FIT0531-R
FIT0531-R Datasheet
SKU:FIT0531-R
| Part | Datasheet |
|---|---|
FIT0531-R |
FIT0531-R (pdf) |
| PDF Datasheet Preview |
|---|
| 1.75mm PLA 750g Red SKU:FIT0531-R INTRODUCTION This is 1.75mm PLA filament which is commonly used by reprap, Makerbot, Mendel, Huxley UP! Printer, WeisTek and Thing-o-matic 3D printers. It comes with one spool that can be easily attached on 3D printer. PLA is a wonderful filament. It is the most environmentally friendly material available for this type of 3D printing, and it comes in a wide range of colors. Polylactic acid or polylactide PLA is a thermoplastic aliphatic polyester derived from renewable resources, such as corn starch, tapioca roots, chips or starch, or sugarcane. It can biodegrade under certain conditions. As the extrusion head temperature will vary from 3D printer to 3D printer design, temperature differences will affect the result of your print, we suggest PLA use an optimal temperature range of to Please make the appropriate adjustments to temperature before you print with PLA, some testing might be required to find your optimal print settings. SPECIFICATION • Diameters 1.75mm • Weight 750g • PLA Parameter • Physical Property Typical value • Tensile 46Mpa • Tensile 20% • Flexural Strength 70Mpa • Flexural Modulus 3212Mpa • Notched lzod • • density 1.31g/cm3 • MFR 10-14g/10min • Accuracy 1.75±0.1mm SHIPPING LIST 1.75mm PLA 750g Red x1 |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived FIT0531-R Datasheet file may be downloaded here without warranties.