CY2X013FLXIT

CY2X013FLXIT Datasheet


CY2X013

Part Datasheet
CY2X013FLXIT CY2X013FLXIT CY2X013FLXIT (pdf)
Related Parts Information
CY2X013FLXCT CY2X013FLXCT CY2X013FLXCT
CY2X013LXI125T CY2X013LXI125T CY2X013LXI125T
CY2X013LXI122T CY2X013LXI122T CY2X013LXI122T
CY2X013LXI100T CY2X013LXI100T CY2X013LXI100T
CY2X013LXI062T CY2X013LXI062T CY2X013LXI062T
CY2X013LXI156T CY2X013LXI156T CY2X013LXI156T
PDF Datasheet Preview
CY2X013

LVDS Crystal Oscillator XO
• Low jitter crystal oscillator XO
• Less than 1 ps typical root mean square RMS phase jitter
• Low-voltage differential signaling LVDS output
• Output frequency from 50 MHz to 690 MHz
• Factory-configured or field-programmable
• Integrated phase-locked loop PLL
• Output enable OE or power-down PD# function
• Supply voltage V or V
• Pb-free package x mm leadless chip carrier LCC
• Commercial and industrial temperature ranges

Logic Block Diagram

CRYSTAL OSCILLATOR
1 OE/ PD#
6 VDD

Functional Description

The CY2X013 is a high-performance and high-frequency XO. The device uses a Cypress proprietary low-noise PLL to synthesize the frequency from an integrated crystal.

The CY2X013 is available as a factory-configured device or as a field-programmable device. Factory-configured devices are configured for general use see Standard and Application-Specific Factory Configurations or they can be customer-specific.

LOW- NOISE PLL

PROGRAMMABLE CONFIGURATION

OUTPUT DIVIDER
3 VSS
4 CLK
5 CLK#
• San Jose, CA 95134-1709
• 408-943-2600

CY2X013

Pinouts

Figure Pin Diagram 6-Pin Ceramic LCC

OE/PD# 1 DNU 2 VSS 3
6 VDD 5 CLK# 4 CLK

Table Pin Definitions - 6-Pin Ceramic LCC

Pin 1
4, 5 2 6 3

Name OE/PD#

CLK, CLK# DNU VDD VSS

I/O Type

CMOS input Output enable pin Active HIGH. If OE = 1, CLK is enabled. Power-down pin Active LOW. If PD# = 0, the device is powered down and the clock is disabled. The functionality of this pin is programmable

LVDS output Differential output clock

Do not use DNU pins are electrically connected, but perform no function

Power Supply voltage V or V

Power Ground

Standard and Application-Specific Factory Configurations

Part Number CY2X013LXI125T CY2X013LXI200T

Output Frequency MHz

Pin 1 Function OE

RMS Phase Jitter Random

Offset Range

Jitter Typical

MHz to 20 MHz 12 kHz to 20 MHz
Ordering Information

Part Number Pb-free CY2X013FLXCT CY2X013FLXIT CY2X013LXI125T[8] CY2X013LXI200T[8]

Configuration

Package Description

Field-programmable Field-programmable Factory-configured Factory-configured
6-pin ceramic LCC SMD - tape and reel 6-pin ceramic LCC SMD - tape and reel 6-pin ceramic LCC SMD - tape and reel 6-pin ceramic LCC SMD - tape and reel

Product Flow

Commercial, 0 °C to 70 °C Industrial, °C to 85 °C Industrial, °C to 85 °C Industrial, °C to 85 °C

Some product offerings are factory programmed customer specific devices with customized part numbers. The Possible Configurations table shows the available device types, but not complete part numbers. Contact your local Cypress FAE or sales representative for more information.

Possible Configurations

Part Number[9] Pb-free CY2X013LXCxxxT CY2X013LXIxxxT

Configuration

Factory-configured Factory-configured

Package Description
6-pin ceramic LCC SMD - tape and reel 6-pin ceramic LCC SMD - tape and reel

Product Flow

Commercial, 0 °C to 70 °C Industrial, °C to 85 °C
Ordering Code Definitions

CY 2X013 F LX C/I XXX T

Tape and reel Custom part configuration code

C = Commercial I = Industrial 6-pin LCC package

Field programmable device Base part number Company ID CY = Cypress

Notes Device configuration details are described in the Standard and Application-Specific Factory Configurations table on page “xxx” indicates factory programmed parts based on customer specific configuration. For more details, contact your local Cypress FAE or a sales representative.

Page 7 of 10

Package Diagram

Figure 6-Pin x mm Ceramic LCC

CY2X013

Acronyms

Acronym ESD FAE HBM JEDEC LCC LVDS OE PCB PLL RMS XO OTP

Description electrostatic discharge field application engineer human body model joint electron devices engineering council leadless chip carrier Low-voltage differential signaling output enable printed circuit board phase-locked loop root mean square crystal oscillator one-time programmable
001-10044 *B

Document Conventions

Units of Measure

Symbol °C mA mV MHz ms ns pF ppm ps V

Unit of Measure degrees Celsius milliampere millivolts megahertz millisecond nanoseconds picofarads microamperes parts per million picoseconds volts ohms watts

Page 8 of 10

CY2X013
.Document History Page

Document Title CY2X013 LVDS Crystal Oscillator XO Document Number 001-10261

Orig. of Submission

Change

Description of Change
504518
09/21/06 New data sheet
*B 2718898 WWZ
06/15/09 Minor ECN to post data sheet to external web
2768029
2897691
09/18/09 03/23/10
Change VOD limits from 250/450 mV to 247/454 mV Change ISB max from 250 to 200 Add clause to IOZ Condition column Add max limit for TR, TF ns Change TOE max from 100 ns to 120 ns Change TLOCK max from 10 ms to 5 ms Updated data sheet status from Preliminary to Final Updated Ordering Information Added Possible Configurations Updated Package Diagram
2973338
07/08/10
Added Standard and Application-Specific Factory Configurations table on page Added phase jitter specs for pre-defined configurations in AC Electrical Characteristics note 7 refers users to the new table on page 2 for typical specs . Added CY2X013LXI100T, CY2X013LXI122T, CY2X013LXI125T, and CY2X013LXI156T devices to Ordering Information and added note 8 to reference the configuration descriptions for each new device. Changed all references to CyberClocksOnline software to CyClockWizard. Removed section on phase noise versus jitter SW optimization.
3047226 BASH
10/08/10
Added CY2X013LXI062T to Standard and Application-Specific Factory Configurations table on page 2 and to Ordering Information table. Added Acronym and Units of Measure table Updated datasheet as per template
*G 3205939 BASH
03/25/11 Added CY2X013LXI200T to Standard and Application-Specific Factory Configurations table on page 2 and to Ordering Information table.
Page 9 of 10

CY2X013

Sales, Solutions, and Legal Information

Worldwide Sales and Design Support Cypress maintains a worldwide network of offices, solution centers, manufacturer’s representatives, and distributors. To find the office closest to you, visit us at Cypress Locations.

Products Automotive Clocks & Buffers Interface Lighting & Power Control

Memory Optical & Image Sensing PSoC Touch Sensing USB Controllers Wireless/RF
cypress.com/go/automotive cypress.com/go/clocks
cypress.com/go/interface cypress.com/go/powerpsoc
cypress.com/go/plc cypress.com/go/memory
cypress.com/go/image cypress.com/go/psoc cypress.com/go/touch cypress.com/go/USB
cypress.com/go/wireless

PSoC Solutions psoc.cypress.com/solutions PSoC 1 | PSoC 3 | PSoC 5

Cypress Semiconductor Corporation, The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use of any circuitry other than circuitry embodied in a Cypress product. Nor does it convey or imply any license under patent or other rights. Cypress products are not warranted nor intended to be used for medical, life support, life saving, critical control or safety applications, unless pursuant to an express written agreement with Cypress. Furthermore, Cypress does not authorize its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress products in life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress against all charges.

Any Source Code software and/or firmware is owned by Cypress Semiconductor Corporation Cypress and is protected by and subject to worldwide patent protection United States and foreign , United States copyright laws and international treaty provisions. Cypress hereby grants to licensee a personal, non-exclusive, non-transferable license to copy, use, modify, create derivative works of, and compile the Cypress Source Code and derivative works for the sole purpose of creating custom software and or firmware in support of licensee product to be used only in conjunction with a Cypress integrated circuit as specified in the applicable agreement. Any reproduction, modification, translation, compilation, or representation of this Source Code except as specified above is prohibited without the express written permission of Cypress.

Disclaimer CYPRESS MAKES NO WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Cypress reserves the right to make changes without further notice to the materials described herein. Cypress does not assume any liability arising out of the application or use of any product or circuit described herein. Cypress does not authorize its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress’ product in a life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress against all charges.

Use may be limited by and subject to the applicable Cypress software license agreement.

All products and company names mentioned in this document may be the trademarks of their respective holders.

Page 10 of 10
More datasheets: 70668 | TACK DOWN TAPE DISPENSER | ELT-315SDRWA/S530-A3 | CM155-32.768KDZFTR | FIT0478 | G844400PUBUS0 | G84-4420LUBEU-0 | B72214Q0551K101 | 310-001 | CC18-110


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived CY2X013FLXIT Datasheet file may be downloaded here without warranties.

Datasheet ID: CY2X013FLXIT 507756