SX100AN

SX100AN Datasheet

GENERAL DESCRIPTION The SX Series pressure sensors provide the lowest cost components for measuring pressures up to 150 psi. These sensors are designed for use with non-corrosive, non-ionic media, such as air and dry gases. Convenient pressure ranges are available to measure differential, gauge, and absolute pressures from 0 psi to 1 psi SX01 up to 0 psi to 150 psi SX150 .

Part	Datasheet
SX100AN	SX100AN (pdf)

Related Parts	Information
SX30AN	SX30AN
SX150AN	SX150AN
SX30DP1	SX30DP1
SX15AN	SX15AN
SX15AP1	SX15AP1
SX01DP1	SX01DP1
SX05DN	SX05DN
SX15DN	SX15DN
SX100DN	SX100DN

PDF Datasheet Preview
Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi SX Series FEATURES • Low Cost • High-Impedance Bridge • Absolute and • Differential Gauge • Low Noise • Low Power Consumption for Battery Power TYPICAL APPLICATIONS • Medical • Instrumentation • Barometric • Measurement • Pneumatic Controls • Battery Powered Equipment EQUIVALENT CIRCUITS GENERAL DESCRIPTION The SX Series pressure sensors provide the lowest cost components for measuring pressures up to 150 psi. These sensors are designed for use with non-corrosive, non-ionic media, such as air and dry gases. Convenient pressure ranges are available to measure differential, gauge, and absolute pressures from 0 psi to 1 psi SX01 up to 0 psi to 150 psi SX150 . Button, Nipple and N Packages The Absolute A devices have an internal vacuum reference and an output voltage proportional to absolute pressure. The differential D devices allow application of pressure to either side of the diaphragm and can be used for gauge or differential pressure measurements. DIP Packages WARNING PERSONAL INJURY DO NOT USE these products as safety or emergency stop devices or in any other application where failure of the product could result in personal injury. Failure to comply with these instructions could result in death or serious injury. This product is packaged in either the standard low cost chip carrier “button” package, a plastic ported “N” package, or a DIP package. All packages are designed for applications where the sensing element is integral to the OEM equipment. These packages can be o-ring sealed, epoxied, and/or clamped onto a pressure fitting. A closed-bridge four pin SIP configuration is provided for electrical connection to the “Button” or “N” Package. The DIP Package mounts on a PC board like a standard IC with through-hole pins. This extremely small size package enables the use of multiple sensors in applications with limited space. WARNING MISUSE OF DOCUMENTATION • The information presented in this product sheet is for reference only. Do not use this document as a product installation guide. • Complete installation, operation, and maintenance information is provided in the instructions supplied with each product. Failure to comply with these instructions could result in death or serious injury. Sensing and Control Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi SX Series CHARACTERISTICS Maximum Ratings For All Devices Supply Voltage, VS Operating Temperature Range 12 Vdc -40 °C to 85 °C [-40 °F to 185 °F] Storage Temperature Range -55 °C to 125 °C [-67 °F to 257 °F] Humidity 0 % to 100 % RH Common-mode Pressure 150 psig Lead Soldering Temperature 250 °C [482 °F] 2 sec to 4 sec PERFORMANCE CHARACTERISTICS 1 Characteristic Description Zero Pressure Offset 2 Temperature Coefficient of Offset 3,4 Combined Pressure Non-Linearity, and Hysteresis 5 Long Term Stability of Offset and Span 6 Response Time 7 Input Resistance Temperature Coefficient of Resistance 3,4 Temperature Coefficient of Span 3,4 Output Resistance Repeatability 8 Min. 690 -2550 Typ. 4 100 750 -2150 Max. 810 -1900 Unit mV µV/V/°C %FSS %FSS µs ppm/°C ppm/°C %FSS ORDERING INFORMATION Pressure Range 0 to 1 psid or psig 0 to 5 psid or psig 0 psia to 15 psia 0 psia to 30 psia 0 psia to 100 psia 0 psia to 150 psia 0 to 15 psid or psig 0 to 30 psid or psig 0 to 100 psid or psig 0 to 150 psid or psig Button Package SX01D SX05D SX15A SX30A SX100A SX150A SX15D SX30D SX100D SX150D Order Part Number Nipple Package “N” Package SX01DP1 SX01DN SX05DP1 SX05DN SX15AP1 SX15AN SX30AP1 SX30AN SX100AN SX150AN SX25DP1 SX15DN SX30DP1 SX30DN SX100DN DIP Package SX01GD2, SX01DD4 SX05GD2, SX05DD4 SX15AD2, SX15AD4 SX30AD2, SX30AD4 SX100AD2, SX100AD4 SX15GD2, SX15DD4 SX30GD2, SX30DD4 SX100GD2, SX100DD4 PHYSICAL DIMENSIONS for reference only mm [In] Button Package Honeywell • Sensing and Control 3 Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi Nipple Package SX Series N Housing Package 4 Honeywell • Sensing and Control Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi D2 DIP Package SX Series DD4 DIP Package AD4 DIP Package Honeywell • Sensing and Control 5 Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi SX Series WARRANTY/REMEDY Honeywell warrants goods of its manufacture as being free of defective materials and faulty workmanship. Contact your local sales office for warranty information. If warranted goods are returned to Honeywell during the period of coverage, Honeywell will repair or replace without charge those items it finds defective. The foregoing is Buyer’s sole remedy and is in lieu of all other warranties, expressed or implied, including those of merchantability and fitness for a particular purpose. Specifications may change without notice. The information we supply is believed to be accurate and reliable as of this printing. However, we assume no responsibility for its use. While we provide application assistance personally, through our literature and the Honeywell web site, it is up to the customer to determine the suitability of the product in the application. For application assistance, current specifications, or name of the nearest Authorized Distributor, contact a nearby sales office. Or call 1-800-537-6945 USA/Canada 1-815-235-6847 International FAX 1-815-235-6545 USA INTERNET Sensing and Control Honeywell 11 West Spring Street Freeport, Illinois 61032 008136-1-EN IL50 GLO 1004 Printed in USA Copyright 2004 Honeywell International Inc. All Rights Reserved.

PDF Datasheet Preview

Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi

SX Series

FEATURES
• Low Cost
• High-Impedance Bridge
• Absolute and
• Differential Gauge
• Low Noise
• Low Power Consumption
for Battery Power

TYPICAL APPLICATIONS
• Medical
• Instrumentation
• Barometric
• Measurement
• Pneumatic Controls
• Battery Powered

Equipment

EQUIVALENT CIRCUITS

GENERAL DESCRIPTION The SX Series pressure sensors provide the lowest cost components for measuring pressures up to 150 psi. These sensors are designed for use with non-corrosive, non-ionic media, such as air and dry gases. Convenient pressure ranges are available to measure differential, gauge, and absolute pressures from 0 psi to 1 psi SX01 up to 0 psi to 150 psi SX150 .

Button, Nipple and N Packages

The Absolute A devices have an internal vacuum reference and an output voltage proportional to absolute pressure. The differential D devices allow application of pressure to either side of the diaphragm and can be used for gauge or differential pressure measurements.

DIP Packages

WARNING

PERSONAL INJURY DO NOT USE these products as safety or emergency stop devices or in any other application where failure of the product could result in personal injury. Failure to comply with these instructions could result in death or serious injury.

This product is packaged in either the standard low cost chip carrier “button” package, a plastic ported “N” package, or a DIP package. All packages are designed for applications where the sensing element is integral to the OEM equipment. These packages can be o-ring sealed, epoxied, and/or clamped onto a pressure fitting. A closed-bridge four pin SIP configuration is provided for electrical connection to the “Button” or “N” Package. The DIP Package mounts on a PC board like a standard IC with through-hole pins. This extremely small size package enables the use of multiple sensors in applications with limited space.

WARNING

MISUSE OF DOCUMENTATION
• The information presented in this product sheet is for reference only. Do not use this document as a product installation guide.
• Complete installation, operation, and maintenance information is provided in the instructions supplied with each product.

Failure to comply with these instructions could result in death or serious injury.

Sensing and Control

Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi

SX Series

CHARACTERISTICS Maximum Ratings For All Devices

Supply Voltage, VS Operating Temperature Range
12 Vdc -40 °C to 85 °C [-40 °F to 185 °F]

Storage Temperature Range
-55 °C to 125 °C [-67 °F to 257 °F]

Humidity
0 % to 100 % RH

Common-mode Pressure
150 psig

Lead Soldering Temperature
250 °C [482 °F] 2 sec to 4 sec

PERFORMANCE CHARACTERISTICS 1

Characteristic Description Zero Pressure Offset 2 Temperature Coefficient of Offset 3,4 Combined Pressure Non-Linearity, and Hysteresis 5 Long Term Stability of Offset and Span 6 Response Time 7

Input Resistance Temperature Coefficient of Resistance 3,4 Temperature Coefficient of Span 3,4

Output Resistance Repeatability 8

Min.
690 -2550

Typ.
4 100 750 -2150

Max. 810 -1900

Unit mV µV/V/°C %FSS %FSS µs ppm/°C ppm/°C %FSS
ORDERING INFORMATION

Pressure Range
0 to 1 psid or psig 0 to 5 psid or psig 0 psia to 15 psia 0 psia to 30 psia 0 psia to 100 psia 0 psia to 150 psia 0 to 15 psid or psig 0 to 30 psid or psig 0 to 100 psid or psig 0 to 150 psid or psig

Button Package SX01D SX05D SX15A SX30A SX100A SX150A SX15D SX30D SX100D SX150D

Order Part Number

Nipple

Package “N” Package

SX01DP1

SX01DN

SX05DP1

SX05DN

SX15AP1

SX15AN

SX30AP1

SX30AN

SX100AN

SX150AN

SX25DP1

SX15DN

SX30DP1

SX30DN

SX100DN

DIP Package SX01GD2, SX01DD4 SX05GD2, SX05DD4 SX15AD2, SX15AD4 SX30AD2, SX30AD4 SX100AD2, SX100AD4 SX15GD2, SX15DD4 SX30GD2, SX30DD4 SX100GD2, SX100DD4

PHYSICAL DIMENSIONS for reference only mm [In] Button Package

Honeywell
• Sensing and Control 3

Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi

Nipple Package

SX Series

N Housing Package
4 Honeywell
• Sensing and Control

Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi

D2 DIP Package

SX Series

DD4 DIP Package AD4 DIP Package

Honeywell
• Sensing and Control 5

Silicon Pressure Sensors SX 0 psi to 1 psi to 0 psi to 150 psi

SX Series

WARRANTY/REMEDY Honeywell warrants goods of its manufacture as being free of defective materials and faulty workmanship. Contact your local sales office for warranty information. If warranted goods are returned to Honeywell during the period of coverage, Honeywell will repair or replace without charge those items it finds defective. The foregoing is Buyer’s sole remedy and is in lieu of all other warranties, expressed or implied, including those of merchantability and fitness for a particular purpose. Specifications may change without notice. The information we supply is believed to be accurate and reliable as of this printing. However, we assume no responsibility for its use.

While we provide application assistance personally, through our literature and the Honeywell web site, it is up to the customer to determine the suitability of the product in the application. For application assistance, current specifications, or name of the nearest Authorized Distributor, contact a nearby sales office. Or call 1-800-537-6945 USA/Canada 1-815-235-6847 International FAX 1-815-235-6545 USA INTERNET

Sensing and Control Honeywell 11 West Spring Street Freeport, Illinois 61032
008136-1-EN IL50 GLO 1004 Printed in USA Copyright 2004 Honeywell International Inc. All Rights Reserved.

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived SX100AN Datasheet file may be downloaded here without warranties.

Datasheet ID: SX100AN 636543