CS44L11
Part | Datasheet |
---|---|
![]() |
CS44L11-CZZ (pdf) |
PDF Datasheet Preview |
---|
CS44L11 Low Voltage Class-D PWM Headphone Amplifier Up to 95 dB Dynamic Range V to V Analog and Digital Supplies Sample Rates up to 96 kHz Digital Tone Control 3 Selectable HPF and LPF Corner Frequencies 12 dB Boost for Bass and Treble - 1 dB step size Programmable Digital Volume Control +18 to -96 dB in 1 dB steps Peak Signal Soft Limiting De-emphasis for 32 kHz, kHz, and 48 kHz Selectable Outputs for Each Channel, including Channel A R, L, mono L + R / 2, mute Channel B R, L, mono L + R / 2, mute PWM 23 mW/Channel into 16 V The CS44L11 is a complete stereo digital-to-PWM Class-D audio amplifier system controller including interpolation, volume control, and a headphone amplifier in a 16-pin TSSOP package. The CS44L11 architecture uses a direct-to-digital approach that maintains digital signal integrity to the final output filter. This minimizes analog interference effects that can negatively affect system performance. The CS44L11 contains on-chip digital bass and treble boost, peak signal limiting, and de-emphasis. The PWM amplifier can achieve greater than 90% efficiency. This efficiency leads to longer battery life for portable systems, smaller device package, less heat sink requirements, and smaller power supplies. The CS44L11 is ideal for portable audio, headphone amplifiers, and mobile phones. ORDERING INFORMATION CS44L11-CZZ, Lead Free -10 to 70 °C 16-pin TSSOP SDIN SCLK LRCK SCL/DIF0 SDA/DEM Control Port Multibit Modulator with Correction PWM Conversion Serial Audio Port Digital Volume Control, Bass/Treble Boost, Compression Limiting, De-emphasis Interpolation Input Sampling Rate LRCLK/MCLK Ratio Multibit Modulator with Correction PWM Conversion Level Shifter Level Shifter VA_HPA HP_A GND_HPA VA_HPB HP_B GND_HPB Preliminary Product Information MCLK This document contains information for a new product. Cirrus Logic reserves the right to modify this product without notice. Copyright Cirrus Logic, Inc. 2005 All Rights Reserved JULY '05 DS640PP4 CS44L11 TABLE OF CONTENTS CHARACTERISTICS AND SPECIFICATIONS 4 PERFORMANCE 5 SWITCHING CHARACTERISTICS 8 SWITCHING CHARACTERISTICS - CONTROL PORT - FORMAT 9 TYPICAL CONNECTION DIAGRAMS 10 REGISTER QUICK REFERENCE 12 REGISTER DESCRIPTIONS 13 Power and Muting Control address 02h 13 Soft Ramp and Zero Cross Control SZC 13 Power Down PDN 13 Float Output FLT 13 Ramp-Up Bypass RUPBYP 14 Ramp-Down Bypass RDNBYP 14 Channel A Volume Control address 03h VOLA 14 Channel B Volume Control address 04h VOLB 14 Tone Control address 05h 15 DS640PP4 CS44L11 Format 28 Writing in Format 28 Reading in Format 28 Memory Address Pointer MAP 28 INCR Auto Map Increment Enable 28 MAP3-0 Memory Address Pointer 29 LIST OF FIGURES Figure Serial Audio Data Interface Timing 8 Figure Control Port Timing - 9 Figure Typical CS44L11 Connection Diagram Stand-Alone Mode 10 Figure Typical CS44L11 Connection Diagram Control Port 11 Figure Dynamics Control Block Diagram 20 Figure De-Emphasis 22 Figure Control Port Timing, 29 Figure Single-Speed Stopband Rejection 29 Figure Single-Speed Transition Band 29 Figure Single-Speed Transition Band 29 Figure Single-Speed Passband Ripple 29 Figure Double-Speed Stopband 30 Figure Double-Speed Transition 30 Figure Double-Speed Transition Band Detail 30 Figure Double-Speed Passband 30 Figure Left-Justified, up to 24-Bit 31 Figure Right-Justified, 24-Bit Data 31 Figure Up to 24-Bit 31 Figure Right-Justified, 16-Bit Data 31 LIST OF TABLES DS640PP4 Added Lead-free device ordering information. -Corrected “Features” on page -Corrected Table 11, “Single-Speed Clock Modes - Control Port Mode,” on page -Corrected Table 12, “Single-Speed Clock Modes - Stand-Alone Mode,” on page -Corrected Table 13, “Double-Speed Clock Modes - Control Port Mode,” on page Added last two rows to Table 13, “Double-Speed Clock Modes - Control Port Mode,” on page Contacting Cirrus Logic Support For all product questions and inquiries contact a Cirrus Logic Sales Representative. To find the one nearest to you go to IMPORTANT NOTICE "Preliminary" product information describes products that are in production, but for which full characterization data is not yet available. Cirrus Logic, Inc. and its subsidiaries "Cirrus" believe that the information contained in this document is accurate and reliable. However, the information is subject to change without notice and is provided "AS IS" without warranty of any kind express or implied . Customers are advised to obtain the latest version of relevant information to verify, before placing orders, that information being relied on is current and complete. All products are sold subject to the terms and conditions of sale supplied at the time of order acknowledgment, including those pertaining to warranty, indemnification, and limitation of liability. No responsibility is assumed by Cirrus for the use of this information, including use of this information as the basis for manufacture or sale of any items, or for infringement of patents or other rights of third parties. This document is the property of Cirrus and by furnishing this information, Cirrus grants no license, express or implied under any patents, mask work rights, copyrights, trademarks, trade secrets or other intellectual property rights. Cirrus owns the copyrights associated with the information contained herein and gives consent for copies to be made of the information only for use within your organization with respect to Cirrus integrated circuits or other products of Cirrus. This consent does not extend to other copying such as copying for general distribution, advertising or promotional purposes, or for creating any work for resale. CERTAIN APPLICATIONS USING SEMICONDUCTOR PRODUCTS MAY INVOLVE POTENTIAL RISKS OF DEATH, PERSONAL INJURY, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE “CRITICAL APPLICATIONS” . CIRRUS PRODUCTS ARE NOT DESIGNED, AUTHORIZED OR WARRANTED FOR USE IN AIRCRAFT SYSTEMS, MILITARY APPLICATIONS, PRODUCTS SURGICALLY IMPLANTED INTO THE BODY, AUTOMOTIVE SAFETY OR SECURITY DEVICES, LIFE SUPPORT PRODUCTS OR OTHER CRITICAL APPLICATIONS. INCLUSION OF CIRRUS PRODUCTS IN SUCH APPLICATIONS IS UNDERSTOOD TO BE FULLY AT THE CUSTOMER’S RISK AND CIRRUS DISCLAIMS AND MAKES NO WARRANTY, EXPRESS, STATUTORY OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE, WITH REGARD TO ANY CIRRUS PRODUCT THAT IS USED IN SUCH A MANNER. IF THE CUSTOMER OR CUSTOMER’S CUSTOMER USES OR PERMITS THE USE OF CIRRUS PRODUCTS IN CRITICAL APPLICATIONS, CUSTOMER AGREES, BY SUCH USE, TO FULLY INDEMNIFY CIRRUS, ITS OFFICERS, DIRECTORS, EMPLOYEES, DISTRIBUTORS AND OTHER AGENTS FROM ANY AND ALL LIABILITY, INCLUDING ATTORNEYS’ FEES AND COSTS, THAT MAY RESULT FROM OR ARISE IN CONNECTION WITH THESE USES. Cirrus Logic, Cirrus, and the Cirrus Logic logo designs are trademarks of Cirrus Logic, Inc. All other brand and product names in this document may be trademarks or service marks of their respective owners. DS640PP4 |
More datasheets: ATA5728P6-TKQY | ATA5724P3-TKQY 19 | ATA5723P3-TKQY | MT7H79P3E-C0054 | FIT0334 | EVAL-CN0349-PMDZ | 1010931003 | CMD3750 | CMD3450 | CMD3350 |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived CS44L11-CZZ Datasheet file may be downloaded here without warranties.