SEC318-2SFP-T
SEC318-2SFP-T Datasheet
10 & 18 port, SNMP, Modbus/TCP Models SEC310-2SFP-T, SEC318-2SFP-T
| Part | Datasheet |
|---|---|
SEC318-2SFP-T |
SEC318-2SFP-T (pdf) |
| Related Parts | Information |
|---|---|
808-38102 |
808-38102 |
808-38200 |
808-38200 |
SEC310-2SFP-T |
SEC310-2SFP-T |
| PDF Datasheet Preview |
|---|
| Monitored Ethernet Switches 10 & 18 port, SNMP, Modbus/TCP Models SEC310-2SFP-T, SEC318-2SFP-T SEC310-2SFP-T SEC318-2SFP-T • Communicates with HMI/SCADA software via Modbus/TCP • Integrated with iView2 - SNMP Management Software free download • Energy Efficient Ethernet EEE , IEEE 802.3az for low energy consumption • Wide temperature range -40 to 75°C • DIN rail or wall/panel mountable • Redundant dual 12 to 48 VDC power inputs • EMS Level 3 Protection • Designed for hazardous locations UL C1D2, ATEX Zone 2 pending , IECEx pending • Port-based QoS feature for deterministic data transmission • Loop detection and event alarm • Power failure indicated by a relay and LED indicator Introduction SE300 series is the industry’s first design for Ethernet IEEE802.3az - Energy Ethernet switches that cut power usage by up to 60%, significantly saving energy usage in the field and reducing total cost of ownership over Advantech B+B SmartWorx SE300 series monitored switches can be used as plug-andplay unmanaged switches right out of the box. Installing the Network Management Software gives them basic monitoring and management capabilities as well. They bridge the gap between unmanaged switches and significantly more expensive, fully managed solutions. When enabled with iView2, these switches provide IP address assignment, allowing for a static IP address or an address that is discoverable via DHCP in the network. Then, these switches have the ability to use Modbus/TCP to communicate with HMI/SCADA software and SNMP to communicate with NMS Networking Management Software at the same time. This gives full access control to both control engineers and IT managers. Specifications COMMUNICATIONS Standards IEEE 802.3u, 802.3x, 802.3ab, 802.3z, 802.1p, 802.3az 10/100/1000Base-T X , Optional 100Base-FX, 1000Base-SX/LX/LHX/XD/ZX/EZX Ethernet 100m Transmission Distance 4-wire Cat.5e, Cat.6 RJ-45 cable suggested for Gigabit port SFP 110km depends on SFP Transmission Speed Ethernet 10/100Mbps Auto-Negotiation Gigabit Copper 10/100/1000Mbps, Auto-Negotiation Gigabit Fiber Up to 1000Mbps INTERFACE Connectors SEC310-2SFP-T 8 x RJ45 + 2 x RJ45/SFP combo ports SEC318-2SFP-T 16 x RJ45 + 2 x RJ45/SFP combo ports 6-pin removable screw terminal power & relay Ethernet Auto Sensing, 10/100/1000BaseTX, Duplex and MDIX. LED Indicators P1, P2, P-Fail, Loop Detection 10/100T X Link/Activity, Speed Gigabit Copper Link/Activity, Speed 1000 Mbps SFP Link/Activity Basic Monitoring & Management Capabilities iView2 gives network managers the ability to monitor and manage eWorx SE300 series switches from a central location. It features an intuitive Graphical User Interface GUI that provides a real-life representation of all installed eWorx SE300 Series switches, displaying device functions, port settings, device status information and traffic statistics via SNMP. iView2 can also configure eWorx SE300 series switches monitoring capabilities for automation applications via the popular Modbus TCP/IP protocol. Control engineers can use existing HMI/SCADA software to integrate the network status by creating extra tags for real-time monitoring. iView2 is a standalone software that supports multiple platforms and operating systems. iView2 Features for eWorx SE300 series Switches Monitoring • System information IP/MAC address • Port status • Port speed • Flow control • Link up counter • TX packets counter, RX packets counter • TX error packets counter, RX error packets counter • Firmware version • PoE status PoE model/s only Management • Configure IP mode • Set IP address • Set TCP Modbus/TCP time-out • Create Community Strings • Configure Traps / Enabling an Intelligent Planet All product specifications are subject to change without notice. SEC310-2SFP-T & SEC318-2SFP-T_2016 Monitored Ethernet Switches 10 & 18 port, SNMP, Modbus/TCP Models SEC310-2SFP-T, SEC318-2SFP-T Specifications - continued SWITCH PROPERTIES MAC Table Size Packet Buffer Size 4.1M bit Switching Capacity SEC310-2SFP-T Gbps. SEC318-2SFP-T Gbps Jumbo Frame Product Ordering Information MODEL # SEC310-2SFP-T SEC318-2SFP-T 8-port 10/100Mbps + 2-port GbE Combo Monitored Ethernet Switch 16-port 10/100Mbps + 2-port GbE Combo Monitored Ethernet Switch RJ45 OPERATING TEMPERATURE 10/100 MBPS GIGABIT 100FX 100/1000BASE-SFP -40~75°C FIBER COMBO PORT, 10/100/1000BASE-T X OR 100/1000BASE-SFP -40~75°C TYPE CONNECTOR LC SFP LC SFP Accessories - optional MODEL # MDR-40-24 DIN Rail Power supply, 24VDC 40 Watt C5UMB3FBG 3 ft. 1 M , Gray, Category 5e UTP Patch Cord C5UMB7FBG 7 ft. 2 M , Gray, Category 5e UTP Patch Cord 808-38102 IE-SFP 100 to 155 Mbps OC-3 , MM850-LC, 2km 808-38104 IE-SFP 100 to 155 Mbps OC-3 , SM1310/PLUS-LC, 40km 808-38200 IE-SFP 1250 Mbps to Gbps OC-24 , SM1310-LC, 20km 808-38201 IE-SFP 1250 Mbps to Gbps OC-24 , MM850-LC, 2250/550m 808-38203 IE-SFP 1250 Mbps to Gbps OC-24 , SM1310/PLUS-LC, 30km Package Checklist Ethernet Switch, Quick Start Guide, DIN-Rail mount bracket installed , Wall mount bracket Warranty Limited lifetime warranty for Advantech B+B designed and/or manufactured products. Corporate Headquarters 707 Dayton Road, PO Box 1040 Ottawa, IL 61350 USA 815-433-5100 Fax 433-5104 European Office Westlink Commercial Park, Oranmore Co. Galway Ireland +353 91 792444 Fax +353 91 792445 |
| More datasheets: 88826125 | 88826145 | 88826105 | 88826014 | 88826135 | 88826004 | EAHP3535GA1 | 2870 | 808-38102 | 808-38200 |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived SEC318-2SFP-T Datasheet file may be downloaded here without warranties.