ICS601M-01I
ICS601M-01I Datasheet
ICS601-01
| Part | Datasheet |
|---|---|
ICS601M-01I |
ICS601M-01I (pdf) |
| Related Parts | Information |
|---|---|
|
ICS601M-01IT |
ICS601M-01IT |
|
ICS601G-01 |
ICS601G-01 |
|
ICS601M-01 |
ICS601M-01 |
|
ICS601G-01I |
ICS601G-01I |
|
ICS601G-01IT |
ICS601G-01IT |
|
ICS601G-01T |
ICS601G-01T |
|
ICS601M-01T |
ICS601M-01T |
| PDF Datasheet Preview |
|---|
| LOW PHASE NOISE CLOCK MULTIPLIER DATASHEET ICS601-01 The ICS601-01 is a low-cost, low phase noise, high-performance clock synthesizer for applications which require low phase noise and low jitter. It is IDT’s lowest phase noise multiplier, and also the lowest CMOS part in the industry. Using IDT’s patented analog and digital Phase-Locked Loop PLL techniques, the chip accepts a 10 - 27 MHz crystal or clock input, and produces output clocks up to 156 MHz at V. This product is intended for clock generation. It has low output jitter variation in the output period , but input to output skew and jitter are not defined nor guaranteed. For applications which require definted input to output timing, use the ICS670-01. Block Diagram • Packaged in 16-pin SOIC or TSSOP • Available in Pb lead free package • Uses fundamental 10 - 27 MHz crystal or clock • Patented PLL with the lowest phase noise • Output clocks up to 156 MHz at V • Low phase noise -132 dBc/Hz at 10 kHz • Low jitter - 18 ps one sigma typ. • Full swing CMOS outputs with 25 mA drive capability at TTL levels • Advanced, low power, sub-micron CMOS process • Industrial temperature range available • Operating voltage of 3.3V or 5V NOTE EOL for non-green parts to occur on 5/13/10 per PDN U-09-01 X1/ICLK Crystal or clock input X2 Reference Divider Crystal Oscillator Phase Comparator VDD 3 Charge Pump Loop Filter ROM Based Multipliers VCO Divide 4 S3:0 3 GND REFOUT OE REFEN IDT / ICS LOW PHASE NOISE CLOCK MULTIPLIER ICS601-01 LOW PHASE NOISE CLOCK MULTIPLIER CLOCK MULTIPLIER Pin Assignment CLK 1 REFEN 2 VDD 3 VDD 4 VDD 5 X2 6 S1 7 X1/ICLK 8 16 GND 15 GND 14 GND 13 REFOUT 12 OE 11 S0 10 S3 16 Pin 150 mil TSSOP or SOIC Pin Descriptions Multiplier Select Table S3 S2 S1 S0 CLK see note 2 on following page 0000 0001 TEST 0010 0011 Input x1 Input x3 0100 0101 Input x4 Input x5 Ordering Information Part / Order Number 601M-01* 601M-01T* 601M-01I* 601M-01IT* 601M-01LF 601M-01LFT 601M-01ILF 601M-01ILFT 601G-01* 601G-01T* 601G-01I* 601G-01IT* 601G-01LF 601G-01LFT 601G-01ILF 601G-01ILFT Marking ICS601M-01 ICS601M-01 ICS601M-01I ICS601M-01I ICS601M-01LF ICS601M-01LF ICS601M01ILF 601G-01 601G-01 601G-01I 601G-01I 601G01LF 601G01IL Shipping Packaging Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Tubes Tape and Reel Package 16-pin narrow SOIC 16-pin narrow SOIC 16-pin narrow SOIC 16-pin narrow SOIC 16-pin narrow SOIC 16-pin narrow SOIC 16-pin narrow SOIC 16-pin narrow SOIC 16-pin TSSOP 16-pin TSSOP 16-pin TSSOP 16-pin TSSOP 16-pin TSSOP 16-pin TSSOP 16-pin TSSOP 16-pin TSSOP Temperature 0 to 70° C 0 to 70° C -40 to 85° C -40 to 85° C 0 to 70° C 0 to 70° C -40 to 85° C -40 to 85° C 0 to 70° C 0 to 70° C -40 to 85° C -40 to 85° C 0 to 70° C 0 to 70° C -40 to 85° C -40 to 85° C *NOTE EOL for non-green parts to occur on 5/13/10 per PDN U-09-01 “L” designates Pb lead free package “I” designates industrial grade. While the information presented herein has been checked for both accuracy and reliability, Integrated Circuit Systems IDT assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is intended for use in normal commercial applications. Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary environmental requirements are not recommended without additional processing by IDT. IDT reserves the right to change any circuitry or specifications without notice. IDT does not authorize or warrant any IDT product for use in life support devices or critical medical instruments. IDT / ICS LOW PHASE NOISE CLOCK MULTIPLIER ICS601-01 LOW PHASE NOISE CLOCK MULTIPLIER CLOCK MULTIPLIER Innovate with IDT and accelerate your future networks. Contact: For Sales 800-345-7015 408-284-8200 Fax 408-284-2775 For Tech Support Corporate Headquarters Integrated Device Technology, Inc. 2006 Integrated Device Technology, Inc. All rights reserved. Product specifications subject to change without notice. IDT and the IDT logo are trademarks of Integrated Device Technology, Inc. Accelerated Thinking is a service mark of Integrated Device Technology, Inc. All other brands, product names and marks are or may be trademarks or registered trademarks used to identify products or services of their respective owners. Printed in USA |
| More datasheets: U.FL-2LP(V)-04N2-A-(500) | U.FL-R-SMT-1(80) | U.FL-R-SMT-1(60) | U.FL-R-SMT-1(40) | U.FL-2LP-04N1-A-(1000) | U.FL-2LP-068N2-A-(200) | CA3102R20-15PF183 | ICS601M-01IT | ICS601G-01 | ICS601M-01 |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived ICS601M-01I Datasheet file may be downloaded here without warranties.