ISM4390-L57 Product Specification
Part | Datasheet |
---|---|
![]() |
ISM4390-L57 (pdf) |
PDF Datasheet Preview |
---|
ISM4390-L57 Product Specification INVENTEK SYSTEMS ISM4390-L57 Embedded Serial-to-Wi-Fi Module eS-WiFi Data Sheet DOC-DS-20081-2.1 Inventek Systems ISM4390-L57 Product Specification Table of Contents 1 GENERAL DESCRIPTION 3 2 PART NUMBER DETAIL 4 Ordering Information 4 3 GENERAL 4 Limitations 4 5 Module Architecture 5 ELECTRICAL SPECIFICATIONS 5 Recommended Operating Ratings 5 Environmental Specifications 5 6 PIN DEFINITION 6 Pin Out 6 Detailed Pin Description 7 Interface Selection 9 7 SERIAL HOST INTERFACES AVAILABLE 9 DOC-DS-20081-2.1 Inventek Systems 1 GENERAL DESCRIPTION ISM4390-L57 Product Specification The Inventek ISM4390-L57 is an embedded eS-WiFiTM GHz wireless Internet Connectivity device. The Wi-Fi module hardware consists of an ARM CortexTM M3 MCU host processor, and Broadcom Wi-Fi device. The module provides a UART interface enabling connection to an embedded design. The Wi-Fi module requires no operating system and has a completely integrated TCP/IP Stack that only requires AT commands to establish connectivity for your wireless product, minimizing development time, testing routines and certification. The low cost, small foot print mm x mm and ease of design-in make it ideal for a range of embedded applications. The module hardware can be used with Inventek’s AT Command set or with Broadcom’s WICEDTM SDK. Summary of Key Features: • b/g/n compliant based on Broadcom MAC/Baseband/Radio device. • Fully contained TCP/IP stack minimizing host CPU requirements. • Configurable using AT commands. • UART Host interface • Network features ICMP Ping , ARP, DHCP,TCP, UDP. • Low power operation 3.3V supply with built-in low power modes. • Secure Wi-Fi authentication WEP-128, WPA-PSK TKIP , WPA2-PSK. • Proven Interoperability • Connects with other vendor’s b/g/n Access Points in the Wireless LAN. • Supported by Broadcom WICEDTM SDK. Typical Applications: • PDA, Pocket PC, computing devices. • Building automation and smart energy control. • Industrial sensing and remote equipment monitoring. • Warehousing, logistics and freight management. • PC and gaming peripherals. • Printers, scanners, alarm and video systems. • Medical applications including patient monitoring and remote diagnostics. DOC-DS-20081-2.1 Inventek Systems ISM4390-L57 Product Specification 2 PART NUMBER DETAIL DESCRIPTION Ordering Information Device ISM4390-L57 Description 802.11b/g/n Wifi Module Firmware UART Ordering Number ISM4390-L57 3 GENERAL FEATURES • Based on the Broadcom BCM4390 MAC/Baseband/Radio device. • Supports Broadcom WICED SDK. • ARM CortexTM M3 MCU at 48 Mhz. • Mb SRAM, 16 Mb Flash • IEEE 802.11n D7.0 -OFDM-72.2 Mbps -single stream w/20 MHz, Short GI • IEEE 802.11g OFDM 54 Mbps • IEEE 802.11b DSSS 11Mbps o WPA Wi-Fi Protected Access o WPA2 Wi-Fi Protected Access 2 - AES/CCMP/802.1x Authentication o WEP • Inputs V tolerant • 7 GPIO Pins • The devices operate from a to V power supply. • -40 to +85 °C temperature range. • Power-saving mode allows the design of low-power applications. • Lead Free Design which is compliant with ROHS requirements. • EMI/EMC Metal Shield for best RF performance in noisy environments and to accommodate for lower RF emissions/signature for easier FCC compliance. Limitations Inventek Systems products are not authorized for use in safety-critical applications such as life support where a failure of the Inventek Systems product would reasonably be expected to cause severe personal injury or death. DOC-DS-20081-2.1 Inventek Systems 4 SPECIFICATIONS Module Architecture ISM4390-L57 Product Specification Figure 1 Inventek’s ISM90_L57 General Block Diagram 5 ELECTRICAL SPECIFICATIONS Recommended Operating Ratings Symbol VDD Voltage Ripple Description Wi-Fi Voltage +/- 2% Min. Typ. Max. Unit. V Voltage Ripple Environmental Specifications Item Operating temperature range Storage temperature range Humidity Description -40o C to +85o C -40o C to +85o C 95% max non-condensing , relative humidity DOC-DS-20081-2.1 Page 5 Inventek Systems 6 PIN DEFINITION Pin Out ISM4390-L57 Product Specification Top View DOC-DS-20081-2.1 Page 6 Inventek Systems Detailed Pin Description ISM4390-L57 Product Specification Type Default Pin Name RESET_N GPIO10/SPI_IRQ A11 |
More datasheets: 2-1002150-0 | 2-1004346-0 | 1-1004346-0 | 3-1004347-0 | 2-1004347-0 | 2-1002785-1 | 2-1002908-0 | 1-1002785-1 | 76650-0113 | 45-1411 |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived ISM4390-L57 Datasheet file may be downloaded here without warranties.