Flash-64P-M01/M09 Evaluation Board Datasheet
Flash-64P-M01/M09 Evaluation Board
The Flash-64P-M01/M09 is a low cost multi-functional evaluation board for the Fujitsu 16-Bit Flash microcontroller series MB90560, MB90560L and MB90565. It can be used stand alone for software development and testing or as a simple target board to work with the emulator system. The board allows the designer immediately to start with the software development before his own final target system is available.
Features
• Supports 16-Bit LX series MB90560, MB90560L, MB90565
• Fully supports 3V and 5V environment
• QFP-64 or DIP-64 package can be used
• In-Circuit serial Flash programming
• All resources available for evaluation
• All pins routed to connectors
• 4MHz main crystal
• Two UART Interfaces (3V and 5V operating)
• 8 User LEDs
• Reset Button
• Two Buttons configurable for external interrupts
• Prototyping area
The Flash-64P-M01/M09 was designed to support the MB90560/L series. It can be used as a stand alone evaluation board or as a target board for emulator debugger. The evaluation board supports two different packages Ø FPT-64P-M09 (square QPF64 package, 0,65mm pitch) Ø DIP-64P-M01 (shrink DIP package)
Flash-64P-M01/M09 By default the board is working with a 4MHz crystal as the main oscillation clock, so internal clock rates up to 16MHz can be generated using the internal PLL of the µC. Two separate RS232 transceivers can be used to connect directly the two on-chip UARTs to the 9 pin D-Sub connectors. The transceivers generate the adequate RS232 levels for the receive (RXD) and transmit (TXD) lines. The DTR line of the connector is hardwired to the DSR line. The RTS signal can be shortcut to CTS using the DIL switch setting. The UART1 interface (X3) is always used for the in-circuit serial programming of the MB90F562/L. If the board is used as an emulator target board, the microcontroller must be removed from the socket and the corresponding probe cable has to be plugged in instead. For the FPT-64P-M09 package (64 pin QFP package), use the probe cable MB2132-461. For the DIP-64P-M01 package (64 pin DIL package), use the probe cable MB2132-434. All pins of the microcontrollers are connected to the edge connectors J16-J19. So all pins are directly available.
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived Flash-64P-M01/M09 Evaluation Board Datasheet file may be downloaded here without warranties.