996
996 Datasheet
PRODUCT ID 996
| Part | Datasheet |
|---|---|
996 |
996 (pdf) |
| PDF Datasheet Preview |
|---|
| SENSORS / LIQUID/FLOW Brass Liquid Solenoid Valve - 12V - 1/2 NPS PRODUCT ID 996 Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening, aquarium, or pool project. There are two 1/2" Nominal NPS outlets. Normally, the valve is closed. When 12VDC is applied to the two terminals, the valve opens and water can flow. Unlike the plastic solenoid valve, this one does not have a gasket, so there is no minimum pressure requirement. We tried this solenoid at various DC voltages and found we could actuate it down at 6VDC although it was a little slower to open . Here is the current draw table for various voltages. We suggest a TIP120 or N-Channel power FET with a 1N4001 kickback diode to drive this from a microcontroller pin. For a power supply, our 12V 5A power adapter will do the job. If you want smaller, more basic valve, we also carry a plastic version which does have a minimum pressure requirement but has much lower power requirements! Voltage 6V 7V 8V 9V 10V 11V 12V Current A 3A These solenoids are not rated for food safety by any official standards. However, they are made of cast brass, with a rubber gasket made of NBR Nitrile Rubber so it can be used with any fluid that will not damage or be damaged by the rubber gasket material. 7/24/2015 |
| More datasheets: TIL113W | 18050USA | 20KTH | 6KTH | 10KTH | 40KTH | 30KTH | 3KTH | 60KTH | 50KTH |
Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 996 Datasheet file may be downloaded here without warranties.