322 322 Datasheet

PRODUT ID 322

Part	Datasheet
322	322 (pdf)

PDF Datasheet Preview
12mm Diffused Thin Digital RGB LED Pixels Strand of 25 - WS2801 PRODUT ID 322 • RGB Pixels are digitally-controllable lights you can set to any color, or animate. Each RGB LED and controller chip is molded into a 'dot' of silicone. The dots are weatherproof and rugged. There are four flanges molded in so that you can 'push' them into a 12mm drill hole in any material up to 1.5mm/0.06" thick. They're typically used to make outdoor signs. We also have flat-backed pixels that are essentially the same, but are not as long and thin. The pixels are connected by a 4-conductor cable. +5V Red , Ground Blue , Data Yellow and Clock Green . Data is shifted down from one pixel to the next so that you can easily cut the strand or attach more onto the end. Each dot is digitally controlled, with an internal 8-bit PWM LED driver 24-bit color for 16 million different shades . The pixels must be clocked by a microcontroller, we have an example code linked below that works on an Arduino, it should be simple to adapt it to any other microcontroller. Technical Details o 12mm diameter 38mm deep o 80mm / 3" apart on the strand o 25 pieces per strand o New! These pixels use a WS2801 chip for full 24 bit color o 5V power, 60mA maximum per pixel LED on full white o 2-pin SPI-like protocol o WS2801 Datasheet for the chip inside each pixel o Brightness Red = Lumens/300 mcd, Green = 10 Lumens/1000 mcd, Blue = Lumens/300 mcd calculation based on full 120 degree beam Engineered in NYC Adafruit

PDF Datasheet Preview

12mm Diffused Thin Digital RGB LED Pixels Strand of 25 - WS2801

PRODUT ID 322
• RGB Pixels are digitally-controllable lights you can set to any color, or animate. Each RGB LED and controller chip is molded into a 'dot' of silicone. The dots are weatherproof and rugged. There are four flanges molded in so that you can 'push' them into a 12mm drill hole in any material up to 1.5mm/0.06" thick. They're typically used to make outdoor signs. We also have flat-backed pixels that are essentially the same, but are not as long and thin. The pixels are connected by a 4-conductor cable. +5V Red , Ground Blue , Data Yellow and Clock Green . Data is shifted down from one pixel to the next so that you can easily cut the strand or attach more onto the end. Each dot is digitally controlled, with an internal 8-bit PWM LED driver 24-bit color for 16 million different shades . The pixels must be clocked by a microcontroller, we have an example code linked below that works on an Arduino, it should be simple to adapt it to any other microcontroller.

Technical Details
o 12mm diameter 38mm deep o 80mm / 3" apart on the strand o 25 pieces per strand o New! These pixels use a WS2801 chip for full 24 bit color o 5V power, 60mA maximum per pixel LED on full white o 2-pin SPI-like protocol o WS2801 Datasheet for the chip inside each pixel o Brightness Red = Lumens/300 mcd, Green = 10 Lumens/1000 mcd, Blue = Lumens/300
mcd calculation based on full 120 degree beam

Engineered in NYC Adafruit

Notice: we do not provide any warranties that information, datasheets, application notes, circuit diagrams, or software stored on this website are up-to-date or error free. The archived 322 Datasheet file may be downloaded here without warranties.

322

322 Datasheet

Datasheet ID: 322 511527