A8739EEETR-T

A8739EEETR-T Datasheet


A8739 Ultra-Small Mobile Adjustable Xenon Photoflash

Part Datasheet
A8739EEETR-T A8739EEETR-T A8739EEETR-T (pdf)
PDF Datasheet Preview
A8739 Ultra-Small Mobile Adjustable Xenon Photoflash

Capacitor Charger with IGBT Driver

Discontinued Product

This device is no longer in production. The device should not be purchased for new design applications. Samples are no longer available.

Date of status change December 3, 2013

Recommended Substitutions:

For existing customer transition, and for new customers or new applications, contact Allegro Sales.

NOTE For detailed information on purchasing options, contact your local Allegro field applications engineer or sales representative.

A8739

Ultra-Small Mobile Adjustable Xenon Photoflash Capacitor Charger with IGBT Driver

Primary-side output voltage sensing no resistor divider required Adjustable switch peak current limit up to A with
single-wire programming through the CHARGE pin Option to fine-tune target voltage Ultra-small 2 x 2 DFN/MLP-8 package Integrated IGBT driver with internal gate resistors Low quiescent current draw uA max. in shutdown mode 1V logic VHI min compatibility Zero-voltage switching for lower loss >75% efficiency Charge complete indication Integrated 50 V DMOS switch

Package 8-pin DFN/MLP suffix EE
2 mm x 2 mm, mm height Not to scale

The Allegro A8739 is a Xenon photoflash charger IC designed to provide an ultra-small solution with flexibility to adjust both charging current limit and output voltage target. By using primary-side voltage sensing, the need for a secondary-side resistive voltage divider is eliminated. This has the additional benefit of reducing leakage currents on the secondary side of the transformer. Target output voltage is primarily determined by the transformer turns ratio, but it can be further adjusted in steps of V each using an external resistor. This enables better output accuracy, as well as greater flexibility in the selection of transformers.

To extend battery life, the A8739 features very low supply current draw uA max in shutdown mode and 10 uA in standby mode . The switch current limit can be programmed from to A in 16 steps with single wire interface, through the CHARGE pin.

The IGBT driver also has internal gate resistors for minimum external component count. The charge and trigger voltage logic thresholds are set at 1 VHI min to support applications implementing low-voltage control logic.

The A8739 is available in an 8-contact 2 mm x 2 mm DFN/MLP package with a maximum overall package height, and an exposed pad for enhanced thermal performance. It is lead Pb free with 100% matte tin leadframe plating.

VIN_VDRV C2

CHARGE

TRIG

Battery Input to V

RBAT

VBAT VOUT Detect SW

Control Block

ISW sense

COUT 315 V

VPULLUP

DONE
100 kΩ

DONE

VIN_VDRV to V

CHARGE

VIN_VDRV IGBT Driver

IGBT Gate

TRIG

Battery Input to V

RBAT

VBAT VOUT Detect SW

Control Block

ISW sense
More datasheets: 74ACT652SC | 74ACT652SCX | 74ACT652MTCX | NSS3-BK | NSS3-WH | 5851111 | 15006 | 32-01/T4C-4PRB | 74F64PC | 2303


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived A8739EEETR-T Datasheet file may be downloaded here without warranties.

Datasheet ID: A8739EEETR-T 516096