412 412 Datasheet

PRODUCT ID 412

Part	Datasheet
412	412 (pdf)

PDF Datasheet Preview
Small push-pull solenoid PRODUCT ID 412 Solenoids are basically electromagnets they are made of a big coil of copper wire with an armature a slug of metal in the middle. When the coil is energized, the slug is pulled into the center of the coil. This makes the solenoid able to pull from one end or push from the other This solenoid in particular is fairly small, with a 30mm long body and a 'captive' armature with a return spring. This means that when activated with up to 24VDC, the solenoid moves and then the voltage is removed it springs back to the original position, which is quite handy. Many lower cost solenoids are only push type or only pull type and may not have a captive armature it'll fall out! or don't have a return spring. This one even has nice mounting tabs, its a great all-purpose solenoid. 1/6/2016 To drive a solenoid you will need a power transistor and a diode, check this diagram for how to wire it to an Arduino or other microcontroller. You will need a fairly good power supply to drive a solenoid, as a lot of current will rush into the solenoid to charge up the electro-magnet, about 100mA, so don't try to power it with a 9V battery! Technical Details 24 DC operation you can use 9-24 DC volts, but lower voltage results in weaker/slower operation Push or pull type with mm throw DC coil resistance 100 ohms 5 Newton starting force 24VDC oz / 39 grams

PDF Datasheet Preview

Small push-pull solenoid

PRODUCT ID 412

Solenoids are basically electromagnets they are made of a big coil of copper wire with an armature a slug of metal in the middle. When the coil is energized, the slug is pulled into the center of the coil. This makes the solenoid able to pull from one end or push from the other

This solenoid in particular is fairly small, with a 30mm long body and a 'captive' armature with a return spring. This means that when activated with up to 24VDC, the solenoid moves and then the voltage is removed it springs back to the original position, which is quite handy. Many lower cost solenoids are only push type or only pull type and may not have a captive armature it'll fall out! or don't have a return spring. This one even has nice mounting tabs, its a great all-purpose solenoid.
1/6/2016

To drive a solenoid you will need a power transistor and a diode, check this diagram for how to wire it to an Arduino or other microcontroller. You will need a fairly good power supply to drive a solenoid, as a lot of current will rush into the solenoid to charge up the electro-magnet, about 100mA, so don't try to power it with a 9V battery!

Technical Details
24 DC operation you can use 9-24 DC volts, but lower voltage results in weaker/slower operation Push or pull type with mm throw DC coil resistance 100 ohms 5 Newton starting force 24VDC oz / 39 grams

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 412 Datasheet file may be downloaded here without warranties.

412

412 Datasheet

Datasheet ID: 412 513592