PI5L102LE

PI5L102LE Datasheet

PI5L102

Part	Datasheet
PI5L102LE	PI5L102LE (pdf)

PDF Datasheet Preview
Features • Supports CompactPCI precharge voltage selection • 3.3V/2.7kΩ, 5V/1ohm line termination selection • Ultra-low quiescent current 0.1uA typical • Low On-Resistance 7Ω maximum • Single supply operation up to 6.2V ±5% • Wide bandwidth data rates >200 Mbps • Mechanical relay replacement • Packaging Pb-free & Green available : -Compact 20-pin TSSOP L Block Diagram 9" 9# PI5L102 CompactPCI Hot Swap Pull-up Switch The PI5L102L CompactPCI Hot Swap Pull-up switch is a Quad 1:2 multiplexer. It is designed to switch the 1V precharge bias voltage and 10kΩ pull-up resistor connected to the CompactPCI bus signals during Hot Swap. Each switch can connect eight inputs IAn to IDn to a given pull-up voltage level. In addition, the PI5L102 can be used to select kΩ/3.3V or kohm/5V pull-ups for the system card PCI signal lines. ON resistance is a low 7Ω maximum and all eight switches are selected or disabled with a single CMOS/TTL compatible signal. For general-purpose applications, the PI5L102 can replace mechanical relays. In network systems, physical layer signals can be switched. To reduce the insertion loss, the PI5L102 can be powered by a 6.2V Zener diode. Truth Table 1 H Hi-Z HI-Z Hi-Z HI-Z L IA0, IA1 IB0, IB2 IC0, IC1, ID0, ID1 Note H = High Voltage Level, L = Low Voltage Level Function Disable Enable Pin Description Pin Name IAn-IDn Data Inputs Enable YA-YD Data Outputs Ground Power CompactPCI is a registered trademark of the PCI Industrial Computer Manufacturers Group PI5L102 CompactPCI Hot Swap Pull-Up Switch Maximum Ratings Above which the useful life may be impaired. For user guidelines, not tested. Storage Temperature to +150°C Ambient Temperature with Power Applied 0°C to +70°C Supply Voltage to Ground Potential Inputs & VCC Only ... to +7.0V Supply Voltage to Ground Potential Outputs & D/O Only to +7.0V DC Input Voltage to +7.0V DC Output 120mA Power Dissipation 0.5W Note Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. DC Electrical Characteristics Over the Operating Range, TA = 0°C to +70°C, VCC = 6.2V, +5%, 2% Parameters Test Conditions 1 Min. Typ 2 Input HIGH Voltage Input LOW Voltage Guaranteed Logic HIGH Level Guaranteed Logic LOW Level Input HIGH Current VCC = Max., VIN = VCC Ordering Information Ordering Code PI5L102L PI5L102LE Package Code L Package Description 20-pin TSSOP Pb-free & Green, 20-pin TSSOP Notes Thermal characteristics can be found on the company web site at Pericom Semiconductor Corporation • 1-800-435-2336 •

PDF Datasheet Preview

Features
• Supports CompactPCI precharge voltage selection
• 3.3V/2.7kΩ, 5V/1ohm line termination selection
• Ultra-low quiescent current 0.1uA typical
• Low On-Resistance 7Ω maximum
• Single supply operation up to 6.2V ±5%
• Wide bandwidth data rates >200 Mbps
• Mechanical relay replacement
• Packaging Pb-free & Green available :
-Compact 20-pin TSSOP L

Block Diagram
9" 9#

PI5L102

CompactPCI Hot Swap Pull-up Switch

The PI5L102L CompactPCI Hot Swap Pull-up switch is a Quad 1:2 multiplexer. It is designed to switch the 1V precharge bias voltage and 10kΩ pull-up resistor connected to the CompactPCI bus signals during Hot Swap. Each switch can connect eight inputs IAn to IDn to a given pull-up voltage level.

In addition, the PI5L102 can be used to select kΩ/3.3V or kohm/5V pull-ups for the system card PCI signal lines.

ON resistance is a low 7Ω maximum and all eight switches are selected or disabled with a single CMOS/TTL compatible signal. For general-purpose applications, the PI5L102 can replace mechanical relays. In network systems, physical layer signals can be switched.

To reduce the insertion loss, the PI5L102 can be powered by a 6.2V Zener diode.

Truth Table 1

H Hi-Z HI-Z

Hi-Z

HI-Z

L IA0, IA1 IB0, IB2 IC0, IC1, ID0, ID1

Note H = High Voltage Level, L = Low Voltage Level

Function Disable Enable

Pin Description

Pin Name

IAn-IDn

Data Inputs

Enable

YA-YD

Data Outputs

Ground

Power

CompactPCI is a registered trademark of the PCI Industrial Computer Manufacturers Group

PI5L102 CompactPCI Hot Swap Pull-Up Switch

Maximum Ratings

Above which the useful life may be impaired. For user guidelines, not tested.

Storage Temperature to +150°C Ambient Temperature with Power Applied 0°C to +70°C Supply Voltage to Ground Potential Inputs & VCC Only ... to +7.0V Supply Voltage to Ground Potential Outputs & D/O Only to +7.0V DC Input Voltage to +7.0V DC Output 120mA Power Dissipation 0.5W

Note Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

DC Electrical Characteristics Over the Operating Range, TA = 0°C to +70°C, VCC = 6.2V, +5%, 2%

Parameters

Test Conditions 1

Min. Typ 2

Input HIGH Voltage

Input LOW Voltage

Guaranteed Logic HIGH Level Guaranteed Logic LOW Level

Input HIGH Current

VCC = Max., VIN = VCC
Ordering Information
Ordering Code PI5L102L PI5L102LE

Package Code L

Package Description 20-pin TSSOP Pb-free & Green, 20-pin TSSOP

Notes Thermal characteristics can be found on the company web site at

Pericom Semiconductor Corporation
• 1-800-435-2336
•

More datasheets: J9A | J5A | FFA20U60DNTU | 1259-7SURSYGW/S530-A3 | 18059ACU | PVSEC-T102-DC1000V-30A-AF1 UL1699B | PVSEC-T101-DC1000V-30A-AF1 | M39146 SL002 | M39146 SL005 | M39146 SL001

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived PI5L102LE Datasheet file may be downloaded here without warranties.

Datasheet ID: PI5L102LE 510076