloaded here without warranties.

Datasheet ID: AT17LV010A-10PI 518867