M09000-14
Part | Datasheet |
---|---|
![]() |
M09000G-14 (pdf) |
PDF Datasheet Preview |
---|
M09000-14 LED Driver and PMIC for DLP/LCOS Pico Projectors • Three programmable 1.2A common anode LED/laser drivers with integrated buck-boost converter and PWM current control • V and V Buck converters capable of 300 mA current loads • V 30 mA and V 150 mA LDO regulators • Accurate DMD supply generators +16 V/8.5 V and -10 V • Monitor and fault protection features • I2C interface • Portable video projector systems The M09000 is a highly integrated, high efficiency driver and power management IC designed for embedded DLP pico projectors. It provides three programmable LED/laser drivers with integrated buck-boost converter, power management functionalities, including high voltage generators for DMD. All of these functions are supported while operating from a single Li-Ion cell. Block Diagram LBOOSTN 1.5k opt C=1uF VHIGH LBOOSTP V18 16V VMID VNEG 8.5V -10V C=1uF PVDD 8.5V HV LDO 16V HV LDO Vxbuck1 Lbuck1 PVDD1 Lbuck2 Vxbuck2 VLDO2 VLDO1 PVDD2 1.0/1.1/1.2V Buck control 1.8V Buck control 3.3V LDO 2.5V LDO SIMO control M09000 References Buck-boost control Temp sensor 10bit A/D Internal oscillator LED Alarm LED driver IOUT2 [9 0] LED driver IOUT1[9:0] LED driver IOUT0[9:0] Control registers LI L4 LO PVOUT EMU_RST PWM/I2_ON SEL 0/I0_ON SEL1/I1_ON MP_EN Ordering Information Package M09000-14 5x5 mm 40-pin QFN * The letter “G” designator after the part number indicates that the device is RoHS compliant. Case Operating Temperature -40 °C to +85 °C Level V2 D V1 Release C V1P B V2A Preliminary Advance A V1A Advance July 2015 December 2012 July 2012 March 2012 February 2012 Updated registers. Silicon updated to version Changed typical LED Driver current accuracy in Table Changed typical Undervoltage Lockout in Table Changed ADC Offset Error, Slope Error and Full Scale in Table Changed LDO operating voltage in Table 1-7 and Table Changed Vih specification in Table Updated register section. Changed the Operating Voltage from a minimum of to and a maximum of to This change is reflected in Table 1-2, Table 1-7, Table 1-8 and Table Changed Pin 11 from GND to PVDDM VDD Supply . This is reflected in Figure 2-1 and Table Initial release. M/A-COM Technology Solutions Inc. MACOM and its affiliates reserve the right to make changes to the product s or information contained herein without notice. Visit for additional data sheets and product information. For further information and support please visit: M09000-14 LED Driver and PMIC for DLP/LCOS Pico Projectors Application Drawing M/A-COM Technology Solutions Inc. MACOM and its affiliates reserve the right to make changes to the product s or information contained herein without notice. Visit for additional data sheets and product information. For further information and support please visit: M09000-14 LED Driver and PMIC for DLP/LCOS Pico Projectors Table of Contents Absolute Maximum Ratings Operating Conditions. LED Driver Characteristics. Buck-Boost DC-DC Converter Monitor ADC Specifications. DMD Power V LDO Regulator VLDO2 . V LDO Regulator VLDO1 . Buck Regulators VXBUCK1/2 Internal Temperature Sensor CMOS Pin Characteristics I2C Timing Specifications1,2. Pin Descriptions and Package Outline Drawings. 14 Pin Descriptions Package Information Functional Description 18 User Configurable Registers LED Drivers Buck-boost Converter PMIC Functions DMD Supply LCOS Applications - Other Uses for the DMD Supply 24 Low Dropout Regulators Buck Regulators Monitor ADC FAIL Pin. M/A-COM Technology Solutions Inc. MACOM and its affiliates reserve the right to make changes to the product s or information contained herein without notice. Visit for additional data sheets and product information. For further information and support please visit: M09000-14 LED Driver and PMIC for DLP/LCOS Pico Projectors Overtemperature and Thermal Shutdown Programmable Serial Interface OTP Programming. State Diagram and Description Component Selection and PCB Layout Control Registers Map and Descriptions 32 User Configurable Status / Readback M/A-COM Technology Solutions Inc. MACOM and its affiliates reserve the right to make changes to the product s or information contained herein without notice. Visit for additional data sheets and product information. For further information and support please visit: M09000-14 LED Driver and PMIC for DLP/LCOS Pico Projectors Electrical Characteristics Absolute Maximum Ratings Table Absolute Maximum Ratings Parameter PVDDX V supplies PVOUT Buck-boost DC-DC converter output IOUT0, IOUT1, IOUT2 Output pins for driving LED LI, LO External inductor pins for DC-DC converter TJCTN TSTG V18, VHIGH, VMID Junction Temperature Storage Temperature Positive DMD outputs VNEG Negative DMD output LBOOSTP Positive side of inductor for DMD LBOOSTN Negative side of inductor for DMD LBUCK1, LBUCK2 Inductor pins for buck converters 1 & 2 VXBUCK1 Output of buck converter 1 VXBUCK2 Output of buck converter 2 |
More datasheets: RFUS2418CG1 | RFVS2421CG1 | RFUS2418BK1 | RFVS2421BK1 | RFUS2426CG1 | RFUS2421BK1 | RFVS1918CG1 | DEMAM9SNMK52 | 76650-0039 | AXA005A0X-SR |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived M09000G-14 Datasheet file may be downloaded here without warranties.