100 PSI-G-DO

100 PSI-G-DO Datasheet


• 5” H O to 100psi Pressure Ranges 2

Part Datasheet
100 PSI-G-DO 100 PSI-G-DO 100 PSI-G-DO (pdf)
Related Parts Information
30 PSI-G-DO 30 PSI-G-DO 30 PSI-G-DO
20 INCH-D-DO 20 INCH-D-DO 20 INCH-D-DO
30 INCH-D-DO 30 INCH-D-DO 30 INCH-D-DO
PDF Datasheet Preview
all sensors
p 4 08 225 431 4 f 4 08 225 207 9 e w ww.allsen sor s.c om

DIGITAL OUTPUT PRESSURE SENSORS

Enhanced Digital Output Sensors
• 5” H O to 100psi Pressure Ranges 2
• All Combined Errors Over Temperature Less Than Typical
• Wide -20 to 85°C Compensated Temperature Range
• Electrically Compatible to All Sensors GA142 Series
• Enhanced Dual Serial Interface Mode
• Medical Instrumentation
• Environmental Controls
• HVAC
• Meteorology

The Digital Output pressure sensors are based upon a proprietary surface mapping technology to produce a fully digital output that virtually eliminates all repeatable errors over temperature and pressure. This series provides a 12 bit digital serial output 14 bit in High Resolution Mode with superior offset, span and linearity characteristics. The output is SPI and compatible as well as fully compatible with the All Sensors GA142 Series sensors.

In addition to synchronous communications, the Digital Output pressure sensors incorporates a bi-directional, TTL level, asynchronous serial interfaces mode hardware selectable 9,600 or 19,200 baud . This mode includes a command set that allows the host to interrogate the sensor for model information, pressure range, serial number, pressure units and conversion factor. The command set also allows the host to select a high resolution output mode, make minor adjustments to offset and has an addressable feature that alows multiple sensors to be tied to the same interface buss.

This series is intended for use with non-corrosive, non-ionic working fluids such as air, dry gases and the like. All signals are 5V TTL/CMOS compatible.

Pin Size x

Typical

Pin 1 2 3 4 5 6

NOTES 1 Dimensions in inches millimeters

Pin Descriptions

Pin Label 1 Vcc

Description +5V power supply input
2 Data/SI

Data output for synchronous mode. Serial in for asynchronous mode.
3 Clock/SO

Clock output for synchronous mode. Serial out for asynchronous mode.
4 Ready/Mode Ready output for synchronous mode. Selects asynchronous
mode when held low during reset.
5 Convert/BR

Convert input for synchronous mode. Selects one of two baud rates for asynchronous
mode low=9,600, high=19,200 .
6 Ground

Ground for power and signals
a 62 96 Sa n Ign acio, Suite E & F, San Jose, CA 95 119
all sensors

Absolute Maximum Ratings

Supply Voltage Vcc Voltage on Any Pin with Respect to Gnd Common-mode pressure Lead Temperature soldering 2-4 sec.

Standard Pressure Ranges

Part Number Operating Pressure
5 INCH-D-DO
-5 to 5
10 INCH-D-DO
-10 to 10
20 INCH-D-DO
-20 to 20
30 INCH-D-DO
More datasheets: AS3711-BQFP-00 | AS3711-BQFP-03 | AS3711-BQFP-FF | AS3711-BQFP | AS3711-BWLT-00 | AS3711-BWLM-00 | AS3711 EVAL BOARD | 80-000540 | FGA40N60UFDTU | 30 PSI-G-DO


Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 100 PSI-G-DO Datasheet file may be downloaded here without warranties.

Datasheet ID: 100 PSI-G-DO 515991